Theories of lateral earth pressure will be used in this chapter to design various types of retaining walls. In general, retaining walls can be divided.

Slides:



Advertisements
Similar presentations
MSE Wall Design.
Advertisements

LRFD Design of Shallow Foundations
Design of Cantilevered Retaining Walls
1 Historical Perspective of Soil Mech. & Geotech. Eng The record of the first use of soil as a construction material by man kind is lost in antiquity.
AASHTO LRFD Section 11 Abutments, Piers, and Walls
Mechanically stabilized earth wall in Northwest Greece
4.5 REINFORCED EARTH (terre armee) FILLS CAN BE FORMED PLACING "REINFORCEMENTS" IN THEM AND COMPACTING (GLASS FIBRE REINFORCED, PLASTIC FIBRE, TRYLENE.
Mechanically Stabilized Earth (MSE) Wall Project Geotechnical Design CEG 4801 Fall 2010 Kamal Tawfiq, Ph.D., P.E. Due Date: 9/30/2010.
Reinforced Concrete Design II
BEARING CAPACITY OF SHALLOW FOUNDATIONS of Shallow Foundation
Bearing Capacity of Shallow Foundation
1. By Dr. Attaullah Shah Swedish College of Engineering and Technology Wah Cantt. Reinforced Concrete Design-II Lec-3 Retaining walls.
ERT352 FARM STRUCTURES RETAINING WALL DESIGN
Lateral Earth Pressure and Retaining Walls
RETAINING WALLS.
RETAINING STRUCTURES. Theories of lateral earth pressure will be used in this chapter to design various types of retaining walls. In general,
Lecture 11 Advance Design of RC Structure Retaining walls
REINFORCED EARTH STRUCTURES CONCEPT BASICS OF DESIGN CASE STUDIES.
CM413 Soil Mechanics Course Lecturer: Prof.Dr. Hassan Abd Ellatif Course Assistant: Eng: Shimaa Shaaban.
EXTERNAL STABILITY The MSE wall system consists of three zones. They are: 1. The reinforced earth zone. 2. The backfill zone. 3. The foundation soil zone.
FOFFF.
Details of Construction Lecture-2 “Shallow Foundation”
LIQUEFACTION FAILURE OF FOUNDATION - STRUCTURE COLLAPSE.
Lateral Earth Pressure
AN INTEGRATED DESIGN CONCEPT … … FROM UNDERGROUND UP TO THE TOP ODOTECHNIKI LTD CONSULTING ENGINEERS Address: 59, 3 rd September Str.
An-Najah National University Faculty Of Engineering Civil Engineering Department Al-Najjar Building Footing Design Systems Alternative Prepared by : Mohammed.
SIVA 1 GEOTECHNICAL ENGINEERING - II Course Overview Dr. Nasrullah Abeer ground.
4.4 SOIL NAILING SOIL NAILING IS A REINFORCEMENT METHOD TO REINFORCE THE GROUND WITH STEEL BARS OR STEEL BARS IN GROUT FILLED HOLES. IT IS MAINLY USED.
1 Foundations and retaining walls.
UNIT I RETAINING WALLS.
Session 11 – 12 LATERAL EARTH PRESSURE
RAFT FOUNDATIONS MAT FOUNDATION.
dr. isam jardaneh / foundation engineering / 2010.
SOIL MECHANICS AND FOUNDATION ENGINEERING-II (CE 311)
International Levee Handbook Overview of the handbook Chapter 8 Physical processes and tools for levee assessment and design.
جامعة الكوفة كلية الهندسة / قم الهندسة المدنية / المرحلة الثالثة Retaining Walls إعداد المهندس ليث عبد الرسول الأسدي.
GLE/CEE 330: Soil Mechanics Introduction to Foundation Engineering
Soil mechanics and foundation engineering-III (CE-434)
GLE/CEE 330: Soil Mechanics Earth Retaining Structures
Direct Shear Test.
REINFORCED EARTH STRUCTURES
Prince Mohamed Bin Fahd University College of Engineering Department of Civil Engineering   Senior Design Project (ASSE III) Spring 2014 Management.
The Engineering of Foundations
TOPIC 3: DESIGN AND ANALYSIS OF SHALLOW FOUNDATION
BAA3513 GEOTECHNICAL ENGINEERING Course Information
Principles of Architecture & Construction
Soil Mechanics-II STRESS DISTRIBUTION IN SOILS DUE TO SURFACE LOADS
GEOTECHNICAL ENGINEERING Slope Stability
Civil engineering department Foundation Design of Al – Jasser Building
Design of Rockery Retaining Walls
{Graduation Project} An-Najah National University
GEOTECHNICAL ENGINEERING Lateral Earth Pressure of Soil
Theory of Reinforced Concrete and Lab. II
RETAINING WALL.
BRIDGES MOST IMPORTANT GEOTECHNICAL EFFECT- LIQUEFACTION
STRUCTURAL ENGINEERING Session 04
Chapter 5: Substructure
Civil Engineering Department An-Najah National University
Reinforced earth structures
RETAINING WALL WITH GEOTEXTILE REINFORCEMENT
soil improvement using shredded rubber tires
Geotechnical Design CEG 4801 Spring 2007
DEEP FOUNDATIONS PILES.
Soil Mechanics-II Soil Stabilization and Improvement
American Concrete Pipe Association Short Course
Project Purpose & Description
ANALYSIS AND DESIGN CONSEPT OF GRE PF RETAINING WALL
Civil Engineering Department
Shear Strength of Soil.
Graduation Project Bracing system for deep excavation.
Presentation transcript:

Theories of lateral earth pressure will be used in this chapter to design various types of retaining walls. In general, retaining walls can be divided into two major categories: A- Conventional retaining walls B- Mechanically stabilized earth walls dr. isam jardaneh / foundation engineering / 2010

There are two phases in the design of a conventional wall: First: Geotechnical Design (External Stability) With the lateral earth pressure known, the structure as whole is checked for external stability, which are overturning, sliding, bearing capacity failures and overall Failure. dr. isam jardaneh / foundation engineering / 2010

Sliding

Overturning

Bearing Capacity

Second: Structural Design (Internal Stability) Each component is checked for strength (thickness). The steel reinforcement of each component is determined. dr. isam jardaneh / foundation engineering / 2010

Reinforced Earth

dr. isam jardaneh / foundation engineering / 2010

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2024 SlidePlayer.com Inc. All rights reserved.