T ubular D aylight G uidance S ystems : building codes and the environment Mohammed Al-Marwaee and David Carter School of Architecture University of Liverpool.

Slides:



Advertisements
Similar presentations
Background Australia has always had bushfires
Advertisements

Construction Method, Material Selection & Building Services
Dr. Ruth Collins TrinityHaus
Portal Framed Construction
Fire-Resistive Construction (2nd part)
Sustainable Lighting Strategies
East Bridgford Project Existing Projects The Green Box Project Adaptation Techniques used within this project:- Natural ventilation is increased by a passive.
A passive investment towards improved control over energy costs.
Summary of NFPA 101 Interior Finish Requirements
BRE: The Fire Performance of Building Envelopes
The Three Tiered Philosophy
Chapter 5: Designing for Heating and Cooling 5.1 Organizing the problem a) Fenestration How much is optimum for the building? What should the form of the.
Standardization in the Green Buildings field Overall energy performance of buildings Dick (H.A.L.) van Dijk, Senior Scientist at Netherlands Organisation.
Radiant Barrier. Problem (Summer Conditions): Solar radiation causes roof temperatures to reach 160 to 190 degrees Fahrenheit. Heat is conducted through.
1 ISAT Module III: Building Energy Efficiency Topic 6:Stead-State Building Loads z Fabric Loss z Ventilation Loss z Environmental Temperature z Steady-State.
Aperture Placement & Area. Aperture Refers to any daylight source – Windows – Skylights – Openings – Transparent or translucent surfaces Placement and.
Joint FP5 ENERGIE Info-day and EnerBuild RTD Project Meeting JAPANESE BUILDING ENERGY RESEACH 7 September 2001, Malmo Ken-ichi Kimura Professor, Advanced.
Enclosure Fire Dynamics
Won’t count Won’t count Another quiz, in two weeks Another quiz, in two weeks The Quiz.
BAE SYSTEMS DESIGN PROJECT: DAYLIGHTING TECHNIQUES/ AFTERNOON DE-”LIGHT” EDSGN 100 Sec. 6 Team 3: David Young, Robert Vadella, Victoria Rodriguez, Phil.
Presented by Edgar Furtado & David Vella FIREPLACE & FLUE REPLACEMENTS 1359 WHITE OAKS BLVD., OAKVILLE.
Best Practices in Energy Efficiency and Renewable Energy in Commercial Buildings EGNRET 28 January 2007.
Concept of Energy Efficiency. Buildings, as they are designed and used, contribute to serious environmental problems because of excessive consumption.
Chapter 22 Selecting Interior Finishes
Conservation and Environmental Design and Construction
Fire-Related Properties of Materials Chapter 7. Mehta, Scarborough, and Armpriest : Building Construction: Principles, Materials, and Systems © 2008 Pearson.
Energy efficiency in buildings Monga Mehlwana Tuesday, 05 October 2010.
CONSTRUCTION Objective You will need to write all the information down but you need to highlight, mark, or note that the items in yellow are important.
The EWZ building Presentation of the building Presentation of the building The design issue The design issue The building concept The building concept.
Prof. Kyriakos Papaioannou ARISTOTLE UNIVERSITY GREECE 7th Intern. Sprinkler Conference-Copenhagen 24-25/6/
