We think you have liked this presentation. If you wish to download it, please recommend it to your friends in any social system. Share buttons are a little bit lower. Thank you!
Presentation is loading. Please wait.
Published byVictoria Benson
Modified over 5 years ago
Is any tool that is powered by something other than human force. I.e. Electricity Fuel Engines Pneumatics Hydraulics
Electric-Powered Most commonly used. I.e. Saws Drills Sanders Grinders
Fuel Engines Typically gasoline. Used where there is no electricity I.e. Chain Saws Leaf blowers Post hole diggers Generators
Pneumatic Tools Used with compressed air as power. I.e. Powered nail gun Powered staplers Air Compressors Drills Impact driver
Hydraulic Tools Uses a compressed liquid, usually oil, to provide power. I.e. Jacks Loaders Lifts Presses
Power Tool Safety
Never operate a power tool without reading the operator’s manual. All electrical equipment should be properly grounded. Avoid damp or wet areas when using electrical power tools. Use personal protective devices. Keep tools in good condition.
Power Point Project List: Hammer Drill Nail Gun Impact Driver Angle Grinder Drill Press Portable Drill Cutoff Saw Band Saw Reciprocating Saw Air Compressor Jointer Hydraulic Press List: Power Router Radial Arm Saw Dremel Sander Miter Saw Chain Saw Circular Saw Table Saw Sand blaster Planer Rip Fence Generators
FHM TRAINING TOOLS This training presentation is part of FHM’s commitment to creating and keeping safe workplaces. Be sure to check out all the training.
Objective Use agricultural mechanics tools properly and safely.
Safety : Power Tools Introduction to Industrial Technology Spring 2014 Mr. Shubert.
HAND and POWER TOOL SAFETY
Copyright © by NCCER, Published by Pearson Education, Inc. Carpentry Fundamentals Level One Module National Center for Construction Education.
Objective Explain the uses of power tools to perform tasks in agricultural mechanics.
Lesson 3 Using Power Tools.
Power Tools Safety. Portable Circular Saws Stock must be well supported in such a way that the kerf will not close and bind the blade.. Thin materials.
Portable Power Tool Safety. Portable Electric and Cordless Drill Be sure the electric drill is disconnected from the power source before installing bits.
Manual Screwdrivers –used for driving screws into a material and/or taking out screws HAND TOOLS Hammer –used for driving nails into a material and/or.
Copyright © by NCCER, Published by Pearson Education, Inc. Core Curriculum Module National Center for Construction Education and Research Slide.
Hand and Portable Power Tools Hazard Recognition.. Inspect tools daily Tool Fits Job.
Stationary Power Tool Safety
OSHAX.org - The Unofficial Guide To the OSHA
Intro to Power Tools. Electric Tools Pneumatic Tools.
Power/Hand Tools Valley City State University | Facilities Services | OSHA Office of Training & Education.
Tools – Hand and Power 1926 Subpart I - Tools – Hand and Power
© 2021 SlidePlayer.com Inc. All rights reserved.