CE 453 Lecture 7 Noise Analysis See: and

Slides:



Advertisements
Similar presentations
Basics of Acoustics Mn/DOT MPCA FHWA Presenters:
Advertisements

Noise Pollution Noise classification. Transport noise Occupational Noise Neighbourhood Noise.
Sound Chapter 16.
Paul M. Kohler Noise Abatement Program Manager INTERSTATE 95 EXPRESS LANES FUNDAMENTALS OF TRAFFIC NOISE.
Chapter 12 SOUND.
Phys 250 Ch15 p1 Chapter 15: Waves and Sound Example: pulse on a string speed of pulse = wave speed = v depends upon tension T and inertia (mass per length.
BASIC CONCEPTS IN ARCHITECTURAL ACOUSTICS ENVIRONMENTAL CONTROL III
The Doppler Effect A source emits a sound of constant frequency. If the apparent frequency of the source is increased which of the following is true? A.
By Aimee Chavez. Wave: a disturbance that transfers energy from place to place. The material through which a wave travels through is called a medium.
What is a sound wave? Mechanical wave – longitudinal *A vibration *Particles of medium are disturbed *Causes a wave causes Most common medium is air Can.
Chapter 2 (supplement): Capacity and Level-of-Service Analysis for Freeways and Multilane Highways Objectives of this presentation: By the end of this.
Capacity Analysis CE 453 Lecture #14.
Pengukuran Noise Ahmad Suudi, S.T., M.T.. 2 Noise Measurement Significant variability in noises from transportation sources L p : noise level at a particular.
Chapter 14 – Noise Pollution and Control Hwk#7 review questions – pp #6,8,15,19 practice prob. – p.474 -#2,7,9,15 Noise – is an undesirable and.
Introduction to Noise Control
Phy 202: General Physics II Ch 16: Waves & Sound Lecture Notes.
…A MOVEMENT OF ENERGY What are waves? A wave is a movement of energy from a vibrating source outward  A vibration – any movement that follows the same.
Phy 212: General Physics II
NOISE MEASUREMENT & ABATEMENT J (Hans) van Leeuwen CE/AE/EnSci 524.
Basic Concepts: Physics 1/25/00. Sound Sound= physical energy transmitted through the air Acoustics: Study of the physics of sound Psychoacoustics: Psychological.
Waves and Sound Feel the Beat…..
18 – 2 The Nature of Sound.
Implementing Noise Compatible Land Use  Federal Highway Administration  Lesson 1 Roadway Noise and FHWA Guidelines.
Chapter 10: Sound Section 1: The Nature of Sound
Noise Pollution. Noise pollution Noise = sound which is unwanted by the recipient Sound is produced by vibrations passing through air, liquids or solids.
Environmental Technology Excessive Noise Noise Generators.
NOISE IN RADIO WAVES Mr. Husnain Lecture 3.
Environmental Impacts Socio-Economic Environment Land Use Transportation System Design & Construction of Facilities Operations & Maintenance Activities.
Noise Pollution and Control
 1) Determine the wave speed of a wave that has a period of 3 minutes and a wavelength of 0.05 m.  2) How are electromagnetic and mechanical waves different?
Waves interact and transfer energy in predictable ways.
Traffic Flow Fundamentals
Sound. Sound Waves Sound is a disturbance that travels through a medium as a longitudinal wave.
Physics 101: Lecture 33 Sound
Mechanical Waves and Sound
Sound Waves Vibration of a tuning fork
10.2 Essential Questions How is sound intensity measured?
Chapter 12 Review. Explain how waves are produced Vibration of an object is what produces sound waves. The vibrating object moves in one direction and.
Module 4 Cable Testing.
Ground Vibrations and Air Blasts: Causes, Effects and Abatement.
1/27/2016Tech I Lighting Unit1 Sound: Properties and Functions Technical Theatre I.
 What do we know about outer space?  What does the bell jar experiment tell us about sound?  Correct! Sound needs a medium to travel though....When.
Recording Arts…Audio Sound Waves Fall What does this all mean to you in this class? You are always working with sound waves – it is important to.
(8.5).  Are longitudinal waves  Require a medium to travel through  The type of medium influences the speed of the sound wave  Sound travels faster.
Ms. Barlow’s 8th Grade Physical Science Class
Ch. 15 What are waves? -A wave is a traveling disturbance that carries energy from one place to another.
V = fλ. 1. A wave is a traveling disturbance. 2. A wave carries energy from place to place.
Waves & Sound Ch 10 6 th grade. What forms mechanical waves? A wave is a disturbance involving the transfer of energy from place to place. Waves that.
As you can see, low frequencies are not absorbed as well. This means low frequencies will travel farther. That graph comes from this extremely detailed.
Introduction to Noise Control Environmental Science Ithan B. Zimmer, Ph.D., P.E.
Sound Waves Vibration of a tuning fork.
10.2 Essential Questions How is sound intensity measured?
ACOUSTICS Aural Comfort & Noise.
SURFACE EFFECTS AND PROPAGATION CHARACTERISTICS
How to measure and analyze traffic noise?
Noise Pollution Noise Mitigation
a brief revision of principles and calculations from Building Physics
I-94 Maple Grove to Rogers Community Noise Engagement Meeting #1
Sound Waves.
The Nature of Sound Chapter 21
The Physics of Sound.
Sound and Hearing it.
Sound!!.
Sound Chapter 16.
Sound and HOW WE Hear it.
ENVIRONMENTAL ENGINEERING
Sound.
Sound The Nature of Sound.
Sound.
Sound and Hearing it.
Presentation transcript:

