1. Robert Ruland MMF Layout, Workflow ruland@slac.stanford.edu October 14, 2004 MMF Review 1 MMF Layout, Workflow Robert Ruland Magnetic Measurements Facility Layout Workflow Summary Magnetic Measurements Facility Layout Workflow Summary

2. Robert Ruland MMF Layout, Workflow ruland@slac.stanford.edu October 14, 2004 MMF Review 2 Layout Floor plan divided into three functional areas Magnetic Measurements (± 0.1º C) Fiducialization and Assembly (± 1º C) Storage (± 2.5º C) Test stand lay-out is driven by requirement to match the Earth Magnetic Field conditions in lab to Undulator Hall, i.e. azimuth and gap orientation need to be identical

3. Robert Ruland MMF Layout, Workflow ruland@slac.stanford.edu October 14, 2004 MMF Review 3 Moving and Lifting Forklift is used to move undulator segment in and out storage racks as well as on and off dollies Dollies are used to move segments between rooms Cranes are used to load segments on and off benches

4. Robert Ruland MMF Layout, Workflow ruland@slac.stanford.edu October 14, 2004 MMF Review 4 Tuning / Fiducialization Workflow All Undulators are tuned to nominal K, position specific K setting is done by adjusting relative quad-to-und alignment Tuning / Fiducialization Workflow In storage area, load dolly with undulator segment Roll dolly into F&A lab, adjust to temperature for 3 days Roll dolly into MM lab, adjust to temperature for 7 days Set-up undulator on bench #2, pre-adjust gap, 2 days Move onto bench #1, fine-adjust gap, tune, measure pointed magnet fixture offset, 3 days Move onto CMM, finish fiducialization, 1 day

5. Robert Ruland MMF Layout, Workflow ruland@slac.stanford.edu October 14, 2004 MMF Review 5 Cradle Assembly Workflow Pre-assemble Cradle Move cradle onto assembly bench Install quad, vacuum chamber, and BPM Pre-Align and straighten vacuum chamber Mount undulator Align Components Move assembly onto CMM Set undulator into nominal position Set roll-away reference Align Quad wrt undulator Align BPM wrt Quad Adjust undulator relative X-position for local K

6. Robert Ruland MMF Layout, Workflow ruland@slac.stanford.edu October 14, 2004 MMF Review 6 END of Presentation