1. Section 2.1 Review and Preview

2. Copyright © 2010, 2007, 2004 Pearson Education, Inc. All Rights Reserved. 1. Center: A representative or average value that indicates where the middle of the data set is located. 2. Variation: A measure of the amount that the data values vary. 3. Distribution: The nature or shape of the spread of data over the range of values (such as bell-shaped, uniform, or skewed). Preview Important Characteristics of Data 4. Outliers: Sample values that lie very far away from the vast majority of other sample values. 5. Time: Changing characteristics of the data over time.

3. Section 2.2 Frequency Distribution

4. Copyright © 2010, 2007, 2004 Pearson Education, Inc. All Rights Reserved. Key Concept When working with large data sets, it is often helpful to organize and summarize data by constructing a table called a frequency distribution, defined later. Because computer software and calculators can generate frequency distributions, the details of constructing them are not as important as what they tell us about data sets. It helps us understand the nature of the distribution of a data set. Copyright © 2010 Pearson Education

5. Copyright © 2010, 2007, 2004 Pearson Education, Inc. All Rights Reserved.Copyright © 2010 Pearson Education Frequency Distribution (or Frequency Table) shows how a data set is partitioned among all of several categories (or classes) by listing all of the categories along with the number of data values in each of the categories. Definition

6. Pulse Rates of Females and Males Original Data

7. Copyright © 2010, 2007, 2004 Pearson Education, Inc. All Rights Reserved.Copyright © 2010 Pearson Education The frequency for a particular class is the number of original values that fall into that class. Frequency Distribution Pulse Rates of Females

8. Copyright © 2010, 2007, 2004 Pearson Education, Inc. All Rights Reserved.Copyright © 2010 Pearson Education Frequency Distributions Definitions

9. the smallest numbers that can actually belong to different classes Copyright © 2010, 2007, 2004 Pearson Education, Inc. All Rights Reserved.Copyright © 2010 Pearson Education Lower Class Limits Lower Class Limits

10. the largest numbers that can actually belong to different classes Copyright © 2010, 2007, 2004 Pearson Education, Inc. All Rights Reserved.Copyright © 2010 Pearson Education Upper Class Limits Upper Class Limits

11. the numbers used to separate classes, but without the gaps created by class limits Class Boundaries Class Boundaries 59.5 69.5 79.5 89.5 99.5 109.5 119.5 129.5

12. Class Midpoints are the values in the middle of the classes and can be found by adding the lower class limit to the upper class limit and dividing the sum by two. Class Midpoints 64.5 74.5 84.5 94.5 104.5 114.5 124.5

13. Class Width is the difference between two consecutive lower class limits or two consecutive lower class boundaries Class Width 10

14. Example 1: Identify the class width, class midpoints, and class boundaries for the given frequency distribution. Tar (mg) in Nonfiltered Cigarettes Frequency 10 – 131 14 – 170 18 – 2115 22 – 257 26 – 292 Class Width: 4 Class Midpoints: 11.5, 15.5, 19.5, 23.5, 27.5 Class Boundaries: 9.5, 13.5, 17.5, 21.5, 25.5, 29.5

15. 1.Large data sets can be summarized. 2.We can analyze the nature of data. 3.We have a basis for constructing important graphs. Reasons for Constructing Frequency Distributions

16. 3. Starting point: Choose the minimum data value or a convenient value below it as the first lower class limit. 4.Using the first lower class limit and class width, proceed to list the other lower class limits. 5. List the lower class limits in a vertical column and proceed to enter the upper class limits. 6. Take each individual data value and put a tally mark in the appropriate class. Add the tally marks to get the frequency. Constructing A Frequency Distribution 1. Determine the number of classes (should be between 5 and 20). 2. Calculate the class width (round up). class width  (maximum value) – (minimum value) number of classes

17. Pulse Rates of Females and Males Original Data Using the pulse rates of males in the given table, construct a frequency distribution. Use 7 classes. Example 2:

18. Male Pulse Rates Frequency 56 - 61 Class width = 96 – 56 7 62 – 67 68 – 73 74 – 79 80 – 85 86 – 91 92 – 97 13 7 9 2 4 1 Using the pulse rates of males in the given table, construct a frequency distribution. Use 7 classes. Example 2:

19. includes the same class limits as a frequency distribution, but the frequency of a class is replaced with a relative frequencies (a proportion) or a percentage frequency ( a percent) Relative Frequency Distribution relative frequency = class frequency sum of all frequencies percentage frequency class frequency sum of all frequencies  100% =

20. Relative Frequency Distribution * 12/40  100 = 30% Total Frequency = 40 *

21. Example 3: Using the frequency distribution from Example 2, create a relative frequency distribution. Male Pulse Rates Frequency 56 – 6113 62 – 677 68 – 739 74 – 792 80 – 854 86 – 914 92 – 971 Male Pulse Rates Relative Frequency 56 – 61 62 – 67 68 – 73 74 – 79 80 – 85 86 – 91 92 – 97 40 (13/40) 32.5% (7/40) 17.5% 22.5% 5% 10% 2.5%

22. Cumulative Frequency Distribution Cumulative Frequencies includes the sum of the frequencies for that class and all of the classes before it.

23. Frequency Tables

24. Copyright © 2010, 2007, 2004 Pearson Education, Inc. All Rights Reserved. Example 4: Using the frequency distribution from Example 2, create a cumulative frequency distribution. Male Pulse Rates Frequency 56 – 6113 62 – 677 68 – 739 74 – 792 80 – 854 86 – 914 92 – 971 Male Pulse Rates Cumulative Frequency Distribution Less than 62 Less than 68 Less than 74 Less than 80 Less than 86 Less than 92 Less than 98 13 (13 + 7) 20 (13 + 7 + 9)29 31 35 39 40

25. Critical Thinking Interpreting Frequency Distributions In later chapters, there will be frequent reference to data with a normal distribution. One key characteristic of a normal distribution is that it has a “bell” shape.  The frequencies start low, then increase to one or two high frequencies, then decrease to a low frequency.  The distribution is approximately symmetric, with frequencies preceding the maximum being roughly a mirror image of those that follow the maximum.

26. Copyright © 2010, 2007, 2004 Pearson Education, Inc. All Rights Reserved. Example 5: Using a strict interpretation of the relevant criteria on the previous slide, does the frequency distribution given below appear to have a normal distribution? Does the distribution appear to be normal if the criteria are interpreted very loosely? Tar (mg) in Nonfiltered Cigarettes Frequency 10 – 131 14 – 170 18 – 2115 22 – 257 26 – 292

27. Gaps The presence of gaps can show that we have data from two or more different populations. However, the converse is not true, because data from different populations do not necessarily result in gaps. Weight (grams) of Pennies Frequency 2.40 – 2.4918 2.50 – 2.5919 2.60 – 2.690 2.70 – 2.790 2.80 – 2.890 2.90 – 2.992 3.00 – 3.0925 3.10 – 3.198