© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-1 Configuring Catalyst Switch Operations Identifying Problems That Occur in Redundant Switched.

Slides:

Advertisements

Similar presentations

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—2-1 Extending Switched Networks with Virtual LANs Introducing VLAN Operations.

Advertisements

© 2008 Cisco Systems, Inc. All rights reserved.Cisco ConfidentialPresentation_ID 1 Chapter 2: LAN Redundancy Scaling Networks.

CCNA3 v3 Module 7 v3 CCNA 3 Module 7 JEOPARDY K. Martin.

Part 2: Preventing Loops in the Network

Switching & Operations. Address learning Forward/filter decision Loop avoidance Three Switch Functions.

Growing the Network © 2004 Cisco Systems, Inc. All rights reserved. Maximizing the Benefits of Switching INTRO v3.0—3-1.

© 2006 Cisco Systems, Inc. All rights reserved.Cisco PublicITE I Chapter 6 1 VLANs LAN Switching and Wireless – Chapter 3.

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—3-1 Determining IP Routes Introducing Routing.

© 2002, Cisco Systems, Inc. All rights reserved..

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—3-1 Determining IP Routes Introducing Distance Vector Routing.

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-1 Configuring Catalyst Switch Operations Introducing Spanning Tree Protocol.

LOGO Local Area Network (LAN) Layer 2 Switching and Virtual LANs (VLANs) Local Area Network (LAN) Layer 2 Switching and Virtual LANs (VLANs) Chapter 6.

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1 Interconnecting Cisco Network Devices.

Layer 2 Switch  Layer 2 Switching is hardware based.  Uses the host's Media Access Control (MAC) address.  Uses Application Specific Integrated Circuits.

© 2008 Cisco Systems, Inc. All rights reserved.Cisco ConfidentialPresentation_ID 1 Chapter 2: LAN Redundancy Scaling Networks.

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—3-1 Determining IP Routes Introducing Link-State and Balanced Hybrid Routing.

VLAN Trunking Protocol (VTP) W.lilakiatsakun. VLAN Management Challenge (1) It is not difficult to add new VLAN for a small network.

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-1 Configuring Catalyst Switch Operations Introducing Basic Layer 2 Switching and Bridging Functions.

Introduction to IT and Communications Technology Justin Champion C208 – 3292 Ethernet Switching CE

Network Redundancy Multiple paths may exist between systems. Redundancy is not a requirement of a packet switching network. Redundancy was part of the.

© 2008 Cisco Systems, Inc. All rights reserved.Cisco ConfidentialPresentation_ID 1 Chapter 2: LAN Redundancy Scaling Networks.

1 © 2004, Cisco Systems, Inc. All rights reserved. CCNA 3 v3.1 Module 7 Spanning Tree Protocol.

© 2008 Cisco Systems, Inc. All rights reserved.Cisco ConfidentialPresentation_ID 1 Lecture 12: LAN Redundancy Switched Networks Assistant Professor Pongpisit.

Connecting Networks © 2004 Cisco Systems, Inc. All rights reserved. Exploring How IP Address Protocols Work INTRO v2.0—4-1.

1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 3 v3.0 Module 7 Spanning-Tree Protocol Cisco Networking Academy.

Saeed Darvish Pazoki – MCSE, CCNA Abstracted From: Cisco Press – ICND 2 – Chapter 2 Spanning tree Protocol 1.

Instructor & Todd Lammle

Switches 1RD-CSY  In this lecture, we will learn about  Collision Domain and Microsegmentation  Switches – a layer two device ◦ MAC address.

The Medium Access Control Sublayer Chapter 4. The Channel Allocation Problem Static Channel Allocation Dynamic Channel Allocation  Delay for the divided.

© 2006 Cisco Systems, Inc. All rights reserved.Cisco PublicBSCI Module 6 1 Basic Switch Concept Prepared by: Akhyari Nasir Resources form Internet.

Cisco 3 – Switching STP Perrine. J Page 110/19/2015 Chapter 8 Spanning Tree Protocol (STP) Having redundancy in a network is important, and allows the.

© 2002, Cisco Systems, Inc. All rights reserved..

Switching Basics and Intermediate Routing CCNA 3 Chapter 7.

