1. Solid State Approach: La 9.33 Si 6 O 26 Electrolyte as a Replacement for YSZ in Solid Oxide Fuel Cells By: Scott Wilhour, Penn State, MatSE Mentor: Martha Mecartney, UCI, ChEMS

2. Outline What are SOFCs? Purpose of this study Apatite-type lanthanum silicate Key points to remember Experimental process Results Conclusions Future work

3. How SOFCs Work What is it? –Electrochemical energy generation device –Operates like a battery, no recharging As long as fuel is supplied to it, the fuel cell will produce energy in the form of electricity and heat

4. Purpose of this Study Use the apatite structure for an electrolyte as an alternative to currently used yttria stabilized zirconia (YSZ) High-conductivity electrolyte to promote the utility of the solid oxide fuel cell –Lower the internal SOFC temperature solve the leaking-seal problem due to high operating temperatures in YSZ SOFCs

5. New Electrolyte La 28 Si 18 O 78 (La 9.33 Si 6 O 26 ) High oxide ion conductivity at low T Conduction occurs via an interstitial mechanism Has lower operating temperature than YSZ

6. KEY POINTS Nanocrystalline grain size as small as possible (~20 nm) for high conductivity Hypothesis is that when smaller grains increase the grain boundary area, should get improved conductivity since materials have interstitial transport of the oxygen ions and grain boundaries should have more space for interstitials –As a result, nanocrystalline apatite would have a higher oxide-ion conductivity to use in future fuel cells than currently used YSZ

7. Experimental Process Procedure for making lanthanum silicate powders: –La 2 O 3 and SiO 2 raw powders are mixed in 4:5 ratio –Mill powders for 8 hours (Attrition and Cryo) –Pack powder into a mold –Cold Isostatic Press (CIP) to mold the pellet –Heat treatment in furnace at 1450°C for 2 hours –Reaction produces lanthanum-silicate based apatite (La 9.33 Si 6 O 26 ) Analysis of materials synthesized –XRD ~ used to determine phase composition and grain size –SEM ~ used to determine grain size –IS ~ used to determine material’s impedance and consequently its ionic conductivity (future work)

8. Results – XRD It was concluded that all of the diffraction peaks of the sample can be assigned to La 28 Si 18 O 78. This means that there was no contamination from impurities Grain sizes were then determined using Scherrer’s method of peak broadening –Attrition-milled lanthanum silicate yielded ~47nm grains –Cryo-milled lanthanum silicate yielded ~29nm grains, within the range needed for high conductivity

9. Results – SEM Attrition-MilledCryo-Milled

10. Results – SEM Attrition-MilledCryo-Milled

11. Conclusions Apatite-type lanthanum silicate (La 9.33 Si 6 O 26 ) exhibits smaller grain sizes on the order of 20-30 nm from XRD data when cryo-milled This shows that achieving a fine grain size in apatite ceramics is possible with cryo-milling.

12. Future Work Impedance Spectroscopy was not conducted due to time constraints, and remains as the final step in this study to measure ionic conductivity as a function of grain size in lanthanum silicate Oxygen ion conductivity in lanthanum silicate electrolyte will need to be compared to yttria stabilized zirconia to see if it is superior

13. Acknowledgements Principal Investigator – Professor Martha Mecartney Graduate Mentor – Mai Ng Aminah Rumjahn Peter Dillon IMSURE Program National Science Foundation