ECE 201 Circuit Theory I1 Assessment Problem #4.1 Page 99 of the text by Nilsson and Riedel.

Slides:

Advertisements

Similar presentations

Solving Systems Using Substitution or Elimination Circuit #1 Solve each system using substitution or elimination.

Advertisements

1 Practical OP-AMP Circuits. 2 i i Integrator 3 Differentiator i i.

ECE 201 Circuit Theory I1 Assessment Problem # 4.12 Mesh-Current Method Special Case Current Source in a branch.

1 ECE 221 Electric Circuit Analysis I Chapter 8 Example 4.3, Problem 4.11 Node-Voltage Method Herbert G. Mayer, PSU Status 1/19/2015.

Objective of Lecture Provide step-by-step instructions for nodal analysis, which is a method to calculate node voltages and currents that flow through.

Lecture 4: Nodal Analysis Nilsson & Riedel ENG17 (Sec. 2): Circuits I Spring April 10, 2014.

Lecture 81 Loop (Mesh) Analysis (3.2) Prof. Phillips February 17, 2003.

Lecture 291 More Loop and Nodal Analysis. Lecture 292 Advantages of Nodal Analysis Solves directly for node voltages. Current sources are easy. Voltage.

Response of First-Order Circuits

ECE 201 Circuit Theory I1 Superposition Principle of “Superposition” –When a linear circuit is excited by more than one independent source of energy, the.

Example 4.2 Using the Node-Voltage Method Use the node-voltage method of circuit analysis to find the branch currents in the circuit shown.

Lecture 71 Nodal Analysis (3.1) Prof. Phillips February 7, 2003.

RLC Circuits Natural Response ECE 201 Circuit Theory I.

ECE201 Lect-101 Loop (Mesh) Analysis (3.2) Dr. Holbert February 27, 2006.

METHODS OF ANALYSIS Mesh Analysis Nodal analysis.

Lecture 261 Nodal Analysis. Lecture 262 Example: A Summing Circuit The output voltage V of this circuit is proportional to the sum of the two input currents.

ECE201 Lect-91 Nodal Analysis (3.1) Dr. Holbert February 22, 2006.

ECE 201 Circuit Theory I1 Resistors in Series Resistors connected at a single node Current through each resistor is the same.

ECE 201 Circuit Theory I1 Step Response of an RC Circuit + v C (t) - i(t) Close the switch at t = 0 Write KCL at the top node Allow for the possibility.

ECE 201 Circuit Theory I1 Node-Voltage Method Special Case Voltage source between essential nodes.

ECE 201 Circuit Theory I1 Thevenin Equivalent of a circuit containing a dependent source.

Series-Parallel Combinations of Inductance and Capacitance

ECE201 Lect-81 Circuits with Resistor Combinations (2.6, 7.7) Prof. Phillips Jan 31, 2003.

ECE 201 Circuit Theory I1 Assessment Problem #4.7 Page 102 of the text by Nilsson and Riedel.

ECE 201 Circuit Theory I1 Node-Voltage Method Identify the nodes –There are 3 “essential” nodes. –Node 0 is the “ground” or “reference” node where the.

ECE 201 Circuit Theory I1 Resistors in Parallel Resistors connected at a single node pair Voltage across each resistor is the same.

ECE 201 Circuit Theory I1 Source Transformation Convert a Voltage Source in Series with a Resistance into A Current Source in Parallel with the SAME Resistance.

Lect4EEE 2021 Nodal Analysis Dr. Holbert January 28, 2008.

Lecture 271 More Nodal Analysis. Lecture 272 Where We Are Nodal analysis is a technique that allows us to analyze more complicated circuits than those.

Lecture 281 Loop Analysis. Lecture 282 Loop Analysis Nodal analysis was developed by applying KCL at each non-reference node. Loop analysis is developed.

ECE201 Exam #2 Review1 Exam #2 Review Dr. Holbert March 27, 2006.

Example ECE 201 Circuit Theory 1. A load having an impedance of 39 + j26 Ω is fed from a voltage source through a line having an impedance of 1.

Lecture 4 Node/Loop Analysis. Although they are very important concepts, series/parallel equivalents and the current/voltage division principles are not.

ECE 201 Circuit Theory I1 Natural Response of an RC Circuit.

Meshes and Loops Steps of Mesh Analysis Supermesh Examples Lecture 6. Mesh Analysis 1.

