1 Power Management in IEEE Yu-Chee 1. Possible Access Sequences for a STA in PS Mode 2. PS in Infrastructure Network 3. PS in Ad Hoc Network

2 Motivation Since mobile hosts are supported by battery power, saving battery as much as possible is very important. Power management in in infrastructure network vs. ad hoc network PCF vs. DCF

3 Introduction Power management modes Active mode (AM) Power Save mode (PS) Power consumption of ORiNOCO WLAN Card Transmit mode Receive mode Idle modeDoze mode 1400mW900mW700mW60mW

4 Basic Idea AP or source hosts buffer packets for hosts in PS mode. AP or sources send TIM periodically. TIM = traffic indication map (a partial virtual bitmap associated with station id) TIM is associated with beacon. Hosts in PS mode only turn on antenna when necessary. Hosts in PS mode only “wake up” to monitor TIM.

5 Basic Idea: TIM Types TIM : transmitted with every beacon (for Unicast) Delivery TIM (DTIM): transmitted less frequently (every DTIM_interval) for sending buffered broadcast packets Ad hoc TIM (ATIM): transmitted in ATIM-Window by stations who want to send buffered packets structured the same as TIM

6 Basic Idea: An Illustration Example

7 Possible Access Sequences for a STA in PS Mode immediate response immediate response with fragmentation deferred response

8 Power Saving Sequences stations shut down the radio transceiver and sleeping periodically to increase battery life. During sleeping periods, access points buffer any unicast frames for sleeping stations. These frames are announced by subsequent Beacon frames. To retrieve buffered frames, newly awakened stations use PS-Poll frames.

9 Immediate Response AP can respond immediately to the PS-Poll PS-Poll frame contains an Association ID in the Duration/ID field so AP can determine which frames were buffered for the MS. Since Duration is not used, it assumes NAV = SIFS + ACK Although the NAV is too short, the medium is seized by data frame.

10 Example: Immediate Response

11 Immediate Response with Fragmentation If the buffered frame is large, it may require fragmentation. ** note: the change of NAVs

12 Deferred Response After being polled, the AP may decide to respond with a simple ACK. although promised, AP does not act immediately AP may do regular DCF activities the PS station must remain awake until it is delivered

13 fig The PS station must stay awake until the next Beacon frame in which its bit in TIM is clear. Fragmentation is possible too.

14 PS in Infrastructure Network

15 Assumptions and Models Assumptions: TIM interval (beacon interval) and DTIM interval are known by all hosts requires time synchronization Two Operational Models: under DCF (contention-based) under PCF (contention-free): omitted

16 Under DCF (Infrastructure Mode) Basic assumption: use CSMA/CA to access the channel RTS, CTS, ACK, PS-Poll are used to overcome the hidden-terminal problem

17 Operations of TIM (in DCF) AP periodically broadcasts beacon with TIM. but STAs may have different wake-up intervals. Hosts in PS must wake up to check TIM. If found having packets buffered in AP, send PS-Poll to AP (by contention). AP replies PS-poll with ACK or DATA. The receiver must remain in active mode until it receives the packet.

18 Buffered Frame Retrieval Process for Two Stations Station 1 has a listen interval = 2. Station 2 has a listen interval = 3.

19 Multicast and Broadcasting: Delivery TIM (DTIM) Frames are buffered whenever any station associated with the AP is sleeping. Buffered broadcast and multicast frames are saved using AID = 0. AP sets the first bit in the TIM to 0. At a fixed number of Beacon intervals, a DTIM is sent. Buffered broadcast and multicast traffic is transmitted after a DTIM Beacon.

20 Buffer Transmission after DTIM DTIM interval = 3

21 (omitted) Under PCF (Infrastructure Mode) Basic Assumption: Point coordinator uses CF-Polling to access the channel. AP only maintains the CF-Pollable stations.

22 Operations of TIM (PCF) AP broadcasts beacon with TIM. Hosts in PS mode checks TIM for their IDs. If there are buffered packets in AP, the host must remain in Active Mode until being polled. O/w, the station goes back to PS mode. Then AP polls those PS stations. When being polled, the station (in PS mode) sends PS-Poll to AP. Then AP sends buffered packets to the station. (See next page.) AP must poll stations in PS mode first.

23 TIM Poll TIM Beacon_ Interval AP STA 2 in PS mode PS-poll STA 1 in PS mode Data ACK PS-poll Data ACK Poll

24 Operations of DTIM (PCF) All CF-pollable stations need be in Active Mode when AP broadcasts DTIM. Immediately after DTIM, AP sends out the buffered broadcast/multicast packets.

25 DTIM Broadcast Data TIM Beacon_ Interval AP STA 2 in PS mode STA 1 in PS mode

26 PS in Ad Hoc Mode (without base station)

27 Announcement TIM (ATIM) All stations in an IBSS listen for ATIM frames during specified periods after Beacon transmissions. Stations that do not receive ATIM frames are free to conserve power.

28 ATIM Usage

29 ATIM Window If the beacon is delayed due to a traffic overrun, the useable portion of the ATIM window shrinks.

30 PS in Ad Hoc Mode Assumptions: beacon interval & ATIM window are known by all hosts Each station predicts which stations are in PS mode. The network is fully connected. Basic Method: CSMA/CA is used to access the channel. RTS, CTS, ACK, PS-Poll are used to overcome hidden terminal.

31 Operations of ATIM All stations should be in active mode during ATIM window. The station which completes its backoff procedure broadcasts a beacon. Sending beacon is based on contention. Any beacon starts the ATIM window. Once a beacon is heard, the rest beacons are inhibited.

32 In ATIM window, each source station having buffered packets to be sent contends to send out its ATIM. If a host finds it is in the ATIM name list, send an ACK to the sender. remain in the ACTIVE mode throughout the beacon interval. If the host is not in the name list, it can go back to the PS mode. After ATIM window, all stations use CSMA/CA to send the buffered packets basic idea: data packet >> ATIM control frames only those hosts who have ACKed the ATIM have such opportunity.

33 ATIM Example

34 ATIM Example (STA 1 Waking Up STAs 2, 3, and 4)

35 Summary of PS infrastructure network PCF DCF (omitted) ad hoc network DCF