Chapter 12 Gas-Liquid Equilibrium

Slides:



Advertisements
Similar presentations
Department of Mechanical Engineering ME 322 – Mechanical Engineering Thermodynamics Lecture 32 Ideal Gas Mixtures II.
Advertisements

APPLICATIONS Applications of Raoult’s law
PTT 201/4 THERMODYNAMICS SEM 1 (2013/2014) 1. 2 Objectives Develop rules for determining nonreacting gas mixture properties from knowledge of mixture.
Solutions Lecture 6. Clapeyron Equation Consider two phases - graphite & diamond–of one component, C. Under what conditions does one change into the other?
Lecture 5: Isothermal Flash Calculations 1 In the last lecture we: Described energy and entropy balances in flowing systems Defined availability and lost.
For a closed system consists of n moles, eq. (1.14) becomes: (2.1) This equation may be applied to a single-phase fluid in a closed system wherein no.
VAPOR LIQUID EQUILIBRUIM
CHEE 311Lecture 161 Correlation of Liquid Phase Data SVNA 12.1 Purpose of this lecture: To show how activity coefficients can be calculated by means of.
Advanced Thermodynamics Note 11 Solution Thermodynamics: Applications
Goal 1: Design a flash drum
PETE 310 Lectures # 6 & # 7 Phase Behavior – Pure Substances (Lecture # 5) Two Component Mixtures Three & Multicomponent Mixtures.
Properties of Reservoir Fluids Fugacity and Equilibrium Fall 2010 Shahab Gerami 1.
PETE 310 Lectures # 32 to 34 Cubic Equations of State …Last Lectures.
Properties of Solutions
Chapter 14-Part VII Applications of VLLE.
Chapter 14: Phase Equilibria Applications
Ideal Gas Law Physics 313 Professor Lee Carkner Lecture 10.
Chemical Engineering Thermodynamics II
Solution Thermodynamics: Applications
Gas Mixtures Chapter 13. Composition of a Gas Mixture: Mass and Mole Fractions Mass Fraction (mf): The ratio of mass of a component to the mass of the.
Bubble Point and dew point Calculations
Solution Thermodynamic:
EGR 334 Thermodynamics Chapter 12: Sections 1-4
Advanced Thermodynamics Note 9 Vapor/Liquid Equilibrium: Introduction
* Reading Assignments:
Wet Gas – Specific Gravity & Z-factor
FLASH CALCULATION A flash is a single-equilibrium stage distillation in witch a feed is partially vaporized to give a vapor richer in the most volatile.
Mass and Energy Balances – Stripping Section and Partial Reboiler
Three & Multicomponent Mixtures…
Vapor pressure and liquids Vapor : A gas that exists below its critical point Gas : gas that exists above its critical point ِNote : A gas can not condense.
Vapor Pressure of Solutions Chapter 13 Part 3. Vapor Pressure The pressure of the vapor present. Vapor is the liquid molecule in gas form over the liquid.
Physical Chemistry I (TKK-2246) 14/15 Semester 2 Instructor: Rama Oktavian Office Hr.: M – F
2.1 Mixtures of Ideal Gases The partial pressure of a gas in a mixture of gases is the pressure that gas would have if it occupied the total volume of.
Chapters 10 and 11: Gases Chemistry Mrs. Herrmann.
VAPOR/LIQUID EQUILIBRIUM- Introduction
Effect of Pressure Copyright © 2011 Pearson Canada Inc. Slide 1 of 46 General Chemistry: Chapter 13 William Henry found that the solubility of a gas increases.
1. (1.3) (1.8) (1.11) (1.14) Fundamental equations for homogeneous closed system consisting of 1 mole:
The Simplest Phase Equilibrium Examples and Some Simple Estimating Rules Chapter 3.
Chapter Colligative Properties: Property of the solvent that depends on the number, not the identity, of the solute particles. 2 assumptions: no.
WCB/McGraw-Hill © The McGraw-Hill Companies, Inc.,1998 Thermodynamics Çengel Boles Third Edition 12 CHAPTER Gas Mixtures.
Chapter 13 Chemical Equilibrium The state where the concentrations of all reactants and products remain constant with time. On the molecular level, there.
Vapor Pressure. Pressure of the vapor present when equilibrium is achieved between the rate of vaporization and the rate of condensation. At the boiling.
Dalton’s law of partial pressure At constant volume and temperature, the total pressure of a mixture of gases is the sum of the partial pressures of all.
CHEE 311J.S. Parent1 4. Chemical Potential in Mixtures When we add dn moles of a component to n moles of itself, we will observe (?) a change in Gibbs.
The Ideal Gas Law No gas perfectly obeys all of the gas laws under all conditions. Nevertheless, these assumptions work well for most gases and most conditions.
APPLICATIONS Applications of Raoult’s law
Chemical Engineering Thermodynamics II
PETE 310 Lecture # 26 Chapter 12 Gas-Liquid Equilibrium Non-ideal VLE.
Introduction to phase equilibrium
Ideal and Dilute Solutions 2/21/2016. Master Thermodynamics Equations.
Chemical Engineering Thermodynamics II Dr. Perla B. Balbuena: JEB 240 Web site:
8. Solute (1) / Solvent (2) Systems 12.7 SVNA
SOLUTION THERMODYNAMICS:
Noorulnajwa Diyana Yaacob PPK Bioproses Universiti Malaysia Perlis MULTIPHASE SYSTEM.
Chemical Engineering Thermodynamics II Dr. Perla B. Balbuena: JEB 240 Website:
Solution Thermodynamics: Applications Chapter 12-Part IV.
공정 열역학 Chapter 3. Volumetric Properties of Pure Fluids
Wednesday, October 7 th  Please take out your notes!  A gas mixture with a total pressure of 745 mmHg contains each of the following gases.
Vapor – Liquid Equilibrium
RESERVOIR ENGINEERING
Solution of Thermodynamics: Theory and applications
Chapter 6: Properties of Solutions
THERMODYNAMICS OF SOLUTIONS
Lecture 49 More on Phase Transition, binary system
Chapter 2 Multi-Phase Systems.
Don’t be in a such a hurry to condemn a person because he doesn’t do what you do, or think as you think. There was a time when you didn’t know what you.
Gases Ch 12.
Lecture # 26 Chapter 12 Gas-Liquid Equilibrium Non-ideal VLE
Chapter 12 Gas-Liquid Equilibrium
Department of Chemical Engineering, University of Nizwa
Presentation transcript:

Chapter 12 Gas-Liquid Equilibrium PETE 310 Lectures # 25 -26 Chapter 12 Gas-Liquid Equilibrium

Gas-Liquid Equilibrium Ideal Behavior Applications to low pressures Simplifications the gas phase behaves as an Ideal Gas the liquid phase exhibits Ideal Solution Behavior

Ideal Behavior The equilibrium criteria between 2 phases a and b is,

Equilibrium Conditions The last criteria implies “tendency of a component to be in phase a or b is balanced” – “net mass transfer across phases is zero”

Ideal Behavior Model Gas phase behaves as an ideal gas (IG), and liquid phase behaves as an ideal solution (IS). These assumptions imply that IG: molecular interactions are zero, molecules have no volume. IS: forces of attraction/repulsion between molecules are the same regardless of molecular species. Volumes are additive (Amagat’s Law).

Forces between molecular species A A B B A B

Statement of Equilibrium IG/IS Raoult’s law 1 2 P 3 T

Types of VLE Calculations Temperature x1, y1 Pressure P2v Ta CP1 Bubble Curve Dew Curve Flash Liquid Vapor P1v CP2 1

Recall Molar Compositions By convention liquid compositions (mole fractions) are indicated with an x and gas compositions with a y.

Mathematical Relationships with In general

Depletion Path Isothermal Reservoir Depletion Process for a Reservoir Oil with 2 Components z = fix ed A 1 T = T CP a M B P B C Pressure P D T x z y 1 a Temperature 1 1 1 z1=overall mole fraction of [1], y1=vapor mole fraction of [1], x1=liquid mole fraction of [1]

Quantitative Phase Equilibrium Exercise

Bubble Point Evaluation (Ideal Behavior Model) The bubble point pressure at a given T is

Bubble Point from Raoult's law zi=xi

Bubble Point Evaluation Under Raoult’s law, the bubble point has a linear dependence with the vapor pressures of the pure components. Once the bubble point pressure is found, the equilibrium vapor compositions are found from Raoult’s law.

Dew Point Calculation At the dew point the overall fluid composition coincides with the gas composition. That is.

Dew Point Calculation (Ideal Behavior Model) Find DP pressure and equilibrium liquid compositions

Dew Point from Raoult's law zi=yi

Flash Calculations In this type of calculations the objective is to: find fraction of vapor vaporized (fv) and equilibrium gas and liquid compositions given the overall mixture composition, P and T.

Flash Calculations (Ideal Behavior Calculations) Start with the equilibrium equation Material balance

Flash Calculations Now replace either liquid or gas compositions using equilibrium equation Here replaced xi

Flash Calculations Rearrange and sum over all yi

Separation process zi(T1,P1) xi(T1,P2) yi(T1,P2) P1 > P2 T1,P2

Flash Calculations Objective function (flash function) is This is 1/ki – ideal equilibrium ratio

Flash Calculations There are several equivalent expressions for the flash function (a) (b) (c)

Flash Calculations Once fv is found the equilibrium gas and liquid compositions are evaluated from and

Vapor Pressure Models (Antoine Equation) 1. Constants depend upon the component – Different Units

Example in our web site excel file VLE_310