Presentation is loading. Please wait.

Presentation is loading. Please wait.

CDMA System Basis.

Similar presentations


Presentation on theme: "CDMA System Basis."— Presentation transcript:

1 CDMA System Basis

2 Features of Wireless Telecomm
Individually Bad propagation environment Co-channel, Adjacent channel interference and near-far effect. Contradiction between limited frequency resource and vast numbers of subscribers. Complicated network and control equipment are required.

3 Classification of Wireless Telecomm

4

5 Frequency Reuse

6 Evolution of Wireless Telecomm

7 Makeup of Wireless Telecomm
BSS MS: Mobile Station BSS: Base Station System BTS: Base-station Transceiver System BSC: Base_Station Controller MSC:Mobile-service Switching Center VLR:Visiting Location Register HLR:Home Location Register PSTN: ISDN: MS BTS BTS BSC VLR BTS MS HLR MSC PSTN MS ISDN BTS BSC BTS BTS MS Um Abis A MSC

8 Spectrum Spreading Technique
Theoretical Basis is Shanon equation C=B*log2(1+S/N) DSSS applied in CDMA Used in military communication in 1950’s and 1960’s Qualcomm company successfully put it into commercially cellular wireless telecommunication by the end of 1980’s

9 Signal processing by DSSS

10 Features of CDMA System(1)
Large capacity 8~10 times of analog system High-quality service 8Kb/s QCELP EQUALS 13Kb/s of GSM; 13Kb/s QCELP EQUALS 64kb/s of wireline Soft handoff lowers call drop rate RAKE receiving overcomes multi-path fading Good secrecy

11 Features of CDMA System (2)
Soft capacity MS’s averaging transmission power is lowered, decreasing radiation to human body and environment . Be named as “Green Handset” Easy to realize dual-mode operation System complexity increased

12 Key techniques of CDMA (1)
Diversity receiving Time diversity——interleaving, error-detection and correction Frequency diversity——inherent feature of wideband communication Space diversity——multiple antenna receiving, RAKE receiving, soft handoff

13 Key techniques of CDMA (2)
Precise power control Open loop power control on reverse link Closed loop power control on reverse link Outer loop power control on reverse link Power control on forward link

14 Key techniques of CDMA (3)
Rate variable codec (QCELP) VOICE Detection (VOD) Synchronization Mobile assisted soft handoff

15 Key techniques of CDMA (4)
Blossoming & Wilting Low Eb/No and high redundant error correction encoding Multiple access:long PN code, short PN code and WALSH orthogonal code

16 Channel structure Forward Channels Piloting channel Reverse Channels
Synchronizing channel Paging channel Traffic channel Reverse Channels Access channel

17

18 IS-95A Channel Modulation--Forward Link

19 Procedure of MS’s COMMUNICATION
Searching base station’s pilot channel Demodulating synchronizing channel MS requests on access channel BS responds on paging channel Traffic channel is assigned for communication

20 MS idle status System access status MS Initial Status
Power On MS Initial Status MS idle status System access status MS in traffic Channel MS fully catches System timing MS paged, originating or registering MS idle changeover when NGHBR_CONFIG is”011” Access channel confirmation End traffic channel Indication of traffic channel Task Initialization Start analog mode End analog mode Notes:not all are listed out

21 ZXC10-BSS System structure-BSC
BSC: Base_Station Controller BTS: Base-station Transceiver System NCM: Network Control Module HIRS: High-speed Interconnect Router Subsystem CDSU: Channel/Digital Service Unit TCM: Timing Control Module SVM: Selector Vocoder Module SVICM: Selector Vocoder Interface Control Module CPM: Call Process Module OMC: Operation & Maintenance Center

22 ZXC10-BSS System structure-BTS
BTS: Base-station Transceiver System CHM: Channel Processing Module CCM: Communication Control Module HIRS: High-speed Interconnect Router Subsystem TCM: Timing Control Module RFIM: RF Interface Module TRx: Transceiver HPA: High Power Amplifier RFE: RF Front End CDSU: Channel/Digital Service Unit BTM: Base-station Test Module BSC: Base-station Controller

23 ZXC10_BSS System Specification-BSC
Maximal BTS supported: 512 Vocoder:7200 Maximal Channels (including payoff and soft handoff):512 X 32 = 16384 Maximal traffic channels: 512 X 20 = 10240 Maximal subscribers: 102,500* BTS side traffic:2,930 Erl* BHCA:125,000* Traffic:1.28BHCA/subscriber

24 ZXC-10 BSS-transition to 3G
Features: Capacity increased Non-symmetrical data service provided For:64Kb/s Rev:14.4Kb/s Backward compatible with 95A Capacity doubled (relative to 95A) Data service 144Kb/s 307.2Kb/s(max) Backward compatible with 95A/B Data service 384Kb/s 2Mb/s(max) Backward compatible with 95A/B/1X


Download ppt "CDMA System Basis."

Similar presentations


Ads by Google