1. Lighting Rain and twigh light sensor

2. Side ligtht 12V 10W Lighting unit Standard bulb for
Bi-Xenon for dipped beam light and main beam light
Additional a H7 bulb for main beam, on this version only the headlight for additional main beam flash when the flasher unit is activated and the dipped beam is not switched on.
Standard bulb for
parking light 12V 10W
„blue light“ H9
Side ligtht 12V 10W

3. H7 Dipped beam headlight
Basic version
H7 Dipped beam headlight
H9 Main beam headlight

4. remove the outer rear light
bulbs for
Turn signal light 21 W
Parking light 5 W
Brake light 21 W
Reversing light 21 W
For changing bulbs
remove the outer rear light

5. LED technique LED´S for Turn signal light in the mirror
Seperate removable

6. Dipped beam/main beam 12 V DS2 35W
Bulb changing
Don‘t touch the glas with the finger‘s !!
please check dipped beam headlight
Dipped beam/main beam 12 V DS2 35W
Headlight unit complete remove and install
Parking light
12 V 5W
Additional main beam light
12 V H7
Turn signal light
12 V 21W

7. Headlight adjustment
After every repair at headlights with gas discharging lamps self leveling suspension or sensors from self leveling suspension, the system has to be readjusted by using VAS 5051.
Basic setting of the headlight with empty vehicle

8. Position: Light assistent ( Tunnel symbol)
Light switch
NEW:
Position: Light assistent ( Tunnel symbol)
optional

9. Coming home function (Leaving home)
Activated in dash panel insert under Set-up Menu

10. Interior light concept
Footwell illumination
Entry lights
Reading lights front and rear
Interior illumination
Engine and luggage compartment illumination

11. Driving light and automatic driving light control
J 623
J 234
The main function of the driving lights is also set in the onboard power supply CU.
The automatic driving light control is only active when the light switch is in the relevant position.
J 527
J 519
J 518
J 400
J 386/J 387
J 345
J 136/J 521
J 388/J 389
J 393

12. Driver information * Warning lamps Sensors Display instruments
J 285 Dash panel insert
(Gateway)
J 234
J 518
J 345
J 519
J 527
J 217
J 623
J 255
J 393
J 646
J 197
J 518
J 386/J 387
J 647
J 527
J 255
J 388/J 389
J 104 *

13. Roof module - Twigh light/rain sensor
10°
10°
80°
Sensitive surfaces of the rain sensor

14. Roof module – electronically controlled interior rear-view mirror
Front roof module
The use of the Electronic Photo Chrome gel inside the automatic anti-dazzle interior mirror allows it to automatically change the reflection when the light sensor detects an impinging bright light.
By:
Engaging reverse gear
Switching on the interior light
the function is switched off.
Deactivating the electronically controlled function through the button on the bottom on the mirror.
Electronically controlled light sensor

15. Roof module – interior rear-view mirror with memory function
To adjust the stored the interior rear-view mirror position assigned to a memory button, the roof module receives the command from the driver’s side seat control unit via the convenience CAN-bus, This position is adjusted by means of the two positioning motor’s in the mirror housing.

16. System overview Coming home / leaving home
Display and operating unit

17. Guided fault finding Self diagnosis
Address word : driving light control left
39 driving light control right
Guided fault finding
Measured value block
Actuator test

18. Exchanging components
Adaptation (coding)
Function  Components selection
 Body
 Electrical systems
 01 self diagnosis systems
 „Automatically headlight levelling coding“

19. Baisc setting headlights
Address word : 29 Light control left
VAS 5051 function „Basic setting“ (channel 1)
Adjust light mechanical
Exit channel 1 and select channel 2
ignition on/off
Select CU dynamically headlight levelling
(Address word 29 (39)
Function 02
39 Light control right
Same procedure as for left hand side

20. Mechanically adjust light (left)
Vehicle self-diagnosis
Left light control 3D
EVG GDB + AutoHRC(r) X011
Coding 1
Dealership number 1995
08 - Read measured value block
Read measured value block
Meas. value block
Display group 1
Basic setting
Mechanically adjust light (left)
Basic setting
Meas. equip.
Jump
Print
Help

21. 2 Mechanically adjust light (left)
Vehicle self-diagnosis
Left light control 3D
EVG GDB + AutoHRC(r) X011
Coding 1
Dealership number 1995
08 - Read measured value block
Read measured value block
Meas. value block
Display group 2
Basic setting
Mechanically adjust light (left)
Basic headlight setting values are integrated
Basic setting
Meas. equip.
Jump
Print
Help

22. Practice on the vehicle
Light control
Practice on the vehicle
Testing on the vehicle