1. gravi – metric (weighing - measure)
Gravimetric Analysis
gravi – metric (weighing - measure)

2. Gravimetric Analysis Introduction 1.) Gravimetric Analysis:
(i) A technique in which the amount of an analyte in a sample is
determined by converting the analyte to some product
Mass of product can be easily measured
(ii) Analyte: the compound or species to be analyzed in a sample
(iii) Overall, gravimetry sounds simple.
Advantages - when done correctly is highly accurate (most accurate of all time); requires minimal equipment
Disadvantage - requires skilled operator, slow.
Convert analyte into a solid, filter, weigh, calculate via a mole map

3. Gravimetric Analysis- What is It?
Reaction: aA + rR > AaRr ppt where:
a molekul analit A bereaksi dengan r molekul R
AaRr is a pure, insoluble precipitate which we can dry and weigh or ignite to convert to something we can weigh
ppt=precipitate

4. Persyaratan yang harus dipenuhi agar metode gravimetri berhasil
Proses pemisahan hendaknya cukup sempurna sehingga kuantitas analit yang tak terendapkan secara analitis tak dapat terdeteksi.
Zat yang ditimbang hendaknya mempunyai susunan yang pasti dan hendaknya murni atau sangat hampir murni. Bila tidak akan di peroleh hasil yang galat.

5. Gravimetric Analysis Introduction 1.) Gravimetric Analysis:
(iii) Example:
Determination of lead (Pb+2) in water
Pb Cl-  PbCl2(s)
By adding excess Cl- to the sample, essentially all of the Pb+2 will precipitate as PbCl2.
Mass of PbCl2 is then determined.
- used to calculate the amount of Pb+2 in original solution
Analyte
Reagent
Solid Product

6. What Do We Get Out of Gravimetry?
% of analyte, % A
%A = weight of analyte x weight of sample
weight of ppt directly obtained ->? A

7. How Do We Get %A? G.F. = a FW[analyte] b FW[precipitate]
% A = weight of ppt x gravimetric factor (G.F.) x weight of sample
G.F. = a FW[analyte] b FW[precipitate]
G.F. = berapa gram analit dalam 1 gram (ekivalennya dalam 1 g) endapan

8. Gravimetric Factor X apples + Y sugar = Z apple pies
What is this relationship in chemistry?

9. The Gravimetric Factor
G.F. = a FW[analyte] b FW[precipitate]
Analyte ppt G.F. CaO CaCO3 FeS BaSO4 UO2(NO3)2.6H2O U3O8 Cr2O3 Ag2CrO4

10. Gravimetric Factor
Analyte ppt G.F. CaO CaCO3 CaO/CaCO3 FeS BaSO4 FeS/BaSO4 UO2(NO3)2 U3O8 3UO2(NO3)2/U3O8 Cr2O3 Ag2CrO4 Cr2O3/2Ag2CrO4
Naming is critically important (next class)

11. Why AgCl? Reaction is highly selective - no interferents
2AgCl ----> 2Ag + Cl2(g)
AgCl is insoluble in water, i.e., only slightly soluble in water-losses negligible
1.4 mg/L at 200C 22 mg/L at 1000C

12. Why AgCl is a Good Precipitate?
Small mass of analyte yields large mass of precipitate-sensitive technique
AgCl precipitates in curds/lumps that can be easily collected, dried, and weighed
Precipitate (ppt) is not hygroscopic

13. Suatu sampel seberat 0,6025 g dari suatu garam klorida dilarutkan dalam air dan kloridanya diendapkan dengan menambahkan perak nitrat berlebih. Endapan perak klorida disaring, dicuci menghasilkan 0,7134 g. Hitung persentase klorida (Cl) dalam sampel itu!
Suatu sampel bijih besi seberat 0,4852 g, dilarutkan dalam asam, besinya dioksidasi ke keadaan oksidasi +3 dan kemudian diendapkan sebagai oksida berair Fe2O3.xH2O. Endapan disaring, dicucui dan dipanggang menjadi Fe2O3 yang ternyata beratnya 0,2481 g. Hitunglah persentase besi dalam sampel itu?

