1. Specification of FPD-M6
TFT LCD Controller Board
Specification of FPD-M6
(Rev2.1)
RoHS Compliant.

2. CONTENTS
GENERAL DESCRIPTION
2. FEATURES
3. General Specifications
4. Environmental and Reliability Specifications
5. Dimension
6. Major Functional connector Information
7. General Electrical Characteristics:
8. Setup for operation:
Appendix:
- LVDS SIGNAL DECRIPTION

3. GENERAL DESCRIPTION
FPF-M6 controller board is an all-in-one LCD monitor board with analog(RGB),DVI inputs.
FPD-M6 Controller board is analog RGB,DVI interface board for TFT LCD Panel
that is providing cost-effective and high quality screen image.
This controller board supports from VGA to WUXGA panels; resolution at 60Hz
refresh rate with expanding to full screen image on the different type of
TFT LCD; LVDS 1ch or LVDS 2ch and 24bit TTL. It gives a lot of convenience to the
user who wants to user different type of LCD panel with this controller and access the GUI.
2. FEATURES
. State of the art high performance scaling image and one chip solution
. Analog RGB , DVI-D
. Multi-sync capability up to 60
DOS,Expand DOS, VGA,SVGA,XGA,SXGA,WXGA(1366x768),SXGA,SXGA+, UXGA,WUXGA
. LVDS 2ch/1ch , TTL 24bits selected by firmware and panel power options.
. Compatible with VESA DPMS power saving modes.
. Simple operating GUI(OSD) user interface.
3. General Specifications.

4. 4. Environmental and Reliability Specifications
MTBF : more than 50,000 hours at 90% confidence level, excluding LCD panel.
Reliability specification and items : refer to “Specification of reliability test for LCD monitor”

5. 5. Dimension
UNIT:mm

6. Board Picture: Jumper Set: About Dimming set;
You have to choice dimming methods to dc or pwm
1) Dimming – DC : CN10 ; 1-2 jumper
2) Dimming – PWM : CN10 ; 2-3 jumper
About LED voltage set:
If you will have LED panel, you have to set the LED voltage 3.3v or 5.0v or 12V
1) 3.0V led voltage : CN12 ; 1-2 jumper
2) 5V led voltage : CN12 ; 3-4 jumper
3) 12V led voltage : CN12 ; 5-6 jumper
About Panel voltage set:
You have to set the panel voltage 3.3v or 5.0v or 12V
1) 3.0V panel voltage : CN3 ; 1-2 jumper
2) 5V panel voltage : CN3 ; 3-4 jumper
3) 12V panel voltage : CN3 ; 5-6 jumper

7. 6. Major Functional connector Informationn
7. General Electrical Characteristics:
Input Signal Characteristics

8. Output Signal Characteristics:
Power Management : VESA DPMS stanard is applied for power management:
LED INDICATE doesn’t right exactly, It may be changed by customer needs

9. 8. Setup for operation
The OSD(On Screen Display) provides certain functions to have move clear image and others.
This board supports 5 buttons OSD operation as a standard.
The control functions are defined on OSD operation, as follows.

10. Appendix
- The information of TTL port pin-assign.