1. Date of download: 10/14/2017
Copyright © ASME. All rights reserved.
From: A Finite-Element Study of Metal Backing and Tibial Resection Depth in a Composite Tibia Following Total Knee Arthroplasty
J Biomech Eng. 2016;138(4): doi: /
Figure Legend:
Strain gage measurement locations for (top) axial compression validation testing and (bottom) three-point bending validation tests. Strain gage locations were selected to be generally consistent with prior published literature [17–19]. FE boundary conditions were set consistently with biomechanical testing, with FE strain probes located at the strain gage locations within the model for comparison between FE and experimental results.

2. Date of download: 10/14/2017
Copyright © ASME. All rights reserved.
From: A Finite-Element Study of Metal Backing and Tibial Resection Depth in a Composite Tibia Following Total Knee Arthroplasty
J Biomech Eng. 2016;138(4): doi: /
Figure Legend:
Contact area verification in the 05-AP model comparing (left) modeled (right) experimental contact regions as characterized with a high contrast dye transferred from the femoral component onto the tibial tray

3. Date of download: 10/14/2017
Copyright © ASME. All rights reserved.
From: A Finite-Element Study of Metal Backing and Tibial Resection Depth in a Composite Tibia Following Total Knee Arthroplasty
J Biomech Eng. 2016;138(4): doi: /
Figure Legend:
Measurement regions as defined in prior biomechanical photoelastic studies [11,12,22,23]. These regions were utilized for derivation of loading trends in general proximal tibial areas. AMP: anteromedial peripheral, AMC: anteromedial central, ALC: anterolateral central, ALP: anterolateral peripheral, PLP: posterolateral peripheral, PLC: posterolateral central, PMC: posteromedial central, and PMP: posteromedial peripheral.

4. Date of download: 10/14/2017
Copyright © ASME. All rights reserved.
From: A Finite-Element Study of Metal Backing and Tibial Resection Depth in a Composite Tibia Following Total Knee Arthroplasty
J Biomech Eng. 2016;138(4): doi: /
Figure Legend:
Experimental and FE minimum and maximum principal strains (με) measured for thethree-point bending (top) and axial compression (bottom) validation tests at each of the designated strain gage measurement regions

5. Date of download: 10/14/2017
Copyright © ASME. All rights reserved.
From: A Finite-Element Study of Metal Backing and Tibial Resection Depth in a Composite Tibia Following Total Knee Arthroplasty
J Biomech Eng. 2016;138(4): doi: /
Figure Legend:
Least-squares mean maximum shear strains measured at the 24 regions based on 20 measurements under 50:50 (top) and 80:20 (bottom) mediolateral loading distributions. Measurements are divided by measurement regions 0–1 cm, 1–2 cm, and 2–3 cm distal to the tibial plateau.