LOGO Local Area Network (LAN) Layer 2 Switching and Virtual LANs (VLANs) Local Area Network (LAN) Layer 2 Switching and Virtual LANs (VLANs) Chapter 6.

Switches 1RD-CSY  In this lecture, we will learn about  Collision Domain and Microsegmentation  Switches – a layer two device ◦ MAC address.

Configuring Cisco Switches Chapter 13 powered by DJ 1.

1 © 2004, Cisco Systems, Inc. All rights reserved. CCNA 1 v3.1 Module 8 Ethernet Switching Claes Larsen, CCAI.

© 1999, Cisco Systems, Inc. 6-1 Chapter 6 Catalyst Switch Operations.

1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 3 v3.0 Module 7 Spanning Tree Protocol.

Spanning Tree V1.2 Slide 1 of 1 Purpose:

NET 324 D Networks and Communication Department Lec1 : Network Devices.

The University of Bolton School of Games Computing & Creative Technologies LCT2516 Network Architecture CCNA Exploration LAN Switching and Wireless Chapter.

1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 3 v3.0 Module 7 Spanning Tree Protocol.

1 Version 3.0 Module 7 Spanning Tree Protocol. 2 Version 3.0 Redundancy Redundancy in a network is needed in case there is loss of connectivity in one.

© 2006 Cisco Systems, Inc. All rights reserved.Cisco PublicITE I Chapter 6 1 Switching in an Enterprise Network Introducing Routing and Switching in the.

© 2006 Cisco Systems, Inc. All rights reserved.Cisco Public 1 Version 4.0 VLANs LAN Switching and Wireless – Chapter 3.

CO5023 LAN Redundancy.

Copyright 2003 CCNA 3 Chapter 8 Spanning Tree Protocol By Your Name.

Chapter-5 STP. Introduction Examine a redundant design In a hierarchical design, redundancy is achieved at the distribution and core layers through additional.

© 2002, Cisco Systems, Inc. All rights reserved..

Instructor Materials Chapter 3: STP

Chapter 2 Overview of Networking Components

LAN Switching and Wireless – Chapter 3

Spanning Tree Protocol

© 2002, Cisco Systems, Inc. All rights reserved.

Spanning Tree Protocols

Instructor & Todd Lammle

Lecture#10: LAN Redundancy

Configuring Catalyst Switch Operations

Spanning Tree Protocol

One Upon A Time Computer Networks

Spanning Tree Protocol

LAN Switching and Wireless – Chapter 3

NT2640 Unit 9 Activity 1 Handout

© 2002, Cisco Systems, Inc. All rights reserved.

© 2002, Cisco Systems, Inc. All rights reserved.

LAN Switching and Wireless – Chapter 3

LAN Switching and Wireless – Chapter 3

© 2002, Cisco Systems, Inc. All rights reserved.

Presentation transcript:

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-1 Configuring Catalyst Switch Operations Identifying Problems That Occur in Redundant Switched Topologies

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-2 Outline Overview Redundant Switched and Bridged Topologies Broadcast Storms Multiple Frame Transmissions MAC Database Instability Summary

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-3 Redundant topology eliminates single points of failure. Redundant topology causes broadcast storms, multiple frame copies, and MAC address table instability problems. Redundant Topology

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-4 Host X sends a broadcast. Switches continue to propagate broadcast traffic over and over. Broadcast Storms

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-5 Host X sends a unicast frame to router Y. The MAC address of router Y has not been learned by either switch. Router Y will receive two copies of the same frame. Multiple Frame Copies

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-6 Host X sends a unicast frame to router Y. The MAC address of router Y has not been learned by either switch. Switches A and B learn the MAC address of host X on port 0. The frame to router Y is flooded. Switches A and B incorrectly learn the MAC address of host X on port 1. MAC Database Instability

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-7 Summary Bridged and switched networks are commonly designed with redundant links and devices, which can introduce problems such as broadcast storms, multiple frame transmission, and MAC database instability. A broadcast storm is created when each switch on a redundant network floods broadcast frames endlessly. Multiple frame transmissions occur when multiple copies of the same frame arrive at the intended host, potentially causing problems with the receiving protocol. MAC database instability occurs when multiple copies of a frame arrive on different ports of a switch.

© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—1-8