Presentation is loading. Please wait.

Presentation is loading. Please wait.

Operational-Amplifier and Data-Converter Circuits

Similar presentations


Presentation on theme: "Operational-Amplifier and Data-Converter Circuits"— Presentation transcript:

1 Operational-Amplifier and Data-Converter Circuits
1

2 sedr42021_0901.jpg Figure 9.1 The basic two-stage CMOS op-amp configuration. Microelectronic Circuits - Fifth Edition Sedra/Smith

3 sedr42021_0902.jpg Figure 9.2 Small-signal equivalent circuit for the op amp in Fig. 9.1. Microelectronic Circuits - Fifth Edition Sedra/Smith

4 sedr42021_0903.jpg Figure 9.3 An approximate high-frequency equivalent circuit of the two-stage op amp. This circuit applies for frequencies fP1. Microelectronic Circuits - Fifth Edition Sedra/Smith

5 sedr42021_0904.jpg Figure 9.4 Typical frequency response of the two-stage op amp. Microelectronic Circuits - Fifth Edition Sedra/Smith

6 sedr42021_0905.jpg Figure 9.5 Small-signal equivalent circuit of the op amp in Fig. 9.1 with a resistance R included in series with CC. Microelectronic Circuits - Fifth Edition Sedra/Smith

7 sedr42021_0906.jpg Figure 9.6 A unity-gain follower with a large step input. Since the output voltage cannot change immediately, a large differential voltage appears between the op-amp input terminals. Microelectronic Circuits - Fifth Edition Sedra/Smith

8 sedr42021_0907.jpg Figure 9.7 Model of the two-stage CMOS op amp of Fig. 9.1 when a large differential voltage is applied. Microelectronic Circuits - Fifth Edition Sedra/Smith

9 sedr42021_0908.jpg Figure 9.8 Structure of the folded-cascode CMOS op amp. Microelectronic Circuits - Fifth Edition Sedra/Smith

10 sedr42021_0909.jpg Figure 9.9 A more complete circuit for the folded-cascode CMOS amplifier of Fig. 9.8. Microelectronic Circuits - Fifth Edition Sedra/Smith

11 sedr42021_0910.jpg Figure Small-signal equivalent circuit of the folded-cascode CMOS amplifier. Note that this circuit is in effect an operational transconductance amplifier (OTA). Microelectronic Circuits - Fifth Edition Sedra/Smith

12 sedr42021_0911.jpg Figure A folded-cascode op amp that employs two parallel complementary input stages to achieve rail-to-rail input common-mode operation. Note that the two “+” terminals are connected together and the two “–” terminals are connected together. Microelectronic Circuits - Fifth Edition Sedra/Smith

13 sedr42021_0912a.jpg Figure (a) Cascode current mirror with the voltages at all nodes indicated. Note that the minimum voltage allowed at the output is Vt + VOV. (b) A modification of the cascode mirror that results in the reduction of the minimum output voltage to VOV. This is the wide-swing current mirror. Microelectronic Circuits - Fifth Edition Sedra/Smith

14 sedr42021_e0908.jpg Figure E9.8 Microelectronic Circuits - Fifth Edition Sedra/Smith

15 sedr42021_0913.jpg Figure The 741 op-amp circuit. Q11, Q12, and R5 generate a reference bias current, IREF. Q10, Q9, and Q8 bias the input stage, which is composed of Q1 to Q7. The second gain stage is composed of Q16 and Q17 with Q13B acting as active load. The class AB output stage is formed by Q14 and Q20 with biasing devices Q13A, Q18, and Q19, and an input buffer Q23. Transistors Q15, Q21, Q24, and Q22 serve to protect the amplifier against output short circuits and are normally cut off. Microelectronic Circuits - Fifth Edition Sedra/Smith

16 sedr42021_0914a.jpg Figure 9.14 (a) The emitter follower is a class A output stage. (b) Class B output stage. Microelectronic Circuits - Fifth Edition Sedra/Smith

17 sedr42021_0914c.jpg Figure (Continued) (c) The output of a class B output stage fed with an input sinusoid. Observe the crossover distortion. (d) Class AB output stage. Microelectronic Circuits - Fifth Edition Sedra/Smith

18 sedr42021_e0910.jpg Figure E9.10 Microelectronic Circuits - Fifth Edition Sedra/Smith

19 sedr42021_0915.jpg Figure 9.15 The Widlar current source.
Microelectronic Circuits - Fifth Edition Sedra/Smith

20 sedr42021_0916.jpg Figure 9.16 The dc analysis of the 741 input stage.
Microelectronic Circuits - Fifth Edition Sedra/Smith