14. Problem
Consider a g sample containing 75% potassium sulfate (FW ) and 25% MSO4. The sample is dissolved and the sulfate is precipated as BaSO4 (FW ). If the BaSO4 ppt weighs , what is the atomic weight of M2+ in MSO4?
ANS: Mg2+

15. Answer
The hard part is setting up the correct equation (good stoichiometry skills are essential here!):
Rearranging and solving:

16. Problem
A mixture of mercurous chloride (FW ) and mercurous bromide (FW ) weighs 2.00 g. The mixture is quantitatively reduced to mercury metal (At wt ) which weighs 1.50 g. Calculate the % mercurous chloride and mercurous bromide in the original mixture.
ANS: g

17. Answer Again, important to set up correct equation:
Rearranging and solving:

18. Gravimetric Analysis Types of Gravimetric Analysis Combustion Analysis
2.) Precipitation
Combustion Analysis
Common method used to determine the amount of carbon and hydrogen
One modified method (Dumas Method) can also determine the amount of nitrogen in a sample
Technique is accurate and usable with a wide range of compounds.
Often one of the first methods used to characterize a new compound

19. Gravimetric Analysis Combustion Analysis C(sample) + O2 CO2
1.) Principals:
(i) Sample is heated in presence of Oxygen (O2)
Converts carbon in sample to CO2
Converts hydrogen in sample to H2O
C(sample) O CO2
2H(sample) + ½O H2O
Pt, CuO, PbO2, or MnO2 is used as a catalyst in this process
(ii) As CO2 and H2O form, leave the sample and flow through a series of
chambers
Chambers contain chemicals that bind one or both of these products
Example:
- P4O10 can be used to absorb H2O
- Ascarite can be used to absorb CO2
- Ascarite - Sodium Hydroxide Coated Non-Fibrous Silicate D Pt D Pt
Ascarite

20. Gravimetric Analysis Combustion Analysis 2.) Apparatus:
(i) After the sample is completely burned:
Remove P4O10 and Ascarite cartridges and weigh
If C and H are present in sample, both cartridges will increase in mass
(ii) Amount of C and H in the original sample is determined from:
Knowing the amount of sample burned
Change in weight in each cartridge

21. Gravimetric Analysis Combustion Analysis 3.) Example Calculation:
A mixture weighing mg contained only cyclohexane, C6H12 (FM ),
and oxirane, C2H4O (FM ). When the mixture was analyzed by combustion analysis, mg of CO2 (FM ) was produced.
Find the weight percent of oxirane in the mixture.

22. Gravimetric Analysis Precipitation Analysis 1.) Principals:
(i) Reagent + Analyte Solid Product (collect and measure mass)
(ii) Desired Properties of Solid Product
Should be very insoluble
Easily filterable (i.e., large crystals)
Very Pure
Known and constant composition
Hanya sedikit endapan memiliki semua sifat ini, tetapi dalam banyak kasus teknik yang tepat dapat membantu mengoptimalkan kualitas ini

23. Gravimetric Analysis Precipitation Analysis 2.) Solubility:
(i) The solubility of a precipitate can be decreased by:
Decreasing temperature of solution
Using a different solvent
- usually a less polar or organic solvent (like dissolves like)
Solubility vs. pH
Solubility vs. Common Ion Effect
Solubility vs. Temperature

24. Gravimetric Analysis Precipitation Analysis 3.) Gravimetric Analysis:
(i) Governed by equilibrium: AgCl Ksp = 1.8 x 10-10
Solubility of AgCl = [Ag+] + [AgCl] + [AgCl2-]
Cl Ag+  AgCl(ag) ion pair formation
AgCl(aq)  AgCl(s) intrinsic solubility
AgCl +Cl-  AgCl2- complex ion formation

25. Gravimetric Analysis Precipitation Analysis 4.) Filterability:
(i) Want product to be large enough to collect on filter:
Doesn’t clog filter
Doesn’t pass through filter
(ii) Best Case: Pure Crystals
(iii) Worst Case: Colloidal suspension
Difficult to filter due to small size
Tend to stay in solution indefinitely  suspended by Brownian motion
- usually nm in size
Brownian Motion
Apakah kristal atau koloid diperoleh tergantung pada kondisi yang digunakan dalam presipitasi