CE 453 Lecture 7 Noise Analysis See: and and

2 Noise What is noise? Who decides? news.bbc.co.uk sprott.physics.wisc.edu/fractals/ chaos /summer/img

3 Noise Undesirable or unwanted sound Subjective Impacts Annoyance, disturbance Stress Physical and psychological damage

4 Transportation Noise Decreases with increasing distance – a corridor problem Generated by: Engine Exhaust Aerodynamic friction Interaction between tire-pavement

5 Control of Transportation Noise Federal -- Noise control act of 1972 Recognized noise as a major degrader of urban living Encourage use of noise standards State and local governments Also institute noise control

6 Noise Measurement Intensity of a single sound is measured on a relative of logarithmic scale Uses a unit called a bel (B) or subunit – decibel (dB) At 14 bels, sound is painful to human ear

7 Common Sounds

8 Noise Propagation Noise is generated at source and spreads spherically away from source Intensity diminishes with distance Losses also occur from sound energy being dissipated as sound is transferred by air particles Bending and diffraction occurs as sound waves encounter natural and manufactured solid objects

9 Noise Control Strategies Minimize noise levels Source controls Vehicle control devices – maintenance, traffic and highway design controls Path controls Sound barriers that reflect and diffuse noise Buffer zones Receiver-side controls insulation

10 Noise abatement measures Traffic management (see next slide) Buffer zones Vegetation Noise insulation Relocating the highway

11 Traffic management measures Prohibit trucks Truck routes Prohibit daytime (or night-time) use Traffic signal timing Speed limits Will all these work?

12 Noise Source

13

14

15 Paths: Effects of distance And adding sources

16 Receivers: Perceptions of noise

17 Number of people annoyed At different sound levels

18

19

20

21 Noise Measurement Significant variability in noises from transportation sources L p : noise level at a particular receptor that is exceeded p percent of the time i.e. Noise that exceeds 100 db 90% of the time A-weighted noise level (equivalent “irritation” level – has to do with mix of frequencies DNL (day/night level – weights nighttime noises)

22 What are L 10 and L eq ? L 10 is usually about 3dB greater than L eq

23 What are L 10 and L eq ? The equivalent sound level is the steady- state, A-weighted sound level which contains the same amount of acoustic energy as the actual time-varying, A-weighted sound level over a specified period of time. If the time period is 1 hour, the descriptor is the hourly equivalent sound level, Leq(h), which is widely used by SHAs as a descriptor of traffic noise. An additional descriptor, which is sometimes used, is the L10. This is simply the A-weighted sound level that is exceeded 10 percent of the time.

