1. Introduction to ANSYS 5.7 Part 1 Workshop Supplement

2. Inventory Number: 001442 First Edition ANSYS Release: 5.7 Published Date: January 30, 2001 Registered Trademarks: ANSYS ® is a registered trademark of SAS IP Inc. All other product names mentioned in this manual are trademarks or registered trademarks of their respective manufacturers. Disclaimer Notice: This document has been reviewed and approved in accordance with the ANSYS, Inc. Documentation Review and Approval Procedures. “This ANSYS Inc. software product (the Program) and program documentation (Documentation) are furnished by ANSYS, Inc. under an ANSYS Software License Agreement that contains provisions concerning non-disclosure, copying, length and nature of use, warranties, disclaimers and remedies, and other provisions. The Program and Documentation may be used or copied only in accordance with the terms of that License Agreement.” Copyright © 2001 SAS IP, Inc. Proprietary data. Unauthorized use, distribution, or duplication is prohibited. All Rights Reserved. Workshop Supplement Introduction to ANSYS 5.7 - Part 1

3. Workshop Supplement January 30, 2001 Inventory #001442 TOC-3 Table of Contents 1.ANSYS Basics Introductory WorkshopW1-1 2.Stress Analysis A.Lathe CutterW2-1 B.2-D Corner Bracket TutorialW2-27 3. Thermal Analysis Axisymmetric Pipe with FinsW3-1 4. Thermal-Stress Analysis Axisymm. Pipe w/ Fins - SequentialW4-1 Axisymm. Pipe w/ Fins - DirectW4-18 5.Importing Geometry A.IGESW5-3 B.SATW5-7 C.SAT AssemblyW5-11 D.ParasolidW5-17 E.Parasolid AssemblyW5-21 6.Solid Modeling: Top-Down Pillow BlockW6-1 7.Solid Modeling: Importation & Clean-up Connecting Rod - Bottom-UpW7-1 Connecting Rod - Import/Clean-upW7-19 8.Meshing A.Pillow BlockW8-1 B.Connecting RodW8-9 C.Cotter PinW8-18 D.WheelW8-25 9.Select Logic A.SiloW9-1 B.Impeller ExtrusionW9-17 10.APDL Basics 2-D Bracket using ParametersW10-1 11.Loading and Solution A.3-D BracketW11-1 B.Connecting RodW11-9 C.WheelW11-17 12.Postprocessing A.Connecting RodW12-1 B.Spherical ShellW12-23 C.Axisymmetric Fin with Multiple Load Steps W12-39 D.Results ViewerW12-59 E.Report GeneratorW12-67 13.Short Topics A.Batch - Plate with Hole at CenterW13-1 B.*ASK - Plate with Hole at CenterW13-7 B.*ABBR - Plate with Hole at CenterW13-13 14.Mechanical Toolbar Pipe ShellW14-1 15.Appendix A Input Files for Workshop ExercisesA-1 * All workshops were run and verified using the first release of ANSYS 5.7