1. AO Series 10 Illuminator pattern
with cover. Replaces Mirror mount. 3 4 2 2 5 1 1 5
This cover could be wider if you
Have more room.

4. Cardboard mock up of full cover
pattern. Cover could be larger
Than pattern shows- but I drew
‘tight’ so I could get two from
the Wal Mart cookie sheet.
Hand holding a CF ballast, and ballast mounted.
Ballast covers are removed, and the spool flanges
trimmed just bit, to fit.

5. 5 2 1
AO Series 10 Illuminator
Cutting patterns- One piece base, partial cover
Replaces mirror mount in base. 3 4 2 1 5

6. Cardboard mock up w/ cover in place. Note that tail of
cover goes under fold in the back- so offset the bend-over
on the back, to allow clearance. Cover attaches with sheet
metal screw(s) in the back, and in front, the tabs catch the mirror
mount screws.
An example of the earlier pattern cut and bent up. Ballast can be under cover, but some insulated wiring is exposed. Ballast should be used with it’s cover.