1. AS Computing Data transmission

2. Basic data transmission Baud The rate that the voltage changes is called the Baud. If the voltage changes 10 times every second the baud is said to be 10. This does not necessarily mean that a 10-baud and a 600-baud modem transmit 10 and 600 bits per second. Bit rate Bits per second is a measure of the number of data bits (digital 0's and 1's) transmitted each second in a communications channel.

4. Communications channels

5. Simplex Data transmission  Simplex communication is a mode in which data only flows in one direction.  One current usage of simplex communications in business involves certain point-of-sale terminals in which sales data is entered without a corresponding reply.

6. Half Duplex Transmission  Half-duplex communication adds an ability for a two-way flow of data between computer terminals.  In this directional mode, data travels in two directions, but not simultaneously.  Data can only move in one direction when data is not being received from the other direction.  This mode is commonly used for linking computers together over telephone lines.

7. Half Duplex Transmission

8. Duplex data transmission  The fastest directional mode of communication is full-duplex communication.  Data is transmitted in both directions simultaneously on the same channel.  Full-duplex communication is made possible by devices called multiplexers.  Full-duplex communication is primarily limited to mainframe computers because of the expensive hardware required to support this directional mode.

9. Serial data transmission  Serial data transmission is the simplest, most economical, and easiest method of transferring digital information from one point to another;  The digital data is sent one bit at a time, this means only one pair of transmission wires is required.

10. Serial Data Transmission Two types of transmission: asynchronous: transmitter and receiver clocks are independent synchronous: transmitter and receiver are synchronized

11. Parallel data transmission  A data transmission method in which all the bits in a character are transmitted simultaneously on separate channels  If there is eight bits sent at a time, this will require 8 wires, one for each data bit.  Parallel transmission is obviously faster than serial, because more than one bit is sent at a time.  Parallel transmission is good only for short distances.

12. Asynchronous transmission  Asynchronous systems send data bytes between the sender and receiver by packaging the data in a frame  One start bit – one or more stop bits  The transmitter and receiver must be preset in advance to an agreed-upon baud rate  Cheap but inefficient – large overhead (20% or more)  Relatively low data rates  Uses: suitable for data transmitted at random intervals (e.g. keyboard to computer) used in the great majority of dial-up connections

13. For the most common serial protocol, data is sent in small packets of 10 or 11 bits, eight of which constitute message information. When the channel is idle, the signal voltage corresponds to a continuous logic '1'. A data packet always begins with a logic '0' (the start bit) to signal the receiver that a transmission is starting. Following the start bit, eight bits of message data are sent bit by bit at the agreed upon baud rate. The packet is concluded with a parity bit and stop bit. Asynchronous transmission

15. Synchronous transmission  Arrival time of each bit is predictable  To prevent timing drift the receiver and transmitter clock are synchronized  Clock signal transmitted either: over a separate line or encoded into the data (Manchester, differential Manchester encoding) to allow a single line for both data and clock

16. Exercise