HOW MANY SIG FIGS ? 200 3.002.00034.7000 1 sig fig Zeros are place holders 2 sig fig Zeros are place holders 4 sig fig Zeros are between sig figs 4 sig.

Slides:



Advertisements
Similar presentations
Dimensional Analysis Factor Labeling.
Advertisements

Dimensional Analysis.
PO D × basic advance d ÷ Convert Between Measurement Systems Type of MeasureCustomary  Metric Length 1 inch (in.) ≈ 2.54 centimeters.
Measurement in Chemistry Factor-Label Method
Chapter 2 “Scientific Measurement”
Converting Units Using Dimensional Analysis
Applying Significant Figures
Dimensional Analysis In which you will learn about: Conversion factors
Unit 1 Into to Measurement
Dimensional Analysis and Metric Conversions
Warmup (5 min) 1. A 9.01 cm3 sample of gasoline has a density of 0.93 kg/cm3. Calculate the mass. d = m/v, so use m = dv m = (0.93 kg/cm3) (9.01 cm3 )
Chem El Camino College Ch. 1: Measurements Chem El Camino College.
Metric Conversion, Scientific Notation, and Significant Figures.
Chp 2. Unit Conversion  English-English  Metric-metric  Metric-English or English-Metric 1 ft = 12 in 1 yd = 3 ft 1 gal = 4 qt 5280 ft = 1 mi.
ACTIVATOR In your opinion, which would be easier to convert? Explain why. A. Meters to millimeters B. Centimeters to inches C. Inches to feet.
Unit 6: Stoichiometry Section 1: Chemical Calculations.
Rounding If the number to the right of the number you are rounding to is 5 or more, you round up, otherwise you do not => with 4 sig.
Conversions & Scientific Notation
Units Dimensional Analysis The method is in the units Let the units do the walking.
FACTOR – LABEL Method ALWAYS works because of these two principles: A fraction equals ______ when the _______________ and __________________ are equivalent.
m = 1 ___a) mm b) km c) dm g = 1 ___ a) mg b) kg c) dg L = 1 ___a) mL b) cL c) dL m = 1 ___ a) mm b) cm c) dm Learning.
Measurement in Chemistry Factor-Label Method The Factor-Label Method At the conclusion of our time together, you should be able to: 1.Recognize a problem.
Discuss with your neighbor about your lab What did you determine about the relationship between Temperature and Reaction rate? Why did you design your.
1.Write down the number as a fraction. 16 in x= 1.
Complete the following metric conversions using the correct number of significant figures a cm to m   b m to km c cm to mm d
Pick up a half sheet of paper (a chart) and a full sheet of paper (worksheet) from the back table. Voice Level 0-zero, nada, zilch.
HONK You can do it! HONK Right behind you! HONK You go goose! HONK Don’t give up! HONK Good job!
Metric Conversion Practice
CLE.3231.Math.1 Graph relationships and functions between manipulated (independent) variables and responding (dependent) variables.CLE.3231.Math.2 Solve.
Dimensional Analysis.
HONK You can do it! HONK Right behind you! HONK You go goose! HONK Don’t give up! HONK Good job!
5.7 CONVERTING UNITS LO: CONVERT BETWEEN METRIC AND IMPERIAL UNITS OF MEASURE.
Metric to English and Vice-versa. Unit Conversion What if you are given a measurement with certain unit and you need to express that same measurement.
 A technique for solving problems of conversions.
Unit 4: Chemical Calculations. Conversion Factors Problem solutions are given in this format: Problem solutions are given in this format: – A x B x D.
Chemistry Three targets with three arrows each to shoot. Can you hit the bull's-eye? Both accurate and precise Precise but not accurate Neither accurate.
FACTOR – LABEL Method ALWAYS works because of these two principles:
CALCULATIONS: DIMENSIONAL ANALYSIS.  BE AWARE. Please correct your work using a different color. If you do this, then it will tell you what you need.
Do Now Find the number of sig figs in the following numbers 1) 2804 m
Dimensional Analysis.
Metric Conversion Practice
35 m = ______ cm 250 g = ______ kg 650 mm = ______ m 230 m = ______ km
General Chemsitry Dimensional Analysis Method
Add to table of Contents:
FACTOR LABEL HOMEWORK.
Metric Conversion Practice
Conversions with Factor Label
Dimensional Analysis Problems
Daily Science (August 27th)
Metric Conversion Practice
Section 1: Chemical Calculations
Conversion Factors Dimensional Analysis Lots of Practice
10/12/16 Today I will convert measurements within the metric system using factor label. Warm Up – Take a deep breath!
2.6 – NOTES Dimensional Analysis
Convert 3.52 kilograms (kg) to grams (g) using the prefix line.
Metric Conversion Practice
British Surrender at Yorktown (1781)
Metric Conversion Practice
Lewis and Clark Start Out (1803)
Day 61 – Unit Conversions.
Equalities State the same measurement in two different units length
Metric Conversion Practice
DIMENSIONAL ANALYSIS PROBLEMS - REVIEW
Calculations: Dimensional Analysis
Metric Conversion Challenge
Metric Conversion Practice
Metric Conversion Practice
CONVERSIONS.
Dimensional Analysis and scientific notation
Significant Figures and Conversions
Presentation transcript:

HOW MANY SIG FIGS ? sig fig Zeros are place holders 2 sig fig Zeros are place holders 4 sig fig Zeros are between sig figs 4 sig fig Zeros are exact zeros

HOW MANY SIG FIGS ? sig fig Zeros are between sig figs 5 sig fig Last zero is exact and others are in between 4 sig fig Zeros are exact zeros 3 sig fig Bar makes place holders significant

Rounding to Sig Figs 1 sig fig 3 sig fig 5 sig fig 7 sig fig Need the bar to make the place holder significant

1.55 x 10 6 nm = km This is just a metric conversion ---- always 2 steps x 10 6 nm Start with what you’re given: One step to the BASE unit, meters: One step to the desired unit, kilometers: xx nm m 1x km 1x10 3 m 1.55x10 -6 km 3 sig figs

Tg =  g This is just a metric conversion ---- always 2 steps Tg Start with what you’re given: One step to the BASE unit, grams: One step to the desired unit, micrograms: xx Tg g 1x gg 1x10 -6 g 9.3x10 11  g 2 sig figs

8.5 x Ml = ml This is just a metric conversion ---- always 2 steps. 8.5 x Ml Start with what you’re given: One step to the BASE unit, liters: One step to the desired unit, milliliters: xx Ml l 1x ml 1x10 -3 l 8.5x ml Or you could use this for last fraction  1000 ml 1 l 2 sig figs

8 gallons = liters Gallons is an English unit and liters is a metric unit - determine what Metric-English conversion will work (from box at top of homework) 8 gal Start with what you’re given: xx gal qt l 1qt liters 1 sig figs 30 liters

5.75 x s = years 5.75 x10 15 s Start with what you’re given: Keep converting to bigger units of time until you get to years: x x s min hr 60 min 1.82x10 8 yr x x 1 1 daysyr hr days sig figs

500 ml/min = qt/hr This has 2 dimensions. Convert ml to qt and min to hr Start with what you’re given: ml is on top Min on bottom x ml l 1x qt hr 31.9 qt/hr xx 500 ml min.94l 60 min 1 1 sig figs 30 qt/hr

9 in 2 = cm 2 9 in 2 Start with what you’re given: Need 2 factors of inches to cancel inches squared x in cm x cm 1in cm 2 1 sig figs 60 cm 2