Wales Building Regulations 2013 Part L Existing non-domestic buildings September 2012.
The Energy Impact of Daylighting and Your Impact on Building Design Jon McHugh, MSME Heschong Mahone Group ASHRAE/AIA Meeting April 20, 1999.
Kim Hockley 1 TOTAL SA – ENERGY EFFICIENT STATION TOTAL 14 TH AVENUE.
Engineering Analysis of NFPA 285 Tested Assemblies
Picking up from last week…. Fire stair layout Fire stair layout Due October 18 th Due October 18 th Assignment #1.
Chapter 2 Lighting Environments Daylight Integration and Control Advantages of daylight and windows: –Psychological & biological well-being –Constant.
Energy Design of Buildings using Thermal Mass Cement Association of Canada July 2006.
SELECTING INSULATION MATERIALS  Insulation can serve as more than just an energy barrier, providing fire resistance, humidity control, and noise reduction.
Fire-Resistant Materials & Assemblies Part 2 Chapter 5.
QuickWalls® strong. fast. simple. *Light Weight *Insulated
Name ________________ Unit 6/P7 – Environmental Implications (what do developers need to take into account when building) Noise Nearby Residents Hours.
Chapter 7 : Construction 1. Adobe – a mixture of clay and straw used as a structural material in the Southwestern United States.
Chapter 24 Chimneys and Fireplaces Copyright Goodheart-Willcox Co., Inc. May not be posted to a publicly accessible website. Explain how masonry chimneys.
Sustainable Design. Sustainable What does it mean to be sustainable? ◦Of, relating to, or being a method of harvesting or using a resource so that the.
Sprinkler Loads on Trusses
Sprinkler Loads on Trusses Educational Presentation.
UNIT 5 BRICK MASONRY.
Contract: EIE/07/069/SI Duration: October 2007 – March 2010 Calculation of the integrated energy performance of buildings EN 15316: Heating systems.
Fundamental Concepts for Design of Special Hazard and Fire Alarm Systems Chapter 1.
Building Construction
CLIMATE CHANGE –AN ISSUE & ITS CHALLENGES. WeatherClimate Time ( Atmospheric condition of a place ) {For long period} {For short period} [element :- temperature,
土木工程概论 Introduction to Civil Engineering 第四章 建筑工程 Chapter 4 Building Engineering.
Architecture Supported by:
Code of Practice for Fire Safety in New and Existing Community Dwelling Houses Eamon O’ Boyle.
Building Environmental Systems
PASSIVE SOLAR DESIGN ALTERNATIVE ENEGRY SOURCES.
Prepared by Frank Cooney B.Arch MRIA
Pre-Contract Cost Control
GES SYSTEM THE IMPORTANCE OF GES SYSTEM IN BUILDING
Building Construction
REVISION REVISION & EXAM PREPARATION 3 CLADDING 1.
Effect of Earthquake on Fire Protection Systems
Concept of Energy Efficiency
Arch205 building construction Introduction
Assessment of the Energy Savings Potential of Daylight Utilization and its Impact on a Building Energy Performance Hermano Bernardo Vienna, 2010.
UNIT-V ELEMENT OF BUILDINGS.
Masonry Bearing Walls.
Arch205 Materials and building construction I
AIRCRAFT FIRE REGULATIONS
Wind energy & EU legislation for Nature conservation
Presentation transcript:

