1. WATER MANAGEMENT

2. SEWAGE TREATMENT (DOMESTIC WASTEWATER TREATMENT)
process of removing contaminants from waste water and household sewage, both runoff (effluents) and domestic.
Process of producing an environmentally-safe fluid waste stream (or treated effluent) and a solid waste (or treated sludge) suitable for disposal or reuse (usually as farm fertilizer).

3. SEWAGE TREATMENT INVOLVES THREE STAGES
Primary treatment
Secondary treatment
Tertiary treatment

4. PRE-TREATMENT
Removes materials that can be easily collected from the raw waste water.
The waste may damage or clog the pumps and skimmers of primary treatment clarifiers (trash, tree limbs, leaves, etc.)

5. SCREENING
sewage water is screened to remove all large objects carried in the sewage stream.

6. GRIT REMOVAL
Grit channel or chamber where the velocity of the incoming wastewater is adjusted to allow the settlement of sand, grit, stones, and broken glass.
Grit removal is desirable for larger plants.

7. FAT AND GREASE REMOVAL
Fat and grease is removed by passing the sewage through a small tank where skimmers collect the fat floating on the surface.
Air blowers in the base of the tank may also be used to help recover the fat as a froth.

8. PRIMARY TREATMENT
Sewage flows through large tanks, commonly called "primary clarifiers" or "primary sedimentation tanks."
Grease and oil from the floating material can sometimes be recovered for saponification.
sedimentation tank may remove from 60 to 65 percent of suspended solids, and from 30 to 35 percent of biochemical oxygen demand (BOD) from the sewage.

9. SECONDARY TREATMENT
To substantially degrade the biological content of the sewage which are derived from human waste, food waste, soaps and detergent.
The majority of municipal plants treat the settled sewage liquor using aerobic biological processes.
The bacteria and protozoa consume biodegradable soluble organic contaminants and bind much of the less soluble fractions into flock.

10. include trickling filters and rotating biological contactors.
SECONDARY TREATMENT
Fixed-film or attached growth systems
include trickling filters and rotating biological contactors.
Suspended-growth systems
include activated sludge, where the biomass is mixed with the sewage and can be operated in a smaller space than fixed-film systems that treat the same amount of water.

11. ROUGHING FILTERS
To treat particularly strong or variable organic loads, typically industrial, to allow them to then be treated by conventional secondary treatment processes.
Air is forced through the media using blowers.
The resultant wastewater is usually within the normal range for conventional treatment processes.

12. SURFACE AERATED BASINS
Aerators provide two functions:
They transfer air into the basins required by the biological oxidation reactions.
They provide the mixing required for dispersing the air and for contacting the reactants.
Achieve 80 to 90 percent removal of BOD with retention times of 1 to 10 days.
Surface aerated vessels operate at between 4 °C and 32 °C.

13. FILTER BEDS
Filter beds are used where the settled sewage liquor is spread onto the surface of a bed made up of coke.
Specially fabricated plastic media must have large surface areas to support the biofilms that form.
Biological films of bacteria, protozoa and fungi form on the media’s surfaces and eat or otherwise reduce the organic content.

14. BIOLOGICAL AERATED FILTER
Biofilters combine filtration with biological carbon reduction, nitrification or denitrification.
Includes a reactor filled with a filter media.
The dual purpose of this media is to support highly active biomass that is attached to it and to filter suspended solids.
Carbon reduction and ammonia conversion occurs in aerobic mode while nitrate conversion occurs in anoxic mode.

15. ROTATING BIOLOGICAL CONTACTOR

16. ROTATING BIOLOGICAL CONTACTOR
Robust and capable of withstanding surges in organic load.
The rotating disks support the growth of bacteria and micro-organisms present in the sewage.
Oxygen is obtained from the atmosphere as the disks rotate.
Effluent from the RBC is then passed through final clarifiers where the micro-organisms in suspension settle as a sludge.

17. SECONDARY SEDIMENTATION
The final step in the secondary treatment stage is to settle out the biological floc or filter material through a secondary clarifier.
to produce sewage water containing low levels of organic material and suspended matter.

18. TERTIARY TREATMENT
The purpose of tertiary treatment is to provide a final treatment stage to raise the effluent quality before it is discharged to the receiving environment.
It is also called "effluent polishing."