BY: FAHEEM MUHAMMAD AUGUST 16,2012 SAVANNAH STATE UNIVERSITY SLAC NATIONAL ACCELERATOR LABORATORY To Develop a Method Using Surveying Techniques & Instruments.

Slides:

Advertisements

Similar presentations

Mobile phone based real time solution to track completed / in progress work The programme officer initiates the work by capturing the site image, GPS.

Advertisements

(GET FAMILIAR WITH EQUIPMENT)

Geospatial Technology

September 13-16, 20055th International PHOTOMOD User Conference, Jurmala, Latvia 1 DEVELOPMENT OF PHOTOGRAMMETRY IN THE STATE LAND SERVICE OF THE REPUBLIC.

2013 Western Australia Surveying Conference

29th December Tel Aviv EGNIS Workshop ISERD the Israel – Europe R&D Directorate.

Internet Ready RTK GPS Network By: Carlos J. Rodríguez, PLS CGSIC Meeting May 23,2006 vernixeng.com.

Session 2 LAND SURVEYING EQUIPMENTS Course: S0663 – Land Surveying Year: 2007.

LCLS LCLS-II Survey & Alignment

Instrument Tests with the new Leica AT401 Georg Gassner September 16 th 2010.

Advisory Board 6 May Advisory Board Objective Class Goals – Big Picture Identify a Professional Organizations Equipment List Lecture/Curriculum.

Land Based Laser Scanning Applications for Transportation Construction Projects Edward Jaselskis, Ph.D., P.E. Iowa State University.

ECE 2011 An Overview of Electrical Engineering Systems Classifications –Communications –Computers –Control –Power –Signal-Processing.

Antenna Baseline Measurement System 29 January 2010 Mark Phillips, Research Assistant Ohio University, Athens OH Research Intern Naval Research Laboratory.

October 20-21, 2005 Internal LCLS Undulator Alignment and Motion Review Catherine LeCocq, SLAC 1 Undulator Alignment Concept &

Fast Fourier Transformation of Vibration Signals using Microsoft EXCEL Mohammed Aref Department of Information Technology Salalah.

The computer-based practical stereo measurements training course in the aerospace education for the students of geographical specialities Yu.F.Knizhnikov,

Setup “Do’s & Don’ts Presented By:

Surveying for Engineering Planning Zoltán Siki

SCC & Leica  Import total station survey, GPS, traverse, levelling and GIS data direct from all Leica instruments.  In built Grid Inquest for GPS reduction.

Methods: spatial polar method photogrammetry laser scanning

TRYPHINE DUDZAYI.  Surveying instrumentation has undergone a major transformation over the past years transit to the modern instruments.  The theodolite,

Welcome to Geoinformatics! Produced by Department of Geomatic Engineering, UCL.

Mapping. Required readings: 18-1 to &18-12&18- 14, and Required figures: 18-2, 18-5, 18-6, 18-7, 18-8, 18-10, and

GPS Survey Equipment GPS Trimble R6 or R8 Legs+Bipod Controller* Base Station or VRS Competencies #1-5.

Surveying I. Lecture 13. Tacheometry.

Harry Williams, Cartography1 Total Station Surveying & GIS. INTRODUCTION TO GIS A Geographic Information System is a combination of software and hardware.

Dong Guangyan, BS, Senior Engineer Outline  1. Summary  2. Basic principle & typical specifications  3. Comparison with traditional surveying.

Planning for airborne LIDAR survey Dr.Lamyaa Gamal El-deen.

© Copyright 2005 Synthosys Synthosys 1 Federal Street L3 Ops Communications Bldg - ACIN Camden, NJ Contact: Linda Yu, President CEO (610)

Modeling And Visualization Of Aboriginal Rock Art in The Baiame Cave

NYSDOT CORS Past, Present and Future

Hong Kong Satellite Positioning Reference Station Network (SatRef) Presented by : Ben LI, LS/G(HK&Is.)

S D Laser Scanning of Acropolis of ATHENS. 3D scanning of the Wall and the Rock of Acropolis Athens and 3D model creation.

Seventh Edition By David A. Madsen, Terence M. Shumaker, and David P. Madsen Civil Drafting Technology Chapter 6 Surveying Fundamentals.

Chris Pair Senior Software Developer Bentley OnSite Overview & Update.

Sensor Positioning in Wireless Ad-hoc Sensor Networks Using Multidimensional Scaling Xiang Ji and Hongyuan Zha Dept. of Computer Science and Engineering,

 Promoting Physical Activity and Nutrition Awareness in Middle School Youth Through the Design of Activities Using Geospatial Technologies By Chelsea.

MMS/MLS – Mobile Mapping and Mobile Laser Scanning System 4th ISPRS SC and WG VI/5 Summer School, Warsaw 2009.

MODERN SURVEY (FAMILARISATION WITH EQUIPMENTS). Modern equipments EDM – Electronic distance measurement eqp. EDM – Electronic distance measurement eqp.

By Shubham GOEL ECE-III year xyz. Introduction Automatic Vehicle Locator (AVL) is a computer – based vehicle tracking system The actual real –time position.

GIS 1 GIS Lecture 6 Digitizing. GIS 2 Outline Digitizing Overview Digitizing Sources GIS Features Creating and Editing Shapefiles in ArcView Spatial Adjustments.

Trimble Solution for Cadastral Surveying

InCORS INDIANA’S STATEWIDE GNSS-GPS REAL TIME NETWORK Presented by Derek Fuller, PLS Land & Aerial Survey Office.

