1. Wood Fasteners

2. What materials need to be joined? Wood, metal and masonry all require different fasteners. What is the thickness of the material to be joined? For a secure connection, the fastener must be the correct length. What weight or strength requirements are there? From framing a house to hanging a picture, there's a fastener for the job. How permanent will the connection be? If the work will be disassembled at some point, use a screw. Will the work be indoors or outdoors? There are specific fasteners for both types of applications.

3. Wood nails are measured, according to length. This is expressed by the letter "d" (called penny). Sizes run from 2d (2- penny/1" long) to 60d. Nails generally are 1" to 6" in length, usually getting thicker as they get longer.

4. Thick, heavy-duty, general-purpose nail. Large, flat head for performing rough work such as construction framing.

5. Short, thin shaped nail with a blunt tip. Used to fasten smaller stock when common nails are too large.

6. Small nail with cupped head for fastening trim when nail heads should not show. Can be countersunk with a nailset, then filled over.

7. Smaller version of the finishing nail up to about 1" long. Used for detail work such as attaching molding or trim.

8. Similar to finishing nail, but thicker and heavier. Used to attach case molding or rough trim where strength and concealment are required.

9. For fastening, screws are stronger than nails. They can be removed with less damage to the material than nails. When using with wood, best practice is to pre-drill a “pilot” hole to guide the screw into position.

10. Slotted Conventional single-groove screwhead. Applied with a flathead screwdriver. Phillips Cross-slotted screwheads with U or V- Shaped slots of uniform width. Driven with a Phillips screwdriver. Torx Require special drivers with six point heads.

11. Head Types Oval Lower portion is countersunk and top is rounded. Easier to remove & better looking than flathead screws. Round Used where the fastened piece is too thin to permit countersinking. Also used on parts that may require a washer. Flat Used in applications where the head needs to be flush with the surface. Slotted and Phillips type are available. Thread Styles Fine-thread Work best for hardwoods. Coarse-thread Intended for soft woods.