1. Fluid Mechanics 06

2. Energy, Work and Power Work:- Work is force acting through a distance when the force is parallel to the direction of motion. Energy:- Types of Work Stored like kinetic energy, potential energy, thermal energy. Power:- Power expresses a rate of work or energy

3. Work and Energy Units Common units include the joule (J), newton- meter, watt-hour (Wh), foot-pound-force (ft-lbf), calorie (cal), and the British thermal unit (Btu). Where Btu = 1055 J(It is the amount of energy needed to heat one pound of water by one degree Fahrenheit) Cal = 4.2 J(it is the amount of thermal energy needed to raise the temperature of 1 gram of water by 1°C) ft-lbf = 1.356 J

4. Power Units Common units for power are the watt (W), horsepower (hp), and the ft-lbf/s. Where 1 hp = 550 ft-lbf/s. 1 hp = 745.7 watt

5. Energy Equation

6. Thermal energy is positive when there is an addition of thermal energy to the system and negative when there is a removal. Work is positive when the system is doing work on the environment and negative when work is done on the system.

7. Pipe Flow Energy Equation

8. The preview equation based on three main assumptions:- (a)the flow is steady. (b) the control volume has one inlet port and one exit port. (c) the density of the flow is constant.

9. Example A horizontal pipe carries cooling water at 10°C for a thermal power plant from a reservoir as shown. The head loss in the pipe is where L is the length of the pipe from the reservoir to the point in question, V is the mean velocity in the pipe, and D is the diameter of the pipe. If the pipe diameter is 20 cm and the rate of flow is 0.06 m3/s, what is the pressure in the pipe at L = 2000 m.

11. Solution

13. Power

14. Example A pipe 50 cm in diameter carries water (10°C) at a rate of 0.5 m3/s. A pump in the pipe is used to move the water from an elevation of 30 m to 40 m. The pressure at section 1 is 70 kPa gage and the pressure at section 2 is 350 kPa gage. What power in kilowatts and in horsepower must be supplied to the flow by the pump? Assume hL = 3 m of water.

16. Solution

17. At the maximum rate of power generation, a small hydroelectric power plant takes a discharge of 14.1 m3/s through an elevation drop of 61 m. The head loss through the intakes, penstock, and outlet works is 1.5 m. The combined efficiency of the turbine and electrical generator is 87%. What is the rate of power generation? Example

19. Solution