21 sedr42021_0917.jpg Figure The dc analysis of the 741 input stage, continued. Microelectronic Circuits - Fifth Edition Sedra/Smith

22 sedr42021_0918.jpg Figure The 741 output stage without the short-circuit protection devices. Microelectronic Circuits - Fifth Edition Sedra/Smith

23 sedr42021_0919.jpg Figure Small-signal analysis of the 741 input stage. Microelectronic Circuits - Fifth Edition Sedra/Smith

24 sedr42021_0920.jpg Figure The load circuit of the input stage fed by the two complementary current signals generated by Q1 through Q4 in Fig Circled numbers indicate the order of the analysis steps. Microelectronic Circuits - Fifth Edition Sedra/Smith

25 sedr42021_0921a.jpg Figure Simplified circuits for finding the two components of the output resistance Ro1 of the first stage. Microelectronic Circuits - Fifth Edition Sedra/Smith

26 sedr42021_0922.jpg Figure Small-signal equivalent circuit for the input stage of the 741 op amp. Microelectronic Circuits - Fifth Edition Sedra/Smith

27 sedr42021_0923.jpg Figure Input stage with both inputs grounded and a mismatch DR between R1 and R2. Microelectronic Circuits - Fifth Edition Sedra/Smith

28 sedr42021_e0915.jpg Figure E9.15 Microelectronic Circuits - Fifth Edition Sedra/Smith

29 sedr42021_0924.jpg Figure The 741 second stage prepared for small-signal analysis. Microelectronic Circuits - Fifth Edition Sedra/Smith

30 sedr42021_0925.jpg Figure Small-signal equivalent circuit model of the second stage. Microelectronic Circuits - Fifth Edition Sedra/Smith

31 sedr42021_0926.jpg Figure 9.26 Definition of Ro17.
Microelectronic Circuits - Fifth Edition Sedra/Smith

32 sedr42021_0927.jpg Figure Thévenin form of the small-signal model of the second stage. Microelectronic Circuits - Fifth Edition Sedra/Smith

33 sedr42021_0928.jpg Figure 9.28 The 741 output stage.
Microelectronic Circuits - Fifth Edition Sedra/Smith

34 sedr42021_0929.jpg Figure Model for the 741 output stage. This model is based on the amplifier equivalent circuit presented in Table 5.5 as “Equivalent Circuit C.” Microelectronic Circuits - Fifth Edition Sedra/Smith

35 sedr42021_0930.jpg Figure Circuit for finding the output resistance Rout. Microelectronic Circuits - Fifth Edition Sedra/Smith

36 sedr42021_e0926.jpg Figure E9.26 Microelectronic Circuits - Fifth Edition Sedra/Smith

37 sedr42021_e0927.jpg Figure E9.27 Microelectronic Circuits - Fifth Edition Sedra/Smith

38 sedr42021_0931.jpg Figure Cascading the small-signal equivalent circuits of the individual stages for the evaluation of the overall voltage gain. Microelectronic Circuits - Fifth Edition Sedra/Smith

39 sedr42021_0932.jpg Figure Bode plot for the 741 gain, neglecting nondominant poles. Microelectronic Circuits - Fifth Edition Sedra/Smith

40 sedr42021_0933.jpg Figure A simple model for the 741 based on modeling the second stage as an integrator. Microelectronic Circuits - Fifth Edition Sedra/Smith

41 sedr42021_0934.jpg Figure A unity-gain follower with a large step input. Since the output voltage cannot change instantaneously, a large differential voltage appears between the op-amp input terminals. Microelectronic Circuits - Fifth Edition Sedra/Smith

42 sedr42021_0935.jpg Figure Model for the 741 op amp when a large positive differential signal is applied. Microelectronic Circuits - Fifth Edition Sedra/Smith

43 sedr42021_0936a.jpg Figure The process of periodically sampling an analog signal. (a) Sample-and-hold (S/H) circuit. The switch closes for a small part (t seconds) of every clock period (T). (b) Input signal waveform. (c) Sampling signal (control signal for the switch). (d) Output signal (to be fed to A/D converter). Microelectronic Circuits - Fifth Edition Sedra/Smith

44 sedr42021_0937.jpg Figure The A/D and D/A converters as circuit blocks. Microelectronic Circuits - Fifth Edition Sedra/Smith

45 sedr42021_0938.jpg Figure The analog samples at the output of a D/A converter are usually fed to a sample-and-hold circuit to obtain the staircase waveform shown. This waveform can then be filtered to obtain the smooth waveform, shown in color. The time delay usually introduced by the filter is not shown. Microelectronic Circuits - Fifth Edition Sedra/Smith

