Semiconductor basics 1. Vacuum tubes  Diode  Triode 2. Semiconductors  Diode  Transistors Bipolar Bipolar Field Effect Field Effect 3. What’s next?

Slides:

Advertisements

Similar presentations

MICROWAVE FET Microwave FET : operates in the microwave frequencies

Advertisements

Semiconductors Chapters

ELECTRICAL CONDUCTIVITY

J-FET (Junction Field Effect Transistor) Introduction The field-effect transistor (FET) controls the current between two points but does so differently.

Transistors These are three terminal devices, where the current or voltage at one terminal, the input terminal, controls the flow of current between the.

Physics of Bipolar Junction Transistor Section

Chapter 4 Bipolar Junction Transistor

Basic Electronics Ninth Edition Basic Electronics Ninth Edition ©2002 The McGraw-Hill Companies Grob Schultz.

MOSFETs Monday 19 th September. MOSFETs Monday 19 th September In this presentation we will look at the following: State the main differences between.

Current Components inside Bipolar Junction Transistor (BJT) NPN BJT.

10/4/2004EE 42 fall 2004 lecture 151 Lecture #15 Basic amplifiers, Intro to Bipolar transistors Reading: transistors (chapter 6 and 14)

Principles & Applications

Dr. Nasim Zafar Electronics 1 EEE 231 – BS Electrical Engineering Fall Semester – 2012 COMSATS Institute of Information Technology Virtual campus Islamabad.

Transistors Electronics 1 CVSD.

BJT in Saturation Mode Section 4.5.

Module 2 Bipolar Junction Transistor. Learning Outcomes 1.The 3 terminals or regions of a BJT. 2.Construction and symbol of NPN and PNP types 3.Low power.

NAME OF FACULTY : MR. Harekrishna Avaiya DEPARTMENT: E.C. (PPI-1ST)

Recap in Unit 2 EE2301: Block B Unit 2.

Principles & Applications

Principles & Applications

What ARE all those little things anyway?

Higher Physics Semiconductor Diodes. Light Emitting Diode 1  An LED is a forward biased diode  When a current flows, electron-hole pairs combine at.

SEMICONDUCTORS Thyristor.

Intro to Mechatronics 18 February 2005 Student Lecture: Transistors

Chapter 5: Field Effect Transistor

Bipolar Junction Transistors (BJTs) The bipolar junction transistor is a semiconductor device constructed with three doped regions. These regions essentially.

Recall Lecture 8 Clipper – Step 1: Find the clip value by doing KVL at the output branch – Step 2: Set the conditions to know whether diode is on or off.

BJT Band diagram Analysis تجزيه وتحليل دياگرام باند انرژي.

Large Part Of This Lecture is Taken From Manipal Institute India

The Transistor 1. How does a Transistor work The Bipolar Transistor The Field Effect Transistor 2. Comparing a Transistor to other devices Diode vs. the.

Introduction to Transistors

Transistors and Semiconductors Miracle Makers of Modern Electronics Graphics courtesy intel.com Research at ience/index.html.

Conductors – many electrons free to move

1 Electronic Circuits AMPLIFIERS. 2 Demostrate Transistor Amplification Determine Transistor Biasing. Explain Transistor Regions - Emitter, Base, Collector.

PN-Junction Diode Characteristics

Power Semiconductor Devices Power Diodes Cross-sectional view of a pn- junction diode intended for power applications. I-V characteristics of a pn- junction.

 A transistor: a three-terminal semiconductor device that can perform two functions: amplification and switching.  Amplification consists of magnifying.

RESISTORS CAPACITORS DIODES AND OTHER SOLID STATE COMPONENTS TRANSISTORS

1 Other Transistor Topologies 30 March and 1 April 2015 The two gate terminals are tied together to form single gate connection; the source terminal is.

AMATEUR RADIO OPERATOR INTRODUCTION January 2013 Active Devices Diodes, Transistors, and Tubes.

Spencer/Ghausi, Introduction to Electronic Circuit Design, 1e, ©2003, Pearson Education, Inc. Chapter 2, slide 1 Introduction to Electronic Circuit Design.

1 Concepts of electrons and holes in semiconductors.

Transistor Basics – Part I. The Diode The semi-conductor phenomena Diode performance with AC and DC currents Diode types –General purpose –LED –Zenier.

Diodes, Transistors and Tubes. Silicon Semiconductors.

Introduction Semiconductors are materials whose electrical properties lie between Conductors and Insulators. Ex : Silicon and Germanium.

CSE251 Lecture 8: Introduction to Bipolar Junction Transistor (BJT)

NAME: NIDHI PARMAR ENR.NO.: GUIDED BY: RICHA TRIPATHI.

Intrinsic. N-Type P-Type The Diode and PN Junction.

Regions of a Transistor A Bipolar Junction Transistor is a three terminal device containing 3 regions: Emitter, Base and Collector.

MOS Capacitor Lecture #5. Transistor Voltage controlled switch or amplifier : control the output by the input to achieve switch or amplifier Two types.

1 Lawndale High School AWIM Program Transistor Theory & Experiment Lecture 5.

J-FET (Junction Field Effect Transistor)

Transistors Student Lecture by: Giangiacomo Groppi Joel Cassell

LTFY – Physics and Engineering

Other Transistor Topologies

Semiconductor Devices

Intro to Semiconductors and p-n junction devices

Bipolar Junction Transistor (BJT) Chapter and 25 March 2016

Bipolar Junction Transistors (BJT)

Actives Devices: Diodes, Transistors, Tubes

Chapter 1 – Semiconductor Devices – Part 2

Electronic Fundamental Muhammad Zahid

Physics of Bipolar Junction Transistor

Physics of Bipolar Junction Transistor

Bipolar Junction Transistor (BJT) Chapter and 17 March 2017

Other Transistor Topologies

BIPOLAR JUNCTION TRANSISTOR (BJT)

Bipolar Junction Transistor (BJT) Chapter and 27 March 2019

Other Transistor Topologies

Presentation transcript:

Semiconductor basics 1. Vacuum tubes  Diode  Triode 2. Semiconductors  Diode  Transistors Bipolar Bipolar Field Effect Field Effect 3. What’s next?

Vacuum Tubes, diode Diode: a device that only allows current to flow in one direction. Filament to heat cathode ~6.3V V cathode anode

Vacuum Tubes, triode Triode: a device that controls (amplifies) a currents by a voltage.

Semiconductors, the p-n junction Doping provides charge carriers that are very close to conduction band.

Semiconductors, the p-n junction Forward biasing: current reverse biasing: high potential

Semiconductors, bipolar transistor An NPN transistor can be considered as two diodes with a shared anode region. The base region of the transistor must be made thin, so that carriers can diffuse across it in much less time than the semiconductor's minority carrier lifetime, to minimize the percentage of carriers that recombine before reaching the collector–base junction. The collector– base junction is reverse-biased, electrons that diffuse through the base towards the collector are swept into the collector by the electric field in the depletion region of the collector–base junction and this forms the collector current which is controlled by the base-emitter p-n junction. The first working transistor, Bell lab 1947

Semiconductors, field effect transistor Like an NPN bipolar transistor, but know bass current. The gate-source p-n junction is controlled by the potential applied to the gate. This in turn controls the current from drain to source. One may think that the voltage applied to gate controls the size of a conductive channel between the drain and source and hence the current in that channel. So a FET is a voltage controlled resistor.

Review questions How quantum physics changed our world? How quantum physics changed our world? Do you believe that future breakthroughs in physics will further change our world for better? Do you believe that future breakthroughs in physics will further change our world for better?