1. Edge Blend Constant radius edge blend Handlebar

2. Edge Blend - Variable 5 mm radius for 25% length of the edge 10 mm radius for the next 25% 15 mm radius for the next 25% 5 mm radius for the last 25% Select Edge Blend → Variable Radius option → select an edge

3. Edge Blend - Variable Select 4 points and specify the radius and the % length of the edge for each section Select Inferred icon and pick the end point of the edge Specify Radius and % length Point 1 – specify 5 mm radius and 75% Arc Length Note: Arc length is counted down from 100%. So for section 1, 5 mm radius for the first 25% of length, you should specify 75% for Arc Length

4. Edge Blend - Variable Point 2 - 10 mm radius for the next 25% Pick a point on the edge and specify radius 10 mm and 50% for Arc Length and then enter Point 3 - 15 mm radius for the next 25%, pick a point on the edge and specify 15 mm radius and 25% Arc Length

5. Edge Blend - Variable Point 4 - 5 mm radius for the last 25%, pick the end point of the edge and specify 5 mm radius and 0% (default) Arc Length

6. Face Blend First surface Direction for the first surface Second surface Direction for the second surface 1 st surface 2 nd surface

7. Face Blend Shape option Circular Conic

8. Face Blend Blend profile could also be controlled with Radius Method option Law Controlled with Linear Law Type Law Controlled with Cubic Law Type

9. Face Blend Select Tangency Constraint Select Coincident Edge Coincident Edge Select Tangent Curve Tangent Curve

10. Soft Blend 5 steps needed to create a soft blend 1 - Select surface one 2 - Select surface two Reverse direction if needed

11. Soft Blend 3 - Select tangent curve 1 4 - Select tangent curve 2 Soft Blend Face Blend 5 - Select tangent curve 2