Alternative Power Source for Dental Hygiene Device Nizar Almansouri Ningbiao Jiang Francisco Heath Jin Niu Jiaqi Xie Team Concussion

Contents of Presentation 1 1. Problem Statement 2. Component Overview 3. Testing Procedure 4. Objectives and Constraints 5. Gantt Chart 6. Conclusion 7. References

2 Problem Statement NAU Department of Dental Hygiene  Humanitarian work in remote areas  No electricity available to power Wig-L-Bug  Our goal is to build them a working power supply

Components DimensionsWeightCost Battery8×5×3in4lb$ Charger6×3×2in1lb$36.95 Inverter6×3×2in1lb$85.00 Total6lb$

Battery Capacity240Wh Nominal Voltage16.8V Regulated Voltage12V Max Discharge Rate10A Dimensions8 x 5 x 3in Weight4lb Grams equivalent lithium~ 20g Cost$

Charger Input Voltage V Output Voltage16.8V Fully Charge Time9h Dimension 6×3×2in Weight1lb Cost $

Inverter SpecificationPure sine wave inverter Input Voltage12V DC Output WaveformPure Sine Wave Output Voltage120V AC at 60Hz Power Output180W Maximum Efficiency90% THD<3% Size 6×3×2in Weight1lb Cost$85 6

System Test  Wig-L-Bug Test 7 IdleLowestLowMediumMax Nominal Power0W38W42W46W48W Continuous Power1W35W39W41W45W Maximum Power1W38W42W48W50W

System Test  Bulb Test Discharge the system with a bulb of 60W power and it takes 3 hours 56 minutes to drain the battery.  Battery Charging Rate Test After the battery is fully discharged, it takes 8 hours 50 minutes to charge the battery. 8

System Test Output Test The output of the system is 113V at 60Hz. When Wig-L-Bug is plugged in it works well with the output from the power source. 9

Constraints  Must have a stable AC voltage output of Hz √  Maximum output of 1.2 Amps √  Must be able to power device continuously for 10 hours ×  Must be able to operate device for 10 hours √  Cannot weigh more than 27 lb√  Must be able to fit in 22 ×18 ×10 in container √  Must be able to charge on Hz √  Must be able to charge % in eight hours √ 10

Work that needs to be done 11 1.Safety a.Make sure the device cannot be hooked up improperly b.Provide instruction sheet with warnings c.Label all components and connections 2.Packaging a.Case must contain all components b.Case must provide adequate protection 3.Further testing a.Repeat discharge/charge test

Gantt Chart 12 We still have one week to finish testing and make everything look good

Conclusion  Specifications of the components  System Test  Constrains  Work that needs to be done 13 ComponentsWeightCost Battery4lb$ Charger1lb$36.95 Inverter1lb$85.00 Total6lb$444.90

References     14