26. Gravimetric Analysis Precipitation Analysis
5.) Process of Crystal Growth:
(i) Two Phases in Crystal Growth
Nucleation – molekul dalam larutan muncul bersama-sama secara acak dan membentuk agregat (kerikil) kecil
Particle growth – addition of molecules to a nucleus to form a crystal
Crystal Growth

27. Gravimetric Analysis Precipitation Analysis
5.) Process of Crystal Growth:
(ii) Nucleation and Particle growth always compete for molecules/ions
being precipitated.
If nucleation is faster than particle growth:
- a large number of small aggregates occur giving colloidal suspensions
If particle growth is faster than nucleation:
- only a few, large particles form giving pure crystals
Want to
Convert to
Colloidal suspension
Crystal formation

28. Gravimetric Analysis Precipitation Analysis
5.) Process of Crystal Growth:
(iii) Methods for Maximizing Crystal Growth (avoid colloids)
Increase temperature of solution
- increase amount of solute that can be in solution at equilibrium
Add precipitating reagent slowly while vigorously mixing solution
- avoids local high concentrations of solution
Keep volume of solution large
- keep concentration of analyte and precipitating reagent low
Precipitate Ionic compounds in presence of electrolyte (0.1 M HNO3)
- overcome charge repulsion and promotes particle growth
Control solubility of solute through chemical means
- by adjusting pH
- adding complexing agents
- example: precipitation of Ca2+ with C2O42-
C2O H HC2O4-
Ca2+ + C2O CaC2O4(s)
Avoid Colloidal Particle
Note: As pH ([H+]) changes, the solubility of CaC2O4 changes
Ksp

29. Gravimetric Analysis Precipitation Analysis 6.) Crystal Impurities:
(i) Impurities are undesirable (known as co-precipitation)
Change the chemical composition of the precipitate
Creates errors in gravimetric analysis
(iii) Types of Impurities
Adsorption, Occlusion, Inclusion
Impurity placed in crystal instead of analyte
Absorbed or trapped within crystal pockets
Adsorbed to crystal surface

30. Gravimetric Analysis Precipitation Analysis 6.) Crystal Impurities:
(iii) Ways to Minimize Impurities
Maximize crystal growth
- large pure crystals decrease occlusions and adsorbed impurities
Digestion: allowing precipitate to stand in mother liquor (precipitating solution), usually while being heated
- promotes removal of impurities from crystal
- increases size of crystals
Wash precipitate, redissolve in fresh solvent and reprecipitate
- helps decrease all types of impurities
Add a masking agent to solution
- keeps impurities from precipitating, but not analyte
Color  Impurity
Masking agent
Mg CPCH  Solid product
Mn CN-  Mn(CN)64-
precipitant

31. Gravimetric Analysis Precipitation Analysis
7.) Final Preparation of Precipitates:
(vi) Washing Precipitates
Precipitates from ionic compounds
- need electrolyte in wash solution
- keep precipitate from breaking up and redissolving (peptization)
Electrolyte should be volatile
- removed by drying
- HNO3, HCl, NH4, NO3, etc.
Illustration:
- AgCl(s) should not be washed with H2O, instead wash with dilute HNO3
(vii) Drying/Igniting Precipitates
Many precipitates contain varying amounts of H2O
- adsorbed from the air (i.e. hygroscopic)
Precipitates are dried for accurate, stable mass measurements
Precipitates are also ignited to convert to a given chemical form

32. Gravimetric Analysis Calculations in Gravimetric Analysis
8.) Example Calculation
A mixture containing only Al2O3 (FM ) and Fe2O3 (FM ) weighs g. When heated under a stream of H2, Al2O3 is unchanged, but Fe2O3 is converted into metallic Fe plus H2O (g).
If the residue weighs g, what is the weight percent of Fe2O3 in the original mixture?