1. Earth Science 101 Volcanoes and Other Igneous Activity Chapter 8 Instructor : Pete Kozich

2. Volcanic eruptions  Factors that determine the violence of an eruption Composition of the magma Temperature of the magma Dissolved gases in the magma These factors affect the magma viscosity  Viscosity of magma Viscosity is a measure of a material's resistance to flow (related to friction)

3. Volcanic eruptions  Factors affecting viscosity Temperature (hotter magmas are less viscous) Composition (silica content) High silica – high viscosity (e.g., rhyolitic lava) Low silica – more fluid (e.g., basaltic lava) Dissolved gases (volatiles) Mainly water vapor and carbon dioxide Gases expand near the surface Provide the force to extrude lava Violence of an eruption is related to how easily gases escape from magma Easy escape from fluid magma Viscous magma produces a more violent eruption (cool, high silica, more violent)

4. Materials associated with volcanic eruptions  Lava flows Basaltic lavas are more fluid Flow in broad sheets or stream-like ribbons often 10 m/hr Types of lava Pahoehoe (Pah-hoy-hoy) lava resembles braids in ropes Aa (ah-ah) lava rough, jagged blocks with sharp edges and spiny projections  Gases Make up one to five percent of magma by weight Mainly water vapor and carbon dioxide Held in place with high pressure, released when pressure decreases

5. A Pahoehoe lava flow

6. A typical aa flow Figure 9.5 B

7. Materials associated with volcanic eruptions  Pyroclastic materials "Fire fragments" produced by the explosion of superheated gases that rapidly expand upon eruption Types of pyroclastic material Ash and dust – fine, glassy fragments Pumice – from "frothy" lava Lapilli – "walnut" size Cinders – "pea-sized" Particles larger than lapilli Blocks – hardened lava Bombs – ejected as hot lava

8. A volcanic bomb Bomb is approximately 10 cm long Figure 9.6

9. Volcanoes  General features Conduit, or pipe carries gas-rich magma to the surface Vent, the surface opening (connected to the magma chamber via a pipe) Crater Steep-walled depression at the summit Caldera (a summit depression greater than 1 km diameter) Parasitic cones Fumaroles (vents that emit hot gas and vapor only)

10. Volcanoes  Types of volcanoes Shield volcano Broad, slightly domed Primarily made of basaltic (fluid) lava Generally large size, not very violent e.g., Mauna Loa in Hawaii Cinder cone Built from ejected lava fragments (particles harden while in flight) Steep slopes Rather small size (less than 300 m high) Frequently occur in groups

11. Shield volcano Figure 9.8

12. Fig. 8.23, p.195

13. Cinder cone Figure 9.11

14. Fig. 8.24a, p.195

15. Volcanoes  Types of volcanoes Composite cone (or stratovolcano) Nearly symmetrical structure Most are adjacent to the Pacific Ocean (e.g., Mt. Rainier) Large size Interbedded lavas and pyroclastics emitted mainly from a central vent Violent activity Often produce nuée ardente Fiery pyroclastic flow made of hot gases infused with ash Flows down sides of a volcano at speeds up to 200 km (125 miles) per hour May produce a lahar - volcanic mudflow

16. Composite volcano Figure 9.7

17. Mt. St. Helens – a typical composite volcano

18. Mt. St. Helens following the 1980 eruption

19. Fig. 8.25b, p.196

20. Debris Avalanche and Eruption of Mount St. Helens, Washington

21. A size comparison of the three types of volcanoes Figure 9.9

22. Volcano Types

23. A nu é e ardente on Mt. St. Helens Figure 9.14

24. A lahar along the Toutle River near Mt. St. Helens Figure 9.16

25. Other volcanic landforms  Calderas Steep walled depression at the summit Formed by the collapse of the volcano into a partially emptied magma chamber Nearly circular Size exceeds one kilometer in diameter most violent, with silica-rich eruptions  Fissure eruptions and lava plateaus Fluid basaltic lava extruded from crustal fractures called fissures, least violent type of eruptions e.g., Columbia Plateau

26. Crater Lake, Oregon is a good example of a caldera Figure 9.17

27. Formation of Crater Lake

28. Crater Lake in Oregon Figure 9.18

29. Fig. 8.26, p.197

30. Fig. 8.30, p.199

31. Fig. 8.22, p.194

32. The Columbia River basalts Figure 9.19

33. Fig. 8.27a, p.197

34. Table 8.1, p.194

35. Other volcanic landforms  Volcanic pipes and necks Pipes are short conduits that connect a magma chamber to the surface Volcanic necks (e.g., Ship Rock, New Mexico) are resistant vents left standing after erosion has removed the volcanic cone