T ubular D aylight G uidance S ystems : building codes and the environment Mohammed Al-Marwaee and David Carter School of Architecture University of Liverpool

Daylight guidance systems (DGS) Tubular guidance systems redirect daylight into areas of buildings that cannot be lit by conventional glazing.

Tubular daylight guidance technology 1. Active collectors These track the movement of the sun using mirrors and lenses (heliostats), but incur a high capital and control cost. 2. Passive collectors These are essentially vertical tubes capped by a light collector, and are commonly used for task and amenity lighting.

Passive zenithal

Passive zenithal collector

Light guides Guides made of aluminium sheet coated with either silver (95% RF) of multilayer plastic (99% RF) Straights and bends available

Passive zenithal emitter

Passive zenithal emitter (2) Fits 600mm ceiling module

Building codes regulation Structural stability Stability and integrity under wind & dead loads Fire protection To prevent fire spread over surfaces, fire and smoke spread within and between buildings, and ensure fire separation within and between adjoining buildings Materials durability and weatherproofing Ensure durability of materials in long term use. Stability of materials under prevailing climatic conditions Thermal considerations To conserve energy by minimising heat loss and gain Lighting issues Most regulations refer to electric lighting but most Codes encourage the use of daylight

Building codes - Structural stability Few structural implications for TDGS Heliostats require additional structural work to account for wind and dead loads Transport elements have small dead load but must not conflict with structural beams etc

Building codes - Fire protection Regulations for fire protection are based on similar principles worldwide Prevent and fire and smoke spread within buildings using fire compartments Prevent fire spread over surfaces by using non -combustible materials Fire separation between adjoining buildings

Fire and smoke within buildings and TDGS Both vertical and horizontal transport components of TDGS may pass through compartment enclosures Fire protected ducts or cladding used for vertical routing through compartments in multi-storey buildings TDGS must be fire-stopped whenever they penetrate fire-resisting walls, floors and ceilings using fire dampers

Fire and smoke between buildings and TDGS Spread of fire between buildings is controlled by limiting the area of unprotected building envelope glazing aperture The optical efficiency of TDGS compared with conventional roof lights can have a beneficial effect of limiting unprotected roof aperture TDGS present no greater risk of internal surface spread of flame than electric lighting luminaires being made of similar materials Majority of TDGS are in single storey buildings - that is into one compartment and most codes allow penetration of the building envelope alone

Lighting and TDGS TDGS can be used to provide daylight into areas of buildings far from the building envelope TDGS are capable of delivering useful quantities of daylight dependant on the configuration of the interior and the lighting system and its controls – up to 2% Daylight Factor There is a need for daylight linked electric lighting to permit substitution by daylight

The environment and ‘climate change’ ‘ Climate change ’ is a major crisis facing mankind Attempts to address the problem have concentrated on reduction of greenhouse gases, notably CO 2, by reducing emissions The largest consumers of energy in most countries are within the building stock Daylight can reduce the environmental impact of lighting by acting as a Lighting is a major consumer of energy substitute for electric light Daylight is more efficient than electric light, its efficacy being of the order of ten times more than that of an incandescent lamp and therefore can lower the cooling requirements of a building

Building Codes and CO 2 Energy usage and CO 2 emission is the main criteria for satisfying the energy-related parts of European Building Codes Assessment is carried out using software from input of a description of the building geometry, construction, use and HVAC and lighting equipment The provision or otherwise of daylight within a building is a major part of the assessment procedure Work by the authors suggests that buildings that would not otherwise gain Building Code approval would do so with the addition of light guides

Case studies of installations 1- University building Top floor of existing three storey building. Penetrates roof only Small unprotected roof area Provides insufficient daylight for tasks Electric lighting not daylight linked Daylight linked TDGS reduces the annual CO2 emissions by 20.7 mT. (85 %).

2- Office Two storey office 12m guides in roof space require support Conflict with other services in roof Guides not fire protected Makes substantial contribution to task illuminance TDGS will, assuming daylight linking, reduce annual CO2 emissions by 1.2 mT. (41 %).

3- School Purpose built two storey Guides to upper floor penetrate only roof Guides to lower floor in brick vertical duct Not enough guides to provide sufficient task illuminance TDGS will, assuming daylight linking, reduce annual CO2 emissions by 1.1 mT. (61 %).

4 - Villa Fida Three-storey villa in Riyadh, Saudi Arabia.Most of the guides installed in the basement Collectors in garden rather than the roof and integrated into landscape and at night the guides transport internal lighting to the garden TDGS will, assuming daylight linking, reduce annual CO2 emissions by 1.1 mT. (41 %)

4600sqm warehouse lit using 105No 650mm dia guides

A daylit cave!

Conclusions Codes do not specifically refer to TDGS. Codes treat collectors as rooflights, transport elements as pipes or ducts, and emitters as luminaires. Still need for new products- eg. Low optical loss for protection at compartment walls and prefabricated fire resistant cladding. The technical development of system components has arguably outstripped consideration of practical issues of detailing and buildability.