1. Band Saw Safety Rules

2. Safety Rule #1 Keep all guards in place. Keep all guards in place.

3. Safety Rule #2 Adjust the blade guards to within 1/8” to ¼” of the stock. Adjust the blade guards to within 1/8” to ¼” of the stock.

4. Safety Rule #2 - Continued Blade guards that are over ¼ inch above the work will lead to accidents and reduces the accuracy of your cut. Blade guards that are over ¼ inch above the work will lead to accidents and reduces the accuracy of your cut.

5. Safety Rule #3 Maintain the stock flat on the table. Maintain the stock flat on the table.

6. Safety Rule #3 - Continued Never hold the stock ‘above’ the table, the material must remain flat on the table surface at all times. Never hold the stock ‘above’ the table, the material must remain flat on the table surface at all times.

7. Safety Rule #4 Don’t cut round stock on the band saw. Don’t cut round stock on the band saw. The round stock may roll into the blade causing an accident. The round stock may roll into the blade causing an accident. Only the instructor should perform this task while using a miter gauge. Only the instructor should perform this task while using a miter gauge.

8. Safety Rule #5 Concentrate your attention on the job at hand. Concentrate your attention on the job at hand.

9. Safety Rule #5 - Continued Do not interrupt others while using power equipment. Do not interrupt others while using power equipment. Stay focused until the blade has stopped moving. Stay focused until the blade has stopped moving.

10. Safety Rule #6 Never leave the machine operating while unattended. Never leave the machine operating while unattended.

11. Safety Rule #7 Keep the work area clean. Keep the work area clean.

12. Safety Rule #7 - Continued Scrap wood or tools on the floor or the bandsaw table will lead to accidents and injuries. Scrap wood or tools on the floor or the bandsaw table will lead to accidents and injuries.

13. Safety Rule #8 If the blade comes out of the guides or breaks, stop the machine immediately by turning off the power. If the blade comes out of the guides or breaks, stop the machine immediately by turning off the power. Do not open the access door to the machine until the wheels have come to a complete stop. Do not open the access door to the machine until the wheels have come to a complete stop. Have the instructor reposition or install a new blade. Have the instructor reposition or install a new blade.

14. Safety Rule #9 Do not reach across the saw line. Do not reach across the saw line.

15. Safety Rule #10 Never back material out of a cut until power has been turned off and the motion of the blade has stopped. Never back material out of a cut until power has been turned off and the motion of the blade has stopped.

16. Safety Rule #11 Always use a push stick when sawing small stock. Always use a push stick when sawing small stock.

17. Safety Rule #12 Do not hold the stock in line with the saw blade. Do not hold the stock in line with the saw blade.

18. Safety Rule #12 - Continued Hold the stock to the sides of the cutting line. Hold the stock to the sides of the cutting line.

19. Safety Rule #13 Keep your hands and fingers several inches from the side of the blade. Keep your hands and fingers several inches from the side of the blade.

20. Safety Rule #13 - Continued Remember to keep your hands clear of the table insert. Remember to keep your hands clear of the table insert.

21. Safety Rule #14 Use ‘relief cuts’ on tight curves to avoid breaking the blade. Use ‘relief cuts’ on tight curves to avoid breaking the blade.

22. Summary Follow the safety rules. Follow the safety rules. Use the band saw and other laboratory tools only for their intended purpose. Use the band saw and other laboratory tools only for their intended purpose. Follow the directions and safety guidelines as listed by the machine’s manufacturer. Follow the directions and safety guidelines as listed by the machine’s manufacturer.