1. Engineering Graphics

2. INDEX Introduction Scales Engineering Curves Orthographic Projection
Isometric Projection
Projection of Points & Lines
Projection of Planes
Projection of Solids
Section of Solids
IN CLASS

3. Types of Lines Numbering Dimensioning Types of Polygon
INTRODUCTION
Types of Lines
Numbering
Dimensioning
Types of Polygon

4. TYPES OF LINES TYPE ILLUSTRATION APPLICATION CONTINUOUS THICK
Visible outlines
CONTINUOUS THIN
Dimension lines, Leader lines, extension lines
CONTINUOUS THIN - WAVY
Irregular boundary lines
SHORT DASHES
Hidden outlines & edges
LONG CHAIN THIN
Center lines, locus lines, pitch circles
LONG CHAIN LINE
THICK AT ENDS
THIN ELSEWHERE
Cutting plane lines
LONG CHAIN THICK
To indicate surface to receive additional treatment
RULED LINE & SHORT ZIG-ZAG THIN
Long break lines

5. NUMBERING

6. STRAIGHT LETTERS & NUMERALS
Step-1 
First draw two horizontal lines of any length at the distance 10 mm apart from each other.
Step-2 
Then draw vertical lines between the two horizontal lines at distance 10 mm apart form each other.
Step-3 
Then write down the Capital Alphabet letters within each box in such a way that each letter of the alphabet should touch the boundary of the respective box only. Like in the same way write down full ABCD….
Step-4 
As per the procedure described above write down numerals from 1 to 0 in a new line.

7. INCLINED LETTERS & NUMERALS
Step-1 
First draw two horizontal lines of any length at the distance 10 mm apart from each other.
Step-2 
Then draw vertical lines between the two horizontal lines such that each vertical line should be inclined at an angle of 75° with the horizontal line & each line should be at the distance of 10  mm apart from each other.
Step-3 
Then write down the Capital Alphabet letters within each box in such a way that each letter of the alphabet should touch the boundary of the respective box only. Like in the same way write down full ABCD….
Step-4 
As per the procedure described above write down numerals from 1 to 0 in a new line.

8. DIMENSIONING There are two types of dimensioning system:
Uni-Directional System
Aligned System

9. In Unidirectional Method of  Dimensioning the dimension line should be cut at center and dimensions should be placed in the middle of dimension lines as shown into the figure.

10. In Aligned Method of Dimensioning the dimension line should be continuous and dimensions should be placed in the middle of dimension lines as shown into the figure

11. Polygon BASIC DRAWING How to draw a Polygon? TRIANGLE SQUARE PENTAGON
HEXAGON
SEPTAGON
OCTAGON C 6 4 A B 30

12. TRIANGLE 30 A B C 4 6

13. SQUARE 30 A B C 4 6
RADIUS O

14. PENTAGON
BISECTOR C 6 5
RADIUS 4 A B 30

15. HEXAGON 30 A B C 4 6
RADIUS

16. OCTAGON 30 A B C 4 6 8
RADIUS