1 Module 3 Toxicity. 2 Toxicity Measures The term Ct is used to describe an estimate of dose. C represents the concentration of the substance (as vapor.

Slides:



Advertisements
Similar presentations
MATERIAL SAFETY DATA SHEET
Advertisements

Sulfur Mustard (Mustard Gas)
Toxicologia para emergências Carlos André Vaz Junior HAZMAT.
UMES Presented by Environmental Health and Safety Preston Cottman (410) Hazardous Material Spill Response Training.
1 Module 2 Potential Exposure Routes and Hazards.
Chemical Safety. Overview Chemical hazard classes Communication of hazards Routes of exposure Hierarchy of controls Special laboratory hazards.
Sandia National Laboratories is a multi-program laboratory managed and operated by Sandia Corporation, a wholly owned subsidiary of Lockheed Martin Corporation,
Health Hazards The overall objective for this module is that given a Material Safety Data Sheet (MSDS), the participant will interpret health hazard information.
An adverse effect on a living creature that results from a single dose or exposure to a substance. What is an Acute Effect.
NON-LETHAL CHEMICAL AGENTS
1 Chapter 1 Measurements 1.6 Writing Conversion Factors Copyright © 2009 by Pearson Education, Inc.
Material Safety Data Sheets (MSDS)
STANDARDS FOR EXPOSURE TO AIRBORNE CONTAMINANTS
© 1999 Lockheed Martin Energy Research Corporation CA57 WHAT IS AN ACCIDENT.
Impact Area 1-hour standards. SILs used to determine when a proposed source’s ambient impacts warrant a comprehensive (cumulative) source impact analysis.
Chemical Handling/Hazards All Chemicals Are Hazardous PDO has 785 chemicals Rejected 22 Carcinogens 7 (e.g, Benzene, Crystalline Silica, Asbestos) A cigarette.
Unit 3: Potential Chemical Exposure During Two-Component
RISK Targets: 1. Explain risk, toxicology, toxins and factors that affect chemical risks. 2. Explain how toxicity is measured and methods of determining.
Toxicity Evaluation of Chemicals with Limited Toxicity Data Roberta L. Grant, Ph.D. Toxicology Division - Chief Engineer’s Office Texas Commission on Environmental.
Safety 5120Industrial Hygiene Threshold Limit Values (TLVs) TLV ® Definition concentrations … which it is airborne concentrations … which it is believed.
Chapter 17 Human Health and Environmental Risks. What is Risk? Risk: possibility of suffering harm from a hazard.
Toxicology and Industrial Hygiene The chemical engineers must be knowledgeable about The way toxicants enter biological organisms (T); The ways toxicants.
C HEMICAL T OXICOLOGY 2010 Safety Manual & Laboratory Safety Chemical Hygiene Plan, p M AY 17, 2011.
Air Quality in Emergency Response Worker Health Considerations Sacramento, CA October 16, 2008 Rupali Das, MD, MPH Occupational Health Branch Division.
Chapter 15 Environmental Health, Pollution and Toxicology.
Chapter 15 Environmental Health, Pollution and Toxicology.
TOXICOLOGY Trina Redford, Industrial Hygienist National Naval Medical Center Naval Business Bldg 615, 2 nd Fl. Philadelphia, PA.
Health Hazards Instructional Goal
WHAT IS WHMIS?? A Canadian-wide Information System
A Review of Exposure and Toxicity. The Need for Gloves and Respirators A Brief Review of Exposure.
CLASSES OF CHEMICALS Toxic Chemicals Reactive Chemicals Flammables
Tier 1 Environmental Performance Tools Economic Criteria.
Nerve agent VX Eva Magulová Crisis management and protection of inhabitants 2007.
Chemistry: An Introduction to General, Organic, and Biological Chemistry, Eleventh Edition Copyright © 2012 by Pearson Education, Inc. Chapter 1 Chemistry.
Nerve Agents.
W507 – Introduction to toxicology
HF Safety.
Pollution and Human Health
Consequence Analysis Dr. AA Department of Chemical Engineering University Teknology Malaysia.
CBR Detection, Decontamination and Information Systems Branch 1 Issues with Use of Toxicity Values For Emergency Response by Timothy Bauer Naval Surface.
Chapter 17 Hazards and Risks. Questions for Today What is Risk and how do we handle Risk? What is a Hazard? What is Toxicology? What affects Toxicity?
Acceptable Exposure Limits …extrapolation of toxicological data to recommendations for limits for occupational exposures.
1 Chemical and Biological Agents. 2 Introduction  Most occupational diseases such as asbestosis, silicosis, various types of dermatitis, spills, and.
Chapter 15.3 Risk Assessment 2002 WHO report: “Focusing on risks to health is the key to preventing disease and injury.” risk assessment—process of evaluating.
Misuse of Exposure Reporting in Acute Risk Assessment John S. Morawetz International Chemical Workers Union Council/UFCW Center for Worker Health & Safety.
Unit 3 – Environmental Chemistry.  A pollutant is any material or energy that can cause harm to a living thing.  Pollution is a change to the environment.
EHS 507 Potential dose: the amount of chemical that is ingested or inhaled, or the amount of chemical contained in material applied to skin. Applied dose:
George M. Woodall, PhD NCEA Toxicologist Leland Urban Air Toxics Research Center October 18, 2005 EPA Reference Values: Regulatory Context.
TOXICOLOGY OCCUPATIONAL HAZARDS CHEMICAL PHYSICAL ERGONOMIC PSYCHOLOGIC BIOLOGIC.
PRINCIPLES OF TOXICOLOGY...a discussion of the fundamental means by which toxicological properties are determined.
RISK DUE TO AIR POLLUTANTS
TOXICOLOGY The study of chemical or physical agents and their interaction with biologic systems to produce a response in a organism. The dose makes the.
 Hazardous substances are those that, following worker exposure, can have an adverse effect on health. Examples of hazardous substances include poisons,
Chapter 17 Human Health and Environmental Risks
Chapter 6 Dose and Response. Chapter 6 Dose and Response.
Conventional sugar beet
Chemical-warfare Agents: An Overview
HYGIENE STANDARDS AND OCCUPATIONAL EXPOSURE LIMITS
Benzene.
Respirator Terminology
THE DOSE MAKES THE POISON
Environmental Toxicology
Chapter 17 Human Health and Environmental Risks
HEALTH EFFECTS Opening Slide.
Topic 4: How Much is Too Much?
Assigning Hazard Ratings
Pollution and Human Health
Material Safety Data Sheets (MSDS)
TOXICOLOGY.
Risk, Toxicology, and Human Health
Presentation transcript:

