B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Experimental setup: l 250.

Slides:



Advertisements
Similar presentations
Civil Engineering Materials
Advertisements

1 Steel balls Topic 3 Taiwan Representative. 2 Outline Question Experimental set up: Vertical collision Materials: Paper, Plastic, and Metal sheets Experimental.
MOISTURE CURLING OF CONCRETE SLABS FOR AIRFIELD APPLICATIONS Chang Joon Lee, Yi-Shi Liu, Ben Birch, David A. Lange, Jeffery R. Roesler z x y ▪ To further.
Modulus of Elasticity and Poisson Ratio of Concrete
1 Class #27.1 Civil Engineering Materials – CIVE 2110 Concrete Material ShrinkageCreep Thermal Properties Fall 2010 Dr. Gupta Dr. Pickett.
Lecture #13 Properties of Hardening Concrete Curing.
Reinforced Concrete Design
EARLY AGE COMPRESSIVE AND TENSILE STRENGTH DEVELOPMENT OBJECTIVE Determine how SCC strategies…  high paste content  VMA (thickeners)  smaller aggregate.
High Temperature Composites Rutgers University Federal Aviation Administration Advanced Materials Flammability Atlantic City, NJ October 24, 2001.
MECHANISMS   Constant Uniaxial Tension Autogenous Shrinkage Elastic Viscoelastic     Time Stress Time Stress * * * Not an exact analytical solution.
Ta-Te Lin, Yi-Chung Chang
MEASUREMENT OF HYGROTHERMAL STRESS IN EXTERIOR WOOD COATINGS Mari de Meijer - Drywood Coatings Johan Nienhuis - SHR Timber Research.
Fatigue Analysis of JPCP With Transverse Surface Crack Introduction Experimental Design Conclusions It has been known that surface edge crack of JPCP (Joint.
WORKSHEET 4 CONCRETE. Q1 a) what are the two main properties that concrete must have? (i) strength b) how do we achieve them? by using an acceptable water.
Mean thermal conductivity of VIPs during service life time R. Caps va-Q-tec AG, Würzburg Annex 65 meeting Grenoble, 11th/12th Sept
Mechanical Properties of HPC with Expansive Additive and Shrinkage Reducing Admixture under Simulated Completely- Restrained Condition at Early Age Takafumi.
Effect of Heat on Insects Ole Dosland Technical Training Director.
Volumetric Change of Repair Materials Low Shrinkage Materials.
Pre-Lab: Absorption & Radiation by Land & Water
Mechanical characterization of lead- free solder joints J. Cugnoni*, A. Mellal*, Th. J. Pr. J. Botsis* * LMAF / EPFL EMPA Switzerland.
Curing Concrete. Curing n Moisture n Temperature n Time Curing requires adequate — If any of these factors are neglected, the desired properties will.
Strength of Concrete.
1 Class #26 Civil Engineering Materials – CIVE 2110 Concrete Material Concrete Compressive Strength, f’ c Cracking Aging, Maturity Fall 2010 Dr. Gupta.
Development of Strength. Development of strength: development of strength after placing of concrete. Curing: It is the procedures used for promoting the.
Timber Seasoning.
Course No: CE 4000 INVESTIGATION ON THE PERFORMANCE OF BAMBOO REINFORCED CONCRETE BEAMS Supervised By: MUHAMMAD HARUNUR RASHID Presented By: MOHAMMAD TAREQ.
EWHA WOMANS UNIVERSITY ARCHITECTURAL STRUCTURE LABORATORY Investigation of Rehabilitation Effects on Fire Damaged High Strength Concrete Beams Eun Mi Ryu.
Cold-Weather Concreting. Cold Weather When air temp. is at or below 5°C or when there is a probability of it falling below 5°C within 24 hours of placing.
Moisture impact on building rocks - the laboratory and in situ investigations FIDRÍKOVÁ D., KUBIČÁR Ľ. Institute of Physics SAS, Bratislava, Slovakia The.
Chapter 5 Construction Mortar.
Table 1 Parameters of length ratio (length to initial length) variation model for beans during drying (L/L 0 = A + B MR) L:D ratio A B R 2 1:
§4.4.6 Influencing factors Strength grade of cement W/C
Capitalizing on Self-Desiccation for Autogenous Distribution of Chemical Admixtures Dale P. Bentz 4 th International Seminar on Self- Desiccation in Concrete.
There are three important definitions about strength  Cubic compressive strength of concrete  Assurance factor of concrete  Standard cubic compressive.
Ultrasonic Pulse Velocity
Estimation of the heat evolution during the hydration of concrete, mix design of hot concrete, drying and coating of concrete structures Exercise 6.
Design of Concrete Structure I Dr. Ali Tayeh First Semester 2009 Dr. Ali Tayeh First Semester 2009.
Strength grade of cement W/C Strength formula of the concrete Factors of aggregate Curing condition Testing condition §4.4.6 Influencing factors.
Sampling and Testing Concrete Mixes MATERIAL TESTING LABORATORY
NIST self-desiccation seminar June 20, 2005 L-O Nilsson A MACRO-MODEL FOR SELF-DESICCATION IN HPC A MACRO-MODEL FOR SELF-DESICCATION IN HIGH PERFORMANCE.
Washington DC Climate Analysis Weather Data Summary.
LECTURE NOTES-CHAPTER 8 CURING OF CONCRETE
Drying of concrete Exercise 10. Evaporation of water from K30 concrete Evaporated water kg/m 3.
Estimation of service life-span of concrete structures
PREPARED BY: MARCIA C. BELCHER CONSTRUCTION ENGINEERING TECHNOLOGY Concrete: Fundamentals.
Pouring concrete is a difficult thing to do correctly. It must have the correct heat distribution to dry. This allows the water to bleed out at the correct.
Concept of Humidity What is the relationship between water vapor holding and temperature? Air hold more water vapour at higher temperature.
Surfaces Task Task 1Task 2Task 3Task 4 Task 5Task 6Task 7Task 8 Task 9 NC Level 6 to 8+
1.4 UNDERSTANDING MEASUREMENTS.  Determination of the actual value for particular physical quantity.
Volume Changes of Concrete Design and Control of Concrete Mixtures – Chapter 10.
Use of Models to Teach the Behavior of Structural Concrete Some Model Slides Courtesy of James Hanson, PhD, PE Rose-Hulman Institute of Technology
Drying Shrinkage Presentation By Savita Goel May 17, 2002.
Team Members: Paul Lucas Mircea Bec Khoi Nguyen Thong Truong Meshari Al Ebrahim Asgedom Gebrehiwot PSU Faculty Advisor Dr. Faryar Etesami Boeing Industry.
A Partnership in Research and Outreach David A. Lange, CEAT Director Department of Civil and Environmental Engineering Chang Joon Lee, Robert Rodden, Yi-Shi.
ASTM Committee F06 F2170 In-situ RH Test Depth Study on Metal Decking (Round II) F2170 Probe Insertion Study Study Location: American Engineering Testing.
Москва, 2013 в Calcium nitrate as Antifreeze Admixture in Concrete.
Curing Definition The process of prevention of loss of moisture from fresh concrete while maintaining satisfactory temperature regime (BS 8110) Fig: The.
Experimental Comparison among the Psychrometer and the Two-Pressure Humidity Generator and the Dew Point Hygrometer Speaker: Jinpeng Fan Authors: Xueli.
Moisture Diffusion and Long-term Deformation of Concrete
Experimental Centre, Faculty of Civil Engineering, CTU in Prague, Ondřej HOLČAPEK, Pavel REITERMAN, Marcel JOGL and Petr KONVALINKA.
What is the volume of a hula hoop?
Master Thesis Presentation – Bart Festen
C Engström Ph.D. candidate, T Hall Ph.D. candidate, A Sjöberg Ph.D.
Wel-come.
Comparison of heat loss with a wetsuit vs. without
11.2 State of the Atmosphere
What is climate? TIME How does climate differ from weather?
Influence of properties of coarse aggregate
Maximum Size of Aggregate
FDM (Fused Deposition Modeling)
Presentation transcript:

