Presentation is loading. Please wait.

Presentation is loading. Please wait.

防水型 6692 GPS/GSM Waterproof ： IP-68 Frequency : GSM 824-960MHz 1710-2170MHz 1710-2170MHz Impedance : 50 ohms VSWR : < 3.0 Gain : 2 dBi Frequency : GPS.

Published byConstance Cain Modified over 8 years ago

Similar presentations

Presentation on theme: "防水型 6692 GPS/GSM Waterproof ： IP-68 Frequency : GSM 824-960MHz 1710-2170MHz 1710-2170MHz Impedance : 50 ohms VSWR : < 3.0 Gain : 2 dBi Frequency : GPS."— Presentation transcript:

1 防水型 6692 GPS/GSM Waterproof ： IP-68 Frequency : GSM 824-960MHz 1710-2170MHz 1710-2170MHz Impedance : 50 ohms VSWR : < 3.0 Gain : 2 dBi Frequency : GPS 1575.42 ±3.0 MHz Bandwidth : 9.0 min. (MHz) Gain at Zenith : +5.0 typ. (dBi) Gain at 10° elevation : -1.0 typ. (dBi) Impedance : 50 ohm Frequency Temperature Coefficient : 0 ±20 ppm/ °C Axial Ratio : 3.0 max (dB) Amplifier Specification Voltage : 3.0 V Current : 10 mA LNA Gain : 26 dB Output VSWR : 1.5 dB Noise Figure : 1.4 dB Impedance : 50 ohm Cable : RG-174/U NEW

2 appearance-matte & bright plastic Tenon design- no worry about rusty screw Labeling – GSM & GPS RF Connectors can be placed by customer’s request Better joint between cover and cable to meet IP68

3 GSM 測試圖面， S11 ， VSWR

Download ppt "防水型 6692 GPS/GSM Waterproof ： IP-68 Frequency : GSM 824-960MHz 1710-2170MHz 1710-2170MHz Impedance : 50 ohms VSWR : < 3.0 Gain : 2 dBi Frequency : GPS."

Similar presentations

Operational Amplifiers

Operational Amplifiers
Low Noise Amplifier (LNA) Presented By Mohammad Jameel NDG on FSMFPGA Based System Design1.

Low Noise Amplifier (LNA) Presented By Mohammad Jameel NDG on FSMFPGA Based System Design1.
Design of a Low-Noise 24 GHz Receiver Using MMICs Eric Tollefson, Rose-Hulman Institute of Technology Advisor: Dr. L. Wilson Pearson.

Design of a Low-Noise 24 GHz Receiver Using MMICs Eric Tollefson, Rose-Hulman Institute of Technology Advisor: Dr. L. Wilson Pearson.
Ph: +612 9482 1944 Fx: +612 9482 1309 75ohm Components.

Ph: Fx: ohm Components.
In partnership with STMicroelectronics DESIGN OF A CLASS 1 POWER AMPLIFIER FOR BLUETOOTH TM APPLICATIONS Advisors Candidate Prof. Antonella D’Orazio Giovanni.

In partnership with STMicroelectronics DESIGN OF A CLASS 1 POWER AMPLIFIER FOR BLUETOOTH TM APPLICATIONS Advisors Candidate Prof. Antonella D’Orazio Giovanni.
Antenna Selection for Optimum Wireless LAN Performance Dr. Steven R. Best Cushcraft Corporation 48 Perimeter Road Manchester, NH 03108 (603) 627-7877.

Antenna Selection for Optimum Wireless LAN Performance Dr. Steven R. Best Cushcraft Corporation 48 Perimeter Road Manchester, NH (603)
Waveguides Seminary 5. Problem 5.1 Attenuation and crosstalk of a wire pair A carrier frequency connection is transmitted on twisted pairs with the following.

Waveguides Seminary 5. Problem 5.1 Attenuation and crosstalk of a wire pair A carrier frequency connection is transmitted on twisted pairs with the following.
Temperature Variable Assembly LM 324N: Used to amplify voltage using negative feedback Resistor values R i =474 Ω R f =10 kΩ Gain ( ) = 22.09 With these.

Temperature Variable Assembly LM 324N: Used to amplify voltage using negative feedback Resistor values R i =474 Ω R f =10 kΩ Gain ( ) = With these.
Common-Base vs. Common-Emitter

Common-Base vs. Common-Emitter
Solid State Amplifier At microwave frequencies, the scattering parameters are used In the design of microwave amplifiers. Design Goals: 1.Maximum power.

Solid State Amplifier At microwave frequencies, the scattering parameters are used In the design of microwave amplifiers. Design Goals: 1.Maximum power.
08/16/01.

08/16/01.
Rapidly Deployable Radio Network 5.3 GHz Microstrip Patch Antennas

Rapidly Deployable Radio Network 5.3 GHz Microstrip Patch Antennas
Mid-Semester Design Review High Frequency Radio with BPSK Modulation.

Mid-Semester Design Review High Frequency Radio with BPSK Modulation.
STARLight PDR 3 Oct ‘01 L. van Nieuwstadt Receiver - Page 1 STARLight Objective To design, build and test RF front end receiver as small as possible, meeting.

STARLight PDR 3 Oct ‘01 L. van Nieuwstadt Receiver - Page 1 STARLight Objective To design, build and test RF front end receiver as small as possible, meeting.
Instrumentation Development for the Measurement and Characterisation of Indoor and Urban Canyon Ambient Noise Floor in the Galileo Frequency Bands M. Junered.

Instrumentation Development for the Measurement and Characterisation of Indoor and Urban Canyon Ambient Noise Floor in the Galileo Frequency Bands M. Junered.
PH4705/ET4305: Instrumentation Amp Our sensor will be connected to some kind of measurement system either directly, diag. 1, or as a bridge circuit diag.

PH4705/ET4305: Instrumentation Amp Our sensor will be connected to some kind of measurement system either directly, diag. 1, or as a bridge circuit diag.
2.4-GHZ RF TRANSCEIVER FOR IEEE 802.11B WIRELESS LAN UF# 1593 6620 UF# 1593 6620.

2.4-GHZ RF TRANSCEIVER FOR IEEE B WIRELESS LAN UF# UF#
Name1 SKA(DS) System Design Aspects 4 th SKADS Workshop, Lisbon, 2-3 October 2008 SKA(DS) System Design Aspects: building a system Laurens Bakker.

Name1 SKA(DS) System Design Aspects 4 th SKADS Workshop, Lisbon, 2-3 October 2008 SKA(DS) System Design Aspects: building a system Laurens Bakker.
1 Wideband LNA for a Multistandard Wireless Receiver in 0.18μm CMOS 指導教授 : 林志明 學生 : 黃世一

1 Wideband LNA for a Multistandard Wireless Receiver in 0.18μm CMOS 指導教授 : 林志明 學生 : 黃世一
Tanta University Faculty Of Engineering Electronics & Electrical Communication Department Challenger 8 Team Tanta University Faculty Of Engineering Electronics.

Tanta University Faculty Of Engineering Electronics & Electrical Communication Department Challenger 8 Team Tanta University Faculty Of Engineering Electronics.

Similar presentations

Ads by Google