36. Formation of a volcanic neck

37. Intrusive igneous activity  Most magma remains at great depths and intrudes into existing rocks  An underground igneous body is called a pluton  Plutons are classified according to Shape Tabular (sheetlike) Massive Orientation with respect to the host (surrounding) rock Discordant – cuts across existing structures Concordant – parallel to features such as sedimentary strata

38. Intrusive igneous activity  Types of igneous intrusive features Dike, a tabular, discordant pluton Sill, a tabular, concordant pluton e.g., Palisades Sill, NY Resemble buried lava flows May exhibit columnar joints Laccolith Similar to a sill (concordant, but massive) Lens shaped mass Arches overlying strata upward

39. Intrusive igneous structures exposed by erosion Figure 9.22 B

40. Intrusive Igneous Features

41. A sill in the Salt River Canyon, Arizona Figure 9.23

42. Intrusive igneous activity  Types of igneous intrusive features Batholith Largest intrusive body (massive, discordant) Often occur in groups Surface exposure 100+ square kilometers (smaller bodies are termed stocks) Frequently form the cores of mountains

43. A batholith exposed by erosion Figure 9.22 c

44. Origin of magma  Magma originates when essentially solid rock, located in the crust and upper mantle, melts  Factors that influence the generation of magma from solid rock Role of heat Earth’s natural temperature increases with depth (geothermal gradient) is not sufficient to melt rock at the lower crust and upper mantle Additional heat is generated by Friction in subduction zones Crustal rocks heated during subduction Rising, hot mantle rocks

45. Origin of magma  Factors (continued) Role of pressure Increase in confining pressure causes an increase in melting temperature Drop in confining pressure can cause decompression melting Lowers the melting temperature Occurs when rock ascends Role of volatiles Primarily water Cause rock to melt at a lower temperature Play an important role in subducting ocean plates

46. Origin of magma  Factors (continued) Partial melting Igneous rocks are mixtures of minerals Melting occurs over a range of temperatures for various minerals Produces a magma with a higher silica content than the original rock

47. How Magma Rises

48. Plate tectonics and igneous activity  Global distribution of igneous activity is not random Most volcanoes are located on the margins of the ocean basins (intermediate, andesitic composition) Second group is confined to the deep ocean basins (basaltic lavas) Third group includes those found in the interiors of continents (often, felsic type)

49. Locations of some of Earth ’ s major volcanoes Figure 9.28

50. Plate tectonics and igneous activity  Plate motions provide the mechanism by which mantle rocks melt to form magma Convergent plate boundaries Descending plate partially melts Magma slowly rises upward Rising magma can form Volcanic island arcs in an ocean (Aleutian Islands) Continental volcanic arcs (Andes Mountains)

51. Plate tectonics and igneous activity  Plate motions provide the mechanism by which mantle rocks melt to form magma Divergent plate boundaries The greatest volume of volcanic rock is produced along the oceanic ridge system Lithosphere pulls apart Less pressure on underlying rocks Partial melting occurs Large quantities of fluid basaltic magma are produced

52. Plate tectonics and igneous activity  Plate motions provide the mechanism by which mantle rocks melt to form magma Intraplate igneous activity Activity within a rigid plate Plumes of hot mantle material rise Form localized volcanic regions called hot spots Examples include the Hawaiian Islands and the Columbia River Plateau in the northwestern United States

53. Tectonic Settings and Volcanic Activity

54. End of Chapter 8

55. Chapter 9

56. 9.1 Folds and faults: geologic structures How rocks respond to stress –Stress: force exerted against an object –Factors affecting response Nature of rock –Elastic deformation –Fracture –Plastic deformation Temperature Pressure Time

57. 9.1 Folds and faults: geologic structures Faults – fracture with displacement Slip – the distance of motion Fault zone – numerous, closely spaced fractures Hanging wall – miner’s reference, the side of a fault “overhead” in a mine Footwall – (as above) the fault side underfoot

58. 9.1 Folds and faults: geologic structures Fault types: Normal fault – pulling apart of landscape causes hanging wall to move downward Reverse fault – compression of landscape forces hanging wall up relative to footwall Thrust fault – low angle reverse fault Strike-slip fault – fracture close to vertical, motion horizontal (transform)

59. 9.1 Folds and faults: geologic structures –Joints – fracture without motion Joints decrease with depth Folds, Faults & plate boundaries Convergent – compression (analogous to reverse faults) Divergent – extension, pulling (analogous to normal faults) Transform – strike-slip

60. Fig. 9.10, p.213

61. Fig. 9.12a, p.215

62. Fig. 9.14, p.215