Standard Enthalpies Objectives Recall the definition of standard enthalpy changes of reaction, formation, combustion Edexcel AS Chemistry p79.

Slides:



Advertisements
Similar presentations
Molar Quantities: Balancing Equations
Advertisements

1) Which of the following is probably true for a solid solute with a highly endothermic heat of solution when dissolved in water? a. The solid has a low.
Ch. 16: Energy and Chemical Change
Calculation of energy changes  If a body changes its temperature then it changes its energy content  Energy changes can be calculated  Units of energy.
Enthalpy C 6 H 12 O 6 (s) + 6O 2 (g) --> 6CO 2 (g) + 6H 2 O(l) kJ 2C 57 H 110 O O 2 (g) --> 114 CO 2 (g) H 2 O(l) + 75,520 kJ The.
Higher Chemistry Unit 1(b) Enthalpy of combustion.
Ch 100: Fundamentals for Chemistry Ch 9: Calculations from Chemical Reactions Lecture Notes (Sections 9.1 to 9.5)
Heat Transfer and Specific Heat Heat Transfer and Specific Heat Energy Changes in Chemical Reactions Energy Changes in Chemical Reactions Calculating ∆H.
Chapter 15 - Standard enthalpy change of a reaction
Atomic Mass The Mole Molecular Weight Unit 8 – Chemical Quantities 1.
Reaction Energy and Reaction Kinetics Thermochemistry.
Chapter 25 – Energy from Chemical Reactions. Thermochemical Equations Remember: ΔH = H products – H reactants. The heat of reaction, ΔH, is negative when.
1) vocab word--the quantity of heat needed to raise the temperature of 1 g of water 1°C 2) vocab word--the amount of energy required to raise the temperature.
Energy and Chemical Reactions
It has been suggested that hydrogen gas obtained by the decomposition of water might be a substitute for natural gas (principally methane). To compare.
Preview Lesson Starter Objectives Measuring and Comparing the Volumes of Reacting GasesMeasuring and Comparing the Volumes of Reacting Gases Avogadro’s.
Copyright © by Holt, Rinehart and Winston. All rights reserved. ResourcesChapter menu Main AR Standards.
Solving Limiting Reactant Problems. Background In limiting reactant problems, we have the amounts (masses or mols) of two of the reactants. The problem.
Measuring Heat reaction
Thermochemical equations Thermochemical equations  Thermochemical equation = a balanced chemical equation that includes the physical states.
Energy changes. The precise value of an enthalpy change depends on; 1) The number of moles. 2) Temperature 3) Pressure 4) The physical states of reactants.
Combustion Reaction. Heat of Reaction (q) C 6 H 14(l) + O 2 (g)  CO 2 (g) + H 2 O (g) Energy required to break bonds Energy released as bonds form.
Thermochemistry Unit Section Practice Problem #15: a. H 2 O (g) H 2(s) + 1/2O 2(g)  H 2 O (g) KJ b. CaCl 2(s) Ca (s) + Cl 2(g)  CaCl 2(s)
1  H = H final - H initial If H final > H initial then  H is positive Process is ENDOTHERMIC If H final > H initial then  H is positive Process is ENDOTHERMIC.
Standard Heats of Reaction The value of  H for a reaction depends on the temperature and pressure so scientists have agreed upon a set of reference conditions.
Stoichiometry. The study of chemical changes is at the heart of chemistry. Stoichiometry is the area of study that examines the quantities of substances.
Energetics HL and SL An exothermic reaction releases heat energy. An endothermic reaction takes in heat energy. During a chemical reaction bonds in the.
Standard Enthalpies of Formation Learning Goal: You will be able to write formation equations, find the enthalpies of formation and use them & Hess’ Law.
Dr Ku Syahidah Ku Ismail CHAPTER 5 STANDARD THERMODYNAMIC FUNCTIONS OF REACTION.
Chemistry Tutorial 5 Chemical energetics and Thermodynamics Question 3: Leslie Tan Zheng Yu 12S7F.
Copyright © by Holt, Rinehart and Winston. All rights reserved. ResourcesChapter menu Main AR Standards.
Thermal Chemistry. V.B.3 a.Explain the law of conservation of energy in chemical reactions b.Describe the concept of heat and explain the difference between.
Energy Balance on Reactive Processes
CHEMISTRY DEPARTMENT WAID ACADEMY ENTHALPY. The enthalpy of combustion of methanol, CH 3 OH, is -715 kJ mol -1. The mass of methanol which has to be burned.
Thermochemistry Standard Enthalpies of Formation.
enthalpy of formation (DHf): the enthalpy change
Energetics.
Communicating Enthalpy Change. Method 1: Molar Enthalpies of Reaction, Δ r H m To communicate a molar enthalpy, both the substance and the reaction must.
Formation Reactions Examples: C (s) + O 2(g)  CO 2(g) Na (s) + ½ Br 2(l)  NaBr (s) 6C (s) + 6H 2(g) + 3O 2(g)  C 6 H 12 O 6(s)
Standard Enthalpy Changes of Reaction Section 15.1.
Chapter 17 Review “Thermochemistry”. Chapter 17 Review What would likely happen (how would it feel) if you were to touch the flask in which an endothermic.
Industrial Applications of Chemical reactions
Preview Lesson Starter Objectives Measuring and Comparing the Volumes of Reacting GasesMeasuring and Comparing the Volumes of Reacting Gases Avogadro’s.
Enthalpies of Formation and Reaction Definitions: Standard state –A gas at 1 atm –An aqueous solution with a concentration of 1 M at a pressure of 1 atm.
AL Chemistry Summer Project Standard enthalpy changes Group 6 (produced by Chen William and Lam Yu Wing)
3 Enthalpy. Units SI unit = joule 1KJ = 1000J = cal 1st law of Thermodynamics The total energy of the universe is constant i.e energy cannot be.
Basic Chemistry Copyright © 2011 Pearson Education, Inc. 1 Chapter 9 Chemical Quantities in Reactions 9.5 Energy in Chemical Reactions Cold packs use an.
Chemistry Two Key Questions 1. Will a chemical reaction go? 2.
Heat of Formation If you understood Hess’ Law, you will have NO problem here.
ENERGETICS /THERMOCHEMISTRY (AS). 1.Often chemical changes are accompanied by changes in heat content / enthalpy of the materials reacting (H) 2. This.
Heat in Chemical Reactions Ch. 16. Energy in Chemical Reactions Every reaction has an energy change associated with it Energy is stored in bonds between.
CHAPTER ELEVEN COMMUNICATING ENTHALPY CHANGES. Today’s Agenda: Give homework solutions.  Communicating Enthalpy PowerPoint Curricular outcomes: 1.3k:
Standard Enthalpy Changes of Reaction – Define and apply the terms standard state, standard enthalpy change of formation (ΔH f ˚) and standard.
© 2009, Prentice-Hall, Inc. Enthalpies of Formation An enthalpy of formation,  H f, is defined as the enthalpy change for the reaction in which a compound.
Chapter 5 Thermochemistry. Thermodynamics  Study of the changes in energy and transfers of energy that accompany chemical and physical processes.  address.
LO- Understand how enthalpy changes of combustion can be measured using calorimetry. Measuring Enthalpy Changes What can you remember from GCSE? The energy.
Finding and Using Molar Ratios The coefficients in a balanced chemical equation can be used to determine the relative number of molecules, formula units,
Combustion reactions are exothermic. They release energy, and heat up the surroundings.
Describe how a chemical reaction happens
Enthalpy of Formation DHrxn has been tabulated for many different reactions. Often tabulated according to the type of chemical reaction or process DHvap.
Calculating various enthalpy changes
Method 1: Molar Enthalpies of Reaction, ΔrHm
Standard enthalpy changes and Hess’ Law
Standard Heats of Formation
Match the terms to their definitions
Section 3 Gas Volumes and the Ideal Gas Law
Chapter 11 Preview Lesson Starter Objectives
Heat and Enthalpy changes.
Chapter 11 Gas Volumes and the Ideal Gas Law Section 3.
Presentation transcript:

