1. Date of download: 11/15/2017
Copyright © ASME. All rights reserved.
From: Influence of Manufacturing Process and Alloying Element Content on the Tribomechanical Properties of Cobalt-Based Alloys
J. Tribol. 2008;131(1): doi: /
Figure Legend:
Schematic illustration of the cup assembly for the rolling contact fatigue tests

2. Date of download: 11/15/2017
Copyright © ASME. All rights reserved.
From: Influence of Manufacturing Process and Alloying Element Content on the Tribomechanical Properties of Cobalt-Based Alloys
J. Tribol. 2008;131(1): doi: /
Figure Legend:
The average volume loss of cast and HIPed Stellite 6 alloys after dry sand rubber wheel tests

3. Date of download: 11/15/2017
Copyright © ASME. All rights reserved.
From: Influence of Manufacturing Process and Alloying Element Content on the Tribomechanical Properties of Cobalt-Based Alloys
J. Tribol. 2008;131(1): doi: /
Figure Legend:
The wear loss of the cast and HIPed Stellite 6 alloys after the pin-on-disk and ball-on-flat tests

4. Date of download: 11/15/2017
Copyright © ASME. All rights reserved.
From: Influence of Manufacturing Process and Alloying Element Content on the Tribomechanical Properties of Cobalt-Based Alloys
J. Tribol. 2008;131(1): doi: /
Figure Legend:
Stress cycles to failure of cast and HIPed alloys after the rolling contact fatigue tests: (a) Stellite 6 alloys and (b) Stellite 20 alloys

5. Date of download: 11/15/2017
Copyright © ASME. All rights reserved.
From: Influence of Manufacturing Process and Alloying Element Content on the Tribomechanical Properties of Cobalt-Based Alloys
J. Tribol. 2008;131(1): doi: /
Figure Legend:
The failure areas after rolling contact fatigue tests of the (a) cast Stellite 6 alloy, 2.24 GPa, and (b) HIPed Stellite 6 alloy, 2.24 GPa

6. Date of download: 11/15/2017
Copyright © ASME. All rights reserved.
From: Influence of Manufacturing Process and Alloying Element Content on the Tribomechanical Properties of Cobalt-Based Alloys
J. Tribol. 2008;131(1): doi: /
Figure Legend:
Schematic of the Hertzian stress distribution during the RCF test