MESA COUNTY’S RTVRN 23 STATIONS/15 NGS CORS. Rover/User Components of VRS GNSS RECEIVER DATA PHONE W/ BLUETOOTH SURVEY CONTROLLER.

Coal Pile Volume Calculation featuring the FARO Photon 120 3d laser scanner.

SVY 207: Lecture 13 Ambiguity Resolution

 PREPARED BY: 1.Sindha.Rinku.R 2.Trivedi.Hasti 3.Kamdar.Karan  GUIDANCE BY : ASHISH RATHOD (ASST.PROF.) Modern tools of Surveying & Mapping.

Introduction Mapping is the foundation of the geological sciences. Three basic elements in geologic map –Location –Lithologic information –Spatial or.

Comparison of Inertial Profiler Measurements with Leveling and 3D Laser Scanning Abby Chin and Michael J. Olsen Oregon State University Road Profile Users.

Introduction to Soft Copy Photogrammetry

Validation of a high-resolution (400m) SAR motion tracking system near the APLIS’07 Ice Camp M. Thomas, C. A. Geiger and C. Kambhamettu.

Technique and precision At all sites a fixed points for global reference were established; a bolt was drilled into the bedrock and its position measured.

LiDAR (Light Detection And Ranging) is a technology that can be used as a topographic survey for many projects, including wetland creation. Flying LiDAR.

Calibration of the Nikon D200 for Close-Range Photogrammetry

1 SVY 207: Lecture 12 Modes of GPS Positioning Aim of this lecture: –To review and compare methods of static positioning, and introduce methods for kinematic.

HAII-ICGC :GNSS Project 2015/03/05. 2 To establish 1 IGS-nominated GNSS reference station with time control at NIMT with data center to synchronize data.

Mapping Technology and Topographic Maps Chapter 1, Lesson 3 and 4.

Innovation for better mobility 1 F INAL R EPORT E LECTRONIC Total Station-GNSS Technology A CCIDENT R ECONSTRUCTION T ECHNOLOGIES AND B EST P RACTICES.

BHP CAPABILITIES PRESENTATION LASER SCANNING AND 3D MODELING.

European Geosciences Union General Assembly 2016 Comparison Of High Resolution Terrestrial Laser Scanning And Terrestrial Photogrammetry For Modeling Applications.

How a topographical map is made.

Characterizing Optics with White-Light Interferometry

Raad A. Kattan(1). , Abdurrahman Farsat Heeto. (2) , Hussein H

“Riegl” 3D laser scaner Egidijus Žilinskas.

Analytical Solutions for Temperature

Status Report on the Alignment Activities at SLAC

Science of Crime Scenes

Total Station Surveying & GIS.

Presentation transcript:

BY: FAHEEM MUHAMMAD AUGUST 16,2012 SAVANNAH STATE UNIVERSITY SLAC NATIONAL ACCELERATOR LABORATORY To Develop a Method Using Surveying Techniques & Instruments to Create 3D Terrain Models

Outline Purpose Instruments  Usage Method Results Conclusion Acknowledgements

Purpose To Develop a Method Using Surveying Instruments To Create a 3D Topographical Map of Small Project Area

Instruments  Zoller and Froehlich (Z+F) Imager 5006i 3D Laser Scanner  Leica GPS (RTK) Rover  Cyra Targets  Z&F Laser Control Software  Bentley MicroStation V8i Software  LFM Server & Modeller Software  Matlab, Surfer and ArcMap Software

The Leica GPS (RTK) Rover RTK- Real Time Kinematics Land Surveying Instrument Leica GPS Uses Satellite Signals & Base Station Radio Signals To Determine (XYZ) Coordinate Points

Zoller + Froehlich(Z+F) 3D Laser Scanner Performs 3D Pixilated High Resolution Scans Of Project Area At A Fast Pace Setup  Solve 6 Unknown To Determine Location Of Scanner  Measure Points For Scanner & Targets Setup

Scanner & Target Locations Scan PositionEasting (m)Northing (m)Height (m) FM FM FM FM FM FM FM FM FM FM FM FM FM FM FM

Cyra Targets Targets represent previously measured points Targets Are Used For The Registration Process Target Pattern is Automatically recognized by software

Software Z&F Laser Control Software Bentley MicroStation V8i software LFM Modeller & Server software Matlab, Surfer and Arc Map software Scan Registration CAD Modeling Scan Processing Generate Contour Lines

Before Registration After Registration Registered Scans

Method First Use Leica GPS RTK to determine the (X,Y,Z) coordinate points for the Z&F 3D Laser Scanner & Target Locations. Setup Z&F 3D Laser Scanner & Target At Points & Perform Scans Around Selected Project Area. Using Computer Software Register Scans, Create 3D Model, & Contour Lines For Topographic Map

Results 3D Scan Over View Entire Site All 15 Scans Registered Into One View Low Resolution 3D Pixilated Scan Photo Contour Lines Can Be Generated

Conclusion Initial Scope-To Develop A Method Using Surveying Techniques & Instruments To Create A 3D Topographic Map of Small Project Area Results-Develop A Method That Created A 3D Scan Overview of the Project Area That Can Be Used As A 3D Topographic Map

Acknowledgements Thanks Department Of Energy SLAC National Accelerator Laboratory SULI Director Stephen Rock Mentors- Catherine LeCocq & Georg Gassner Thanks- Michael Gaydosh & Hans Imfeld For Teaching Me How To Use The Instruments & Software Thank SULI Participants

Photos From Scan

References maps.com/assets/National_Geographic/sample_3d views_new.jpg bin/GetTRDoc?AD=ADA471752