46 sedr42021_0939.jpg Figure An N-bit D/A converter using a binary-weighted resistive ladder network. Microelectronic Circuits - Fifth Edition Sedra/Smith

47 sedr42021_0940.jpg Figure The basic circuit configuration of a DAC utilizing an R-2R ladder network. Microelectronic Circuits - Fifth Edition Sedra/Smith

48 sedr42021_0941.jpg Figure A practical circuit implementation of a DAC utilizing an R-2R ladder network. Microelectronic Circuits - Fifth Edition Sedra/Smith

49 sedr42021_0942.jpg Figure Circuit implementation of switch Sm in the DAC of Fig In a BiCMOS technology, Qms and Qmr can be implemented using MOSFETs, thus avoiding the inaccuracy caused by the base current of BJTs. Microelectronic Circuits - Fifth Edition Sedra/Smith

50 sedr42021_0943.jpg Figure 9.43 A simple feedback-type A/D converter.
Microelectronic Circuits - Fifth Edition Sedra/Smith

51 sedr42021_0944a.jpg Figure The dual-slope A/D conversion method. Note that vA is assumed to be negative. Microelectronic Circuits - Fifth Edition Sedra/Smith

52 sedr42021_0944b.jpg Figure 9.44 (Continued)
Microelectronic Circuits - Fifth Edition Sedra/Smith

53 sedr42021_0945.jpg Figure Parallel, simultaneous, or flash A/D conversion. Microelectronic Circuits - Fifth Edition Sedra/Smith

54 sedr42021_0946a.jpg Figure Charge-redistribution A/D converter suitable for CMOS implementation: (a) sample phase, (b) hold phase, and (c) charge-redistribution phase. Microelectronic Circuits - Fifth Edition Sedra/Smith

55 Figure 9.47 Capture schematic of the two stage CMOS op amp in Example 9.4.
Microelectronic Circuits - Fifth Edition Sedra/Smith

56 sedr42021_0948.jpg Figure Magnitude and phase response of the op-amp circuit in Fig. 9.47: R = 1.53 kW, CC = 0 (no frequency compensation), and CC = 0.6 pF (PM = 55°). Microelectronic Circuits - Fifth Edition Sedra/Smith

57 sedr42021_0949.jpg Figure Magnitude and phase response of the op-amp circuit in Fig. 9.47: R = 1.53 kW, CC = 0 (no frequency compensation), and CC = 1.8 pF (PM = 75°). Microelectronic Circuits - Fifth Edition Sedra/Smith

58 sedr42021_0950.jpg Figure Magnitude and phase response of the op-amp circuit in Fig. 9.47: CC = 0.6 pF, R = 1.53 kW (PM = 55°), and R = 3.2 kW (PM = 75°). Microelectronic Circuits - Fifth Edition Sedra/Smith

59 sedr42021_0951.jpg Figure Small-signal step response (for a 10-mV step input) of the op-amp circuit in Fig connected in a unity-gain configuration: PM = 55° (CC = 0.6 pF, R = 1.53 kW) and PM = 75° (CC = 0.6 pF, R = 3.2 kW). Microelectronic Circuits - Fifth Edition Sedra/Smith

60 sedr42021_0952.jpg Figure Large-signal step response (for a 3.3-V step-input) of the op-amp circuit in Fig connected in a unity-gain configuration. The slope of the rising and falling edges of the output waveform correspond to the slew rate of the op amp. Microelectronic Circuits - Fifth Edition Sedra/Smith

61 sedr42021_p0914.jpg Figure P9.14 Microelectronic Circuits - Fifth Edition Sedra/Smith

62 sedr42021_p0923.jpg Figure P9.24 Microelectronic Circuits - Fifth Edition Sedra/Smith

63 sedr42021_p0937.jpg Figure P9.37 Microelectronic Circuits - Fifth Edition Sedra/Smith

64 sedr42021_p0942.jpg Figure P9.42 Microelectronic Circuits - Fifth Edition Sedra/Smith

65 sedr42021_p0946.jpg Figure P9.47 Microelectronic Circuits - Fifth Edition Sedra/Smith

66 sedr42021_p0961.jpg Figure P9.61 Microelectronic Circuits - Fifth Edition Sedra/Smith

67 sedr42021_p0965.jpg Figure P9.65 Microelectronic Circuits - Fifth Edition Sedra/Smith


Download ppt "Operational-Amplifier and Data-Converter Circuits"

Similar presentations


Ads by Google