Standard Enthalpies Objectives Recall the definition of standard enthalpy changes of reaction, formation, combustion Edexcel AS Chemistry p79

Standard Enthalpies When we compare enthalpy changes of reactions we use standard conditions, - known temperatures, pressures, masses and concentrations of reactants or products, in order to make it a fair comparison. KEY IDEAS The standard conditions are: A pressure of 1 atmosphere A temperature of 298K (25 o C) Reactants and products in physical states, normal for the above conditions. A concentration of 1.0 mol dm -3 for solutions. The o sign indicates standard conditions

Task You have 10 minutes to produce a 2 minute presentation on one of the standard enthalpies. You should find out it’s symbol Explain what it is Give some examples with word and symbol equations

Standard enthalpy change of reaction ΔH o r The enthalpy change when the reaction occurs in the molar quantities shown in the chemical equation, under standard conditions in their standard states Eg. 2C 3 H 8(g) + 10O 2(g) 8H 2 O (l) + 6CO 2(g)

Standard enthalpy change of formation ΔH o f The enthalpy change when one mole of a compound is formed from its elements under standard conditions; both compound and elements are in standard states. Eg. 2C (s) + 3H 2(g) + ½O 2(g) C 2 H 5 OH (l) Standard Enthalpy Change of Formation

Standard enthalpy change of combustion ΔH o c The enthalpy change when one mole of an element or compound reacts completely with oxygen under standard conditions. Eg. CH 4(g) + 2O 2(g) CO 2(g) + 2H 2 O (l) Combustion Reaction Demonstration

Exam Question Methanol, CH 3 OH (l), when blended with petrol, can be used as a fuel. ΔH o c [CH 3 OH] = -726kJmol -1 a)Write an equation, including state symbols, for the standard enthalpy change of combustion of methanol (2) b) Write an equation, including state symbols. For the standard enthalpy change of formation of methanol (2) c) Liquid petroleum gas is a fuel that contains propane, C 3 H 8. Explain why the following equation does not represent a standard enthalpy change of combustion.(1) 2C 3 H 8(g) + 10O 2(g) 8H 2 O (l) + 6CO 2(g) ΔH r =-4113kJmol -1

Answers a)CH 3 OH (l) + 1½O 2(g) CO 2(g) + 2H 2 O (l) b)C (s) + 2H 2(g) + ½O 2(g) CH 3 OH (l) c) Only one mole of C 3 H 8 should be shown according to the definition of enthalpy of combustion

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2024 SlidePlayer.com Inc. All rights reserved.