ECE 201 Circuit Theory I1 Sinusoidal response of circuits The switch is closed at t = 0. Determine the current i(t) for t >= 0. i(t)

ECE 201 Circuit Theory I1 Passive elements in the frequency domain Consider a resistor, R, in the time domain + v - i.

ECE 201 Circuit Theory I1 Thevenin Equivalent for a circuit containing a dependent source.

The Node Voltage Method

ECE 201 Circuit Theory 11 Source Transformation to Solve a Circuit Find the power associated with the 6 V source. State whether the 6 V source is absorbing.

ECE201 Lect-31 Single Loop Circuits (2.3); Single-Node-Pair Circuits (2.4) Dr. Holbert August 28, 2001.

ECE 3710 E: Circuits and Electronics Jeff Dugger Lecture 4: 08/31/00.

What is an Op Amp? Ideal Op Amps Applications Examples Lecture 9. Op Amps I 1.

Circuit Analysis Techniques 1.Circuit Reduction 2.Node-Voltage method 3.Mesh- Current method. 4.Superposition method. 5.Thevenin’s and Norton’s circuits.

3.1. Introduction Step to analyze AC Circuits: 1.Transform the circuit to the phasor or frequency domain. 2.Solve the problem using circuit techniques.

ECE 2300 Circuit Analysis Lecture Set #6 The Node Voltage Method with Voltage Sources.

ECE 201 Circuit Theory I1 ECE 201 Homework Guidelines Be neat and use Engineering Paper! Begin each problem on a new sheet Identify each problem –Problem.

Fall 2001ENGR201 Nodal Analysis1 Read pages Nodal Analysis: Nodal analysis is a systematic application of KCL that generates a system of equations.

Objective of Lecture Provide step-by-step instructions for nodal analysis, which is a method to calculate node voltages and currents that flow through.

1 Loop (Mesh) Analysis. 2 Loop Analysis Nodal analysis was developed by applying KCL at each non-reference node. Loop analysis is developed by applying.

ECE 201 Circuit Theory 11 Step Response of an RL Circuit Find the current in the loop or the voltage across the inductor after the switch is closed at.

Lesson 11: Nodal Analysis II

Problems With Assistance Module 3 – Problem 4 Filename: PWA_Mod03_Prob04.ppt Next slide Go straight to the Problem Statement Go straight to the First.

ECE201 Lect-151 Nodal Analysis (7.8) Dr. Stephen Goodnick October 3, 2003.

ECE201 Lect-111 Circuits with Resistor Combinations (2.6, 7.7) Dr. S. M. Goodnick September 19, 2003.

1 Lecture #6 EGR 272 – Circuit Theory II Read: Chapter 9 and Appendix B in Electric Circuits, 6 th Edition by Nilsson Using Phasors to Add Sinusoids Sinusoidal.

Problems With Assistance Module 3 – Problem 3 Filename: PWA_Mod03_Prob03.ppt This problem is adapted from: Exam #2 – Problem #1 – ECE 2300 – July 25,

Page 102 of the text by Nilsson and Riedel

Page 107 of the text by Nilsson and Riedel

ELECTRIC CIRCUITS James Nilsson – Susan Riedel.

Lecture 01 - Node Voltage Analysis

Example 4.2 Using the Node-Voltage Method

Node-Voltage Method Identify the nodes

The KCL equations for nodes 1 through 4 follow

Superposition Principle of “Superposition”

Lecture 06 - Node Voltage Analysis

Resistors in Parallel Resistors connected at a single node pair

Resistors in Series Resistors connected at a single node

Node - Voltage Method ECE 201 Circuit Theory I.

Lecture 07 - Node Voltage Analysis

Presentation transcript:

ECE 201 Circuit Theory I1 Assessment Problem #4.1 Page 99 of the text by Nilsson and Riedel

ECE 201 Circuit Theory I2 Use the node-voltage method to find v 1, v 2, and i 1 +v1-+v1- +v2-+v2- i1i1

ECE 201 Circuit Theory I3 Identify the voltages and currents i1i1 v1v1 v2v2 i3i3 i2i2 i4i4

ECE 201 Circuit Theory I4 Write KCL at each node i1i1 v1v1 v2v2 i3i3 i2i2 i4i4

ECE 201 Circuit Theory I5 v1v1 v2v2

6 Solving +v1-+v1- +v2-+v2- i1i1

ECE 201 Circuit Theory I7 How much power is delivered by the current sources? + 60V V -