1 Module 3 Toxicity

2 Toxicity Measures The term Ct is used to describe an estimate of dose. C represents the concentration of the substance (as vapor or aerosol) in air (usually expressed as mg/m 3 ) and t represents time (usually expressed in minutes). The t value is the product of the concentration (C) to which an organism is exposed multiplied by the time(t) during which it remains exposed to that concentration. Ct does not express the amount retained within an organism; thus, it is not an inhalational dose. The term LCt 50 is often used to denote the vapor or aerosol exposure (Ct) necessary to cause death in 50% of the population exposed (L denotes lethal, and 50 denotes 50% of the population). The term LD 50 is used to denote the dose that is lethal for 50% of the population exposed by other routes of exposure (liquid,solid).

3 Toxicity Values for Nerve Agents LD 50 of VX is 5 milligrams/70-kg human (liquid on skin) LCt 50 of VX is 15 milligrams-min/m 3 (vapor inhalation) LD 50 of GB is 1.7 grams/70-kg human (liquid on skin) LCt 50 of GB is 35 milligrams-min/m 3 (vapor inhalation) 1 kilogram (kg) = pounds

4 VX Liquid Exposure An potentially lethal exposure is a drop about the size of the Lincoln Statue in the center of the Lincoln Memorial on the back of a penny

5 Toxicity Values for Sulfur Mustard Agent LD 50 (liquid on skin) is 1.4g/70-kg human Between 4 and 32 micrograms/70-kg man can cause blistering LCt 50 is 1000 mg-min/m 3

6 Acute Exposure Guidelines (AEGLs)

7 AEGLs Concentration of a chemical in air, above which, specific categories of health effects could begin to occur in an unprotected civilian population. AEGLs are expressed as the concentration of a chemical an individual is exposed to over a given period of time.

8 AEGLs Represent threshold exposure limits Three levels - 1, 2, and 3 Based on 5 reference times from 10 minutes to 8 hours Used to trigger emergency actions including event notification and protective action decisions

9 Five Exposure Periods 10 minutes 30 minutes 1 hour 4 hours 8 hours

10 AEGL-1 AEGL-1 is the airborne concentration (expressed as ppm or mg/m3) of a substance at or above which it is predicted that the general population, including susceptible individuals, could experience notable discomfort, irritation, or certain subclinical, non-sensory effects. However, the effects are not disabling and are transient and reversible upon cessation or exposure May trigger a precautionary alert

11 AEGL-2 AEGL-2 is the airborne concentration (expressed as ppm or mg/m 3 ) of a substance at or above which it is predicted that the general population, including susceptible individuals, could experience irreversible or other serious, long-lasting effects or impaired ability to escape. Exposed people need to evacuate or shelter-in-place above AEGL-2. May become a mass casualty event.

12 AEGL-3 AEGL-3 is the airborne concentration (expressed as ppm or mg/m 3 ) of a substance at or above which it is predicted that the general population, including susceptible individuals, could experience life-threatening effects or death. People must not be exposed to these levels. This is likely a mass casualty event.

13 AEGL Summary Significant adverse effects No significant adverse effects Severe adverse effects No adverse effects Above AEGL-3 effects become increasingly severe and could be fatal. Above AEGL-2 effects become increasingly more significant, and may cause impairment, be longer lasting, or permanent. Above AEGL-1 there may be some discomfort, odor, or irritation. Effects, if any, are not impairing and only temporary. AEGL-1 AEGL-2 AEGL-3 No Exposure

14 AEGL Values for GB

15 Comparison of AEGLs CTs for HD and GB