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Experimental setup: l 250 mm “thick” cylinders, diameter 150 mm l Curing temperatures l Relative humidity, RH at a depth of 20% of the slab thickness l Weight

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Parameters: l Water-cement ratio, 0.38, 0.43 and 0.55 l Sealed or water curing at 8°C, 20°C and 30°C, 1st month l 20°C 60 % RH after 1 month, some exposed to wind, some sealed l RH measured at 1, 1½, 2, 3 and 6 months

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Effect of maturity on strength:

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Temperature effect on self-desiccation: averages of three values

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Self-desiccation vs. strength :

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Effect of w/c and water curing on drying: Sealed 28d. at +30C, then dried 28d. at 60 % RH Sealed 21d. at +30C, 7d. in water, then dried 28d. at 60 % RH Sealed 28d. at +30C

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Effect of wind on drying, various w/c: Sealed 28d. at +20C, then dried 28d. at 60 % RH

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Effect of w/c and temperature on drying: +8°C +30°C Sealed 28d. at: (then dried 28d. at +20°60%RH)

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE RH of concrete with w/c = 0.38: Age (days) In water +30°C +8°C dried sealed +20°C Sealed

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE RH of concrete with w/c = 0.43: Age (days) +8°C +30°C sealed In water dried sealed dried +20°C Sealed

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE RH of concrete with w/c = 0.55: Age (days) In water wind +20°C Sealed +8°C +30°C

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Summary and conclusions, 1 : l 27 specimens 150 mm in diameter, 250 mm in length with w/c = 0.38, 0.43, l Effects of heating, sealing, water and wind l 28-day strength 20% higher after curing at 8 °C compared to 30 °C. l Self-desiccation was more pronounced after curing at 8 °C than at 30 °C, at the same age! 1 week of water curing gave 4% higher RH for low w/c =0.38 and for w/c =0.55.

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE Summary and conclusions, 2 : l Wind of 4 m/s had no influence on the drying, except possibly some for w/c =0.55. l The maturity concept could not be applied to strength or to self-desiccation. l Probable explanation: Micro & p ore structure at low temperature curing became finer.

B Persson, LTH Building Materials, University of Lund, Lund, Sweden ON THE TEMPERATURE EFFECT ON SELF-DESICCATION OF CONCRETE T1T1 T cur <T 1 wnwn  RH