ECS 152A 1. Introduction

A Communications Model Source —generates data to be transmitted Transmitter —Converts data into transmittable signals Transmission System —Carries data Receiver —Converts received signal into data Destination —Takes incoming data

Communications Tasks Transmission system utilizationAddressing InterfacingRouting Signal generationRecovery SynchronizationMessage formatting Exchange managementSecurity Error detection and correctionNetwork management Flow control

Simplified Communications Model - Diagram

Simplified Data Communications Model

Networking Point to point communication not usually practical —Devices are too far apart —Large set of devices would need impractical number of connections Solution is a communications network —Wide Area Network (WAN) —Local Area Network (LAN)

Wide Area Networks Large geographical area Crossing public rights of way Rely in part on common carrier circuits Alternative technologies —Circuit switching —Packet switching —Frame relay —Asynchronous Transfer Mode (ATM)

Circuit Switching Dedicated communications path established for the duration of the conversation e.g. telephone network

Packet Switching Data sent out of sequence Small chunks (packets) of data at a time Packets passed from node to node between source and destination Used for terminal to computer and computer to computer communications

Frame Relay Packet switching systems have large overheads to compensate for errors Modern systems are more reliable Errors can be caught in end system Most overhead for error control is stripped out

Asynchronous Transfer Mode ATM Evolution of frame relay Little overhead for error control Fixed packet (called cell) length Anything from 10Mbps to Gbps Constant data rate using packet switching technique

Local Area Networks Smaller scope —Building or small campus Usually owned by same organization as attached devices Data rates much higher Usually broadcast systems Now some switched systems and ATM are being introduced

LAN Configurations Switched —Switched Ethernet May be single or multiple switches —ATM LAN —Fibre Channel Wireless —Mobility —Ease of installation

Metropolitan Area Networks MAN Middle ground between LAN and WAN Private or public network High speed Large area

Networking Configuration

Protocol Architecture

Need For Protocol Architecture E.g. File transfer —Source must activate comms. Path or inform network of destination —Source must check destination is prepared to receive —File transfer application on source must check destination file management system will accept and store file for his user —May need file format translation Task broken into subtasks Implemented separately in layers in stack Functions needed in both systems Peer layers communicate

Key Elements of a Protocol Syntax —Data formats —Signal levels Semantics —Control information —Error handling Timing —Speed matching —Sequencing

Protocol Architecture Task of communication broken up into modules For example file transfer could use three modules —File transfer application —Communication service module —Network access module

Simplified File Transfer Architecture

A Three Layer Model Network Access Layer Transport Layer Application Layer

Network Access Layer Exchange of data between the computer and the network Sending computer provides address of destination May invoke levels of service Dependent on type of network used (LAN, packet switched etc.)

Transport Layer Reliable data exchange Independent of network being used Independent of application

Application Layer Support for different user applications e.g. , file transfer

Protocol Architectures and Networks

Addressing Requirements Two levels of addressing required Each computer needs unique network address Each application on a (multi-tasking) computer needs a unique address within the computer —The service access point or SAP —The port on TCP/IP stacks

Protocols in Simplified Architecture

Protocol Data Units (PDU) At each layer, protocols are used to communicate Control information is added to user data at each layer Transport layer may fragment user data Each fragment has a transport header added —Destination SAP —Sequence number —Error detection code This gives a transport protocol data unit

Protocol Data Units

Network PDU Adds network header —network address for destination computer —Facilities requests

Operation of a Protocol Architecture

Standardized Protocol Architectures Required for devices to communicate Vendors have more marketable products Customers can insist on standards based equipment Two standards: —OSI Reference model Never lived up to early promises —TCP/IP protocol suite Most widely used Also: IBM Systems Network Architecture (SNA)

OSI Open Systems Interconnection Developed by the International Organization for Standardization (ISO) Seven layers A theoretical system delivered too late! TCP/IP is the de facto standard

OSI - The Model A layer model Each layer performs a subset of the required communication functions Each layer relies on the next lower layer to perform more primitive functions Each layer provides services to the next higher layer Changes in one layer should not require changes in other layers

OSI Layers

The OSI Environment

OSI as Framework for Standardization

Elements of Standardization Protocol specification —Operates between the same layer on two systems —May involve different operating system —Protocol specification must be precise Format of data units Semantics of all fields allowable sequence of PCUs Service definition —Functional description of what is provided Addressing —Referenced by SAPs

Service Primitives and Parameters Services between adjacent layers expressed in terms of primitives and parameters Primitives specify function to be performed Parameters pass data and control info

OSI Layers (1) Physical —Physical interface between devices Data Link —Means of activating, maintaining and deactivating a reliable link —Error detection and control —Higher layers may assume error free transmission

OSI Layers (2) Network —Transport of information —Higher layers do not need to know about underlying technology —Not needed on direct links Transport —Exchange of data between end systems —Error free —In sequence —No losses —No duplicates —Quality of service

OSI Layers (3) Session —Control of dialogues between applications —Dialogue discipline —Grouping —Recovery Presentation —Data formats and coding —Data compression —Encryption Application —Means for applications to access OSI environment

Use of a Relay

TCP/IP Protocol Architecture Developed by the US Defense Advanced Research Project Agency (DARPA) for its packet switched network (ARPANET) Used by the global Internet No official model but a working one. —Application layer —Host to host or transport layer —Internet layer —Network access layer —Physical layer

Physical Layer Physical interface between data transmission device (e.g. computer) and transmission medium or network Characteristics of transmission medium Signal levels Data rates etc.

Network Access Layer Exchange of data between end system and network Destination address provision Invoking services like priority

Internet Layer (IP) Systems may be attached to different networks Routing functions across multiple networks Implemented in end systems and routers

Transport Layer (TCP) Reliable delivery of data Ordering of delivery

Application Layer Support for user applications e.g. http, SMPT

OSI v TCP/IP

TCP Usual transport layer is Transmission Control Protocol —Reliable connection Connection —Temporary logical association between entities in different systems TCP PDU —Called TCP segment —Includes source and destination port (c.f. SAP) Identify respective users (applications) Connection refers to pair of ports TCP tracks segments between entities on each connection

UDP Alternative to TCP is User Datagram Protocol Not guaranteed delivery No preservation of sequence No protection against duplication Minimum overhead Adds port addressing to IP

TCP/IP Concepts

Addressing level Level in architecture at which entity is named Unique address for each end system (computer) and router Network level address —IP or internet address (TCP/IP) —Network service access point or NSAP (OSI) Process within the system —Port number (TCP/IP) —Service access point or SAP (OSI)

Trace of Simple Operation Process associated with port 1 in host A sends message to port 2 in host B Process at A hands down message to TCP to send to port 2 TCP hands down to IP to send to host B IP hands down to network layer (e.g. Ethernet) to send to router J Generates a set of encapsulated PDUs

PDUs in TCP/IP

Some Protocols in TCP/IP Suite