Introduction Relative weights can be estimated by fitting a linear model using responses from individual trials: where g is the linking function. Relative weights are derived from the linear coefficients,  j. Here we ask whether, for psychophysical data, different regression models vary in terms of (a) efficiency [standard errors of the estimates], (b) bias [accuracy relative to true solution] of the estimated  s. Only no-signal stimuli are analyzed. Models Probit – g is a cumulative normal Logit – g is a cumulative logistic Linear – g is the identity function (i.e., linear model) Correlation coefficient – The correlation is between each stimulus magnitude (x ij ) and response (y i ). Linear Classification (Ahumada, 2002) – No- signal stimuli are averaged conditional on responses, the difference is an estimate of the decision “template.” To provide comparisons across methods, the coefficients are normalized: Conclusions – The magnitudes of the standard errors of the estimates are approximately equal for the correlation and linear classification models, and for the logit and probit regression models. – Across methods, the standard errors of the estimates are large relative to differences in the estimated coefficients. – These results suggest little advantage, with regard to efficiency and bias, of one model over another when fitting psychophysical data. Citations Ahumada, J. A. Jr. (2002). “Classification image weights and internal noise level estimation,” J. Vision, 2, Berg, B. G. and Green, D. M. (1990). “Spectral weights in profile listening,” J. Acoust. Soc. Am., 88, Acknowledgements This work was supported by grant DC from the National Institutes of Health. 5aPP3. Comparing linear regression models applied to psychophysical data. Zhongzhou Tang 1, Andrew Shih 2 and Virginia M. Richards 1 1 Department of Psychology, 2 Deparment of Bioengineering, University of Pennsylvania Spectrum Level Frequency Standard Standard + Signal Figure 1 Experiment I: Profile Analysis Figure 1 shows example stimuli. Methods -- 3 Listeners-- Yes/No -- Feedback-- Perturbation Results Thresholds are consistent with those reported by Berg (1990). Figure 2 shows the relative weights for three observers by the logit (blue) and correlation (red) models. The results for the other models are similar. Error bars are twice the standard errors of relative weights. Frequency (Hz) Relative Weights Figure 2 Figure 3 shows the standard errors of relative weight as a function of the number of trials used to estimate the relative weight. For L1 and L2 the standard errors tend to fall with number of trials; for L3 that result is less obvious. Number of trials Figure 3 Experiment II: Coherence Detection Listeners detect a series of coherent tone pips in a background of random time-by-frequency tone pips (Figure 4). Methods -- 4 Listeners-- Yes/No -- Feedback-- Target Frequency: 1 kHz Frequency Time Figure 4 Frequency (Hz) Time (ms) Figure L4 L5 L6 L7 Number of trials Figure 6. Results Figure 5 shows the statistically significant relative weights. White indicates positive weights, black negative weights. These weights are from a logit model applied to no- signal trials (all observers). Exp II: Results (cont.) Figure 6 shows the average standard errors of relative weights as a function of the number of trials for logit (blue) and correlation (red) models. Note: standard errors do not fall with number of trials. Different models yield very similar estimates of relative weights. Average Standard Errors of Relative Weights Standard Interval Signal Interval Average Standard Errors of Relative Weights