Sec 3 IHE GE 2014/Chan ML.

Slides:



Advertisements
Similar presentations
11.2A Folds, Faults, and Mountains
Advertisements

Mountain Building Chapter 10
Edward J. Tarbuck & Frederick K. Lutgens
Structural Geology Crustal Deformation
Crustal Deformation Earth, 10e - Chapter 10
Deformation of the Crust
Deforming the Earth’s Crust: Faulting Pg. 129 What is a FAULT? When rock layers BREAK when stress is applied One block of rock slides relative to another.
Deformation of Crust Fall 2013.
Chapter 2 Earthquakes 1989 Earthquake- National Geographic.
Deforming the Earth’s Crust
Folding & Faulting Folding  When Earth’s crust bends, folds occur  Folding occurs under compression when forces act towards each other, such as when.
Chapter 7: Plate Tectonics Section 4: Deforming the Earth’s Crust
Plate Tectonics Sec 3 IHE GE 2014/Chan ML
© 2011 Pearson Education, Inc. Earth: An Introduction to Physical Geology, 10e Tarbuck & Lutgens.
Deforming the Earth’s Crust Faults and Folds
Stress, Faulting, Folding, Mountain Building
Earthquake Notes Crustal Deformation.
Folds Rocks are often bent into a series of wave-like undulations called folds Characteristics of folds Folds result from compressional stresses which.
Complete the worksheets
Essentials of Geology, 9e
Structural Geology.
Deforming the Earth’s crust
Deformation Mr Boland Geography.
Lecture Outlines PowerPoint
Do Now for Wednesday, February 20 th ! Use your knowledge of the Law of Superposition to arrange the layers of Earth from oldest to youngest.
Ch. 10 Crustal Deformation
Earth Science, 10e Edward J. Tarbuck & Frederick K. Lutgens.
This is an illustration of the Earth laid out flat and show- ing the major cracks (faults) (in the Earth’s crust. Each section of the Earth’s crust is.
Plate Tectonics.
Name: __________________ Period: _______ Date: ___________.
Plate Tectonic Booklet Convection Currents. Example: Mid-Atlantic Ridge Effects: 1. Creates a submarine mountain range 2. Volcanic activity in the form.
“Deforming the Earth’s Crust”
BELLWORK Name the 3 types of plate boundaries and an example of each.
structural geology & mountain building
Structure An Introduction to Deformation. Standards Describe the composition and structure of Earth’s materials.
Mountain Building Lesson 4.7 How are mountains formed? Lesson 4.7.
Mountain Building An uplifting experience!. How and where? Deformation of crust from stress. –Compression = Rocks are squeezed together Occurs at convergent.
Deforming the Earth’s Crust Chapter 4 Section 4
Deformation of the Crust
Folds, Faults & Geologic Maps
Mountain Building Chapter 11. WHERE MOUNTAINS FORM 11.1.
Deforming the Earth’s Crust
MOUNTAIN BUILDING.
Deforming the Earth’s Crust Faults and Folds
Deforming the Earth’s Crust Faults and Folds
Compressional Forces Geography grade 8 and 9.
Section 1: How Rock Deforms
6.3 Deforming Earth’s Crust
Crustal Deformation Chapter 10.
Unit 4 Lesson 3 Mountain Building
Deforming the Earth’s Crust Faults and Folds
Deforming the Earth’s Crust Chapter 4 Section 4
Deforming Earth's Crust
Objectives Summarize the principle of isostasy.
Folding and Faulting.
Chapter 7: Plate Tectonics Section 4: Deforming the Earth’s Crust
Mountain Building Earth Science Ch. 11.
Deforming the Earth’s Crust
Earth’s Materials and Processes-Part 10 Mountain Building and Faults
Ch.4, Sec.4 - Deforming the Earth’s Crust
Chapter 5, Lesson 1, Interactions at Plate Boundaries
Chapter 5, Lesson 1, Interactions at Plate Boundaries
Chapter 11: Deformation of the Crust
Deforming the Earth’s Crust
Mountains.
Chapter F4 Section 4 Deforming the Earth’s Crust Deformation
Earth's Crust in Motion.
MOUNTAIN BUILDING AND EVOLUTION OF CONTINENTS
Folding & Faulting Folding When Earth’s crust bends, folds occur
Deforming the Earth’s Crust Faults and Folds
Presentation transcript:

Sec 3 IHE GE 2014/Chan ML

Fold is a bend in the rock strata caused by compression

Folds are formed by compression resulting in shortening and thickening of the crust. Parts of a fold: 1) limbs - the two sides of a fold. 2) axial plane - an imaginary surface that divides a fold as symmetrically as possible, with one limb on either side of the plane. 3) fold axis - a line drawn along the points of maximum curvature of each layer. Also defined as the intersection of the axial plane with the beds. In some folds, the axis is completely horizontal. In more complex folding, the fold axis is often inclined at an angle known as the plunge - a plunging fold. Folding http://pirate.shu.edu/~schoenma/mountains.htm

anticline - formed by upfolding, or arching, of rock layers anticline - formed by upfolding, or arching, of rock layers. It is a structure in which the oldest strata are found in the center. 2) syncline - a downfold, or trough, with youngest strata in the center. Symmetrical when the limbs on either side of the axialplane diverge at the same angle and asymmetrical when they do not. Asymmetrical fold is said to be overturned if one limb is tilted beyond the vertical. Some folds are said to be plunging since the axis of the fold penetrates into the ground. Types of fold

Limb http://www.bcminerals.ca/pdf/Geo12-activityHH.pdf

Fold mountains Formation: two plates converge two continental plates or a continental and an oceanic plate. Usually found along continents’ edges When the plates converge, the accumulated layers of rock crumple as sedimentary rocks are forced upwards into a series of folds young fold mountains (10 to 25 million years), (Rockies and Himalayas) Fold mountains old fold mountains (over 200 million years), (Urals and Appalachians)

The French Alps http://www.deskpicture.com/DPs/Places/FrenchAlps.jpg

Folding www.indiana.edu/~g103/G103/week9/wk9.html

Overturned Folding www.indiana.edu/~g103/G103/week9/wk9.html

Faults are fractures in the crust along which displacement has taken place. Faults can occur as single discrete breaks, or as part of a large fault system (the San Andreas fault has displacement of hundreds of kilometers and consist of many interconnecting fault surfaces). These so called fault zones can be several kilometers wide. Sudden movements along faults are the cause of most earthquakes. Faulting

http://facweb.bhc.edu/academics/science/harwoodr/Geol101/study/Images/D041-716.jpg

Formation of Block Mountains by: TENSION COMPRESSION Reverse faults Rock layers are compressed Central block is pushed upwards Overhanging escarpment Normal Faults Rock layers are pulled apart Side blocks are lowered relative to the central block Examples: Sierra Nevada (USA), Flinders Range (Australia), The Tetons (USA) Examples: Death Valley, California (USA), Black Forest (Germany)

Formation of Rift Valleys by: TENSION COMPRESSION Normal Faults Rock layers are pulled apart Central block is lowered Example: Great Rift Valley, East Africa Reverse Faults Rock layers are compressed Side blocks are pushed up Overhanging escarpment Example: Great Glenn Fault, Scotland

Dominant displacement horizontal and parallel to the strike of the fault plane. Rather than a single fracture along which movement takes place, large strike-slip faults consist of a zone of roughly parallel fractures up to several kilometers in width. They DO NOT produce a fault scarp, like the normal and reverse faults Many major strike slip faults cut through the lithosphere and accommodatemotion between two large crustal plates - transform fault. Examples: San Andreas Fault, Anatolian Fault (Turkey) Strike-Slip Faults

http://teachers.sduhsd.k12.ca.us/gstimson/faultmac.gif

New Madrid http://www.showme.net/~fkeller/quake/images/tennesseeguy.wordpressblog.jpg California

Strike Slip fault http://pirate.shu.edu/~schoenma/mountains.htm http://www.geo.arizona.edu/~cparkjr/hebgen/page2.html

Case Study

The Great Rift Valley System (Africa) +9656 km crack (fissure) in the earth's crust, stretching from Lebanon to Mozambique. It divides Kenya into two segments. formed by violent subterranean forces that tore apart the earth's crust. forces caused huge chunks of the crust to sink between parallel fault lines and force up molten rock in volcanic eruptions. this process, called rifting, is still in progress many active and semi-active volcanoes; and hotsprings are along the Rift. The Great Rift Valley System (Africa)

http://www.munoz-group.net/pics/map_africa.jpg http://images.encarta.msn.com/xrefmedia/aencmed/targets/maps/map/000edd0e.gif

2 continental plates moving apart (African Plate: Nubian) and Somalian Subplate Due to the rising convection currents Producing Normal Faults The central block is lowered relative to the adjacent blocks The process is accompanied by earthquakes and volcanic eruptions This process is widening the valley The Somalian plate may be pulled apart from Africa, just like what happened to Madagascar Stages of Formation

Madagascar The continent of Africa is thought to have been split by a series of rift valleys in various states of development. Those in East Africa are still in thick crust. Those in West Africa are associated with thick oil-bearing sediments. In the Red Sea area the rifting has gone so far as to form a narrow ocean. In the south-east Madagascar has been completely separated from Africa by rifting.

http://geology.rutgers.edu/~feigy/LectureNotes/12StructuralGeol.pdf http://www.berghuis.co.nz/abiator/patana/6t/index/humanities/mountains/geofaulting/flash/main.swf Chong, Marianne. Aspects of Physical Geography Waugh, David. Integrated Approach R e f e r e n c e s