24 Mathematical Model Simple model L 50 = log V – 20 log D (db) Where: V = traffic volume (veh/hour) D = distance from traffic to observer in feet Also use nomographs, relate noise to speed, volume, distance, etc.

25 State of the Art is FHWA’s Traffic Noise Model (TNM) Modeling of five standard vehicle types, including automobiles, medium trucks, heavy trucks, buses, and motorcycles, as well as user-defined vehicles. Modeling of both constant-flow and interrupted-flow traffic using a 1994/1995 field- measured data base. Modeling of the effects of different pavement types, as well as the effects of graded roadways. Sound level computations based on a one-third octave-band data base and algorithms. Graphically-interactive noise barrier design and optimization. Attenuation over/through rows of buildings and dense vegetation. Multiple diffraction analysis. Parallel barrier analysis. Contour analysis, including sound level contours, barrier insertion loss contours, and sound-level difference contours. Available for $695 at McTrans

Problem: Find dBA L ft from road 2 lane road 2400 vehicles per hour 5 percent trucks 60 mph #cars =.95x2400=2280 Example Problem

27 Problem: Find dBA L 10 at 500 ft From a 2 lane road carrying: 2400 vehicles per hour 5 percent trucks, at 60 mph … cars =.95x2400=2280 L 50 dBA for cars at 100’ = 68 dBA

29 Problem: Find dBA L 10 at 500 ft From a 2 lane road carrying: 2400 vehicles per hour 5 percent trucks, at 60 mph … trucks =.05x2400=120 L 50 dBA for trucks at 100’ = 62 dBA

31 Problem: Find dBA L 10 at 500 ft From a 2 lane road carrying: 2400 vehicles per hour 5 percent trucks, at 60 mph … O-ELD = 500’

32 Problem: Find dBA L 10 at 500 ft From a road carrying: 2400 vehicles per hour 5 percent trucks, at 60 mph … Adjustment from 100ft ref = -10 dB

34 Problem: Find dBA L 10 at 500 ft From a road carrying: 2400 vehicles per hour 5 percent trucks, at 60 mph … vol/speed*ELD = 19,000 for cars, 1,000 for trucks L 10 - L 50 = 2 dBA cars, 6.5 dBA trucks

36 Adding 2 sources Heavy trucks 58.5 db Passenger vehicles 60 db

37 Difference = 60 – 58.5 = 1.5 Add 2.3 db to higher = 62.3 db due to both sources

39

40

41

42 Noise Barriers

43 Other Adjustments Grade (trucks) +/- 3-4%= +2 +/- 5-6% = +3 +/- >7 = +5 Surface very smooth = -5 (auto only) very rough = +5 (auto, or truck>60mph) Interrupted flow (L 10 ) auto = +2 Truck= +4 Foliage -5 for each 100’ >15’ -10 max Rows of houses -5 for each -10 max

44 Noise Barriers (how they work) Noise is "diffracted" over the barrier, this increases the distance it travel to the listener, thus decreasing the noise A + B > C Source:

45 Source: FHWA, “Keeping the Noise Down, Highway Traffic Noise Barriers”

46 Noise Barriers (how they work) Noise is also reflected and/or absorbed Source:

47 Possible barriers

48

49 Source: FHWA, “Keeping the Noise Down, Highway Traffic Noise Barriers”

50 Source: FHWA, “Keeping the Noise Down, Highway Traffic Noise Barriers”

51 Source: FHWA, “Keeping the Noise Down, Highway Traffic Noise Barriers”

52 Source: FHWA, “Keeping the Noise Down, Highway Traffic Noise Barriers”

53 Source: FHWA, “Keeping the Noise Down, Highway Traffic Noise Barriers”

54 Source: FHWA, “Keeping the Noise Down, Highway Traffic Noise Barriers”