ELECTRONICS Frost Alarm Frost Alarm. ELECTRONICS When the thermistor temp is high the resistance is low and the transistor is off.

Slides:

Advertisements

Similar presentations

David Smith1 S.G. Electronics Revision Lesson. David Smith2 Introduction Electronic systems have 3 parts Input Process Output There are 2 types of systems:

Advertisements

AP Electricity Quiz Review

Basic Circuits TEST YOUR BRAIN!.

Current-Voltage Characteristics of a bulb In this experiment you are going to investigate how the current through a bulb changes according to the.

P2.3.1 – Static Electricity. Objectives, to understand that: –When certain electrical insulators are rubbed together they become electrically charged.

Chapter 4 AC to AC Converters

TRANSISTORS Past Paper Questions and Answers EP01– Q11(b) The circuit below is a monostable timing circuit, When activated component C turns on.

The All IC’s are usually set up in a DIL (Dual In Line) configuration, this is where there are two sets of parallel connections (the pins). As you can.

Input Devices Microphone Symbol: Energy Change:soundelectrical Solar Cell Symbol: Energy Change:lightelectrical.

Electronics Digital Processes Transistor as a Switch 1)(G) State that a transistor can be used as a switch. 2)(G) State that a transistor may be conducting.

Physics and Electronics. Electronic systems Electronic systems are made up of 3 parts: 1)An INPUT SENSOR – these detect changes in the environment Examples:

Electronic Component Functions What is this component doing my in electronic device?

Operational Amplifiers

Module 2 Bipolar Junction Transistor. Learning Outcomes 1.The 3 terminals or regions of a BJT. 2.Construction and symbol of NPN and PNP types 3.Low power.

Physics in Action W Richards Worthing High School.

gradually rises from 0 to 9V immediately drops from 9V to 0V

The Transistor A transistor is an automatic switch. It can only be on or off. base emitter collector 0.7 V When the transistor is on, current flows from.

1 Electronics 4.4: Digital Processes Transistors and Digital Electronics Electronics 4.4: Digital Processes.

1 D & T Design Lesson Sec 3B By: MdmLee Kah Gek Technological Areas - Electronics MacPherson Secondary School.

Rd 3 - Electronics 1.Ohm’s Law 2.Potential Divider 3.Resistor in Series and Parallel - Application of Ohm’s Law 4. Operational Amplifier (Comparator and.

Twenty Questions Electronics. Twenty Questions

Circuits and Electronics. Circuits A circuit is a closed path through which a continuous charge can flow. A circuit is a closed path through which a continuous.

1 Electronics 4.4: Digital Processes PageTitle 1)Contents Page 2)Header Page 3)Learning Outcomes 4)Introducing Transistors 5)Transistor Terminals 6)Transistor.

Your Hospital What are sensing circuits ?

Beath High School - Int 1 Physics1 Intermediate 1 Physics Electronics Input, Process and Output Digital Logic Gates.

RESISTORS Always remember…… V = IR (V= voltage in volts; I = current in amps; R = resistance in ohms)

The energy change in a thermocouple is : 1.E E to E H 2.E S to E E 3.E L to E E 4.E H to E E :20.

Unit 6 in four lessons Resistors.

describes the relationship between current, voltage, and resistance greater the voltage across a device with resistance, the greater the current through.

Beath High School - Int 1 Physics1 Intermediate 1 Physics Electronics Glossary AND gate to device digital signals to inverter LDR to logic circuit logic.

Electricity revision. What is the question? Here are some answers what might the question be? Bistable latch thermistor NOT gate Diode-bridge direct current.

© Oxford University Press 2011 IP Images Images.

Twenty Questions Electronics. Twenty Questions

Electronic. Analog Vs. Digital Analog –Continuous –Can take on any values in a given range –Very susceptible to noise Digital –Discrete –Can only take.

1 Electrical Fundamentals We need some understanding of electrical fundamentals to do the lab exercises. Electric Circuit Consists of: –Power Source: Battery,

18240 Element two - Components INPUTS OUTPUTS PURPOSE TYPICAL USE.

7. Direct Current circuits. 11 Find the currents, which flow in all the wires of the circuit in this figure 12  9 V 6 V b a cd 18 

ELECTRONICS – Input Transducers Engineering Science – National 5.

Show-me board revision quiz 1.Draw the symbol for an LED 2.What happens to the resistance of a thermistor as it is heated up? 3.What happens to the resistance.

Cathode Ray Oscilloscope (CRO)

6.2 ELECTRONICS. CAPACITOR An electrical device used to store electrical charge.

 A transistor is the basic building block of electronic components.  The average computer may have millions of them within its circuits.  Essentially,

Electronics revision Electronics Revision Part 1.

Analogue Electronics Higher Physics Unit 2 Electricity And Electronics Monitoring & Control Circuits.

Regions of a Transistor A Bipolar Junction Transistor is a three terminal device containing 3 regions: Emitter, Base and Collector.

Starter: use Pg to complete the table

BASICS OF ELECTRONICS.

Connect 4 Change the terms in the following template to customize Connect 4 for any topic. You will need to copy one copy of one of the two templates.

Electricity – what’s it about?

LOCKERBIE ACADEMY PHYSICS DEPT

Electronic Components

Potential Divider Aims What is a potential divider

LDRs and Thermistors.

Ohmic Resistor Current-Potential Difference Graph

Twenty Questions Electronics.

Electronics – Learning Outcomes

Transistor & Voltage Divider

Components and Schematics

The resistance of a thermistor changes from 30k to 12k when the temperature changes from 20C to 70 C Calculate the sensitivity if resistance is taken.

Electric Circuits.

סימנים מוסכמים בחשמל ואלקטרוניקה

Designing Electric Circuits

ELECTRONIC SYSTEMS Note: There is no compulsory question set on Section 25 of the syllabus. Questions set on topics within Section 25 are always set as.

LOCKERBIE ACADEMY PHYSICS DEPT

Electric Circuits Ch 17, section 4.

Describe the action of thermistors and light- dependent resistors and show understanding of their use as input transducers Thermistor A transducer is an.

Passive Transducers Elliott.

Presentation transcript:

ELECTRONICS Frost Alarm Frost Alarm

ELECTRONICS When the thermistor temp is high the resistance is low and the transistor is off.

ELECTRONICS Frost Alarm Frost Alarm

ELECTRONICS When the thermistor temp is low, the resistance is high and the transistor switches on.

ELECTRONICS Fire Alarm Fire Alarm

ELECTRONICS When the temp is hot the thermistor resistance is low so it takes little voltage and so the resistor takes most of the voltage and so the transistor switches on.

ELECTRONICS Fire Alarm Fire Alarm

ELECTRONICS When the temp is cold the thermistor takes most voltage and so the resistor takes little and the transistor is off.

ELECTRONICS Burglar Alarm Burglar Alarm

ELECTRONICS When the L.D.R. is in the light,the resistance is low so the voltage is low and the transistor is off

ELECTRONICS Burglar Alarm Burglar Alarm

ELECTRONICS When the L.D.R. is in the dark its resistance is high and the transistor switches on.

ELECTRONICS Time Delay Circuit Time Delay Circuit

ELECTRONICS When the capacitor charges up to a certain voltage after a certain time, the transistor switches on.

ELECTRONICS

ELECTRONICS There are 3 process devices, The NOT gate The AND gate The OR gate