1. SolidWorks Session 4 Ferdowsi University of Mashhad
Dr. Behnam Moetakef Imani

2. Fillet : Types of Fillet

3. Fillet Type : Constant Radius
Constant radius . Creates fillets that have a constant radius for the entire length of the fillet.
set the PropertyManager options to create these fillet types:
Multiple radius fillets       
Round corner fillets.
Setback fillets

4. Multiple Radius Fillets
Creates fillets that have different radius values

5. Round Corner Fillet
Creates a smooth transition where fillet edges meet

6. Setback Fillets
Defines a setback distance from a vertex at which the fillets start to blend

7. Fillet Type : Variable Radius
Creates a fillet with variable radii values

8. Fillet Type : Variable Radius Control Points
You can manipulate and assign radius values to
the control points between the vertices of a variable radius fillet

9. Fillet Type : Face Fillet
Blends non-adjacent, non-continuous faces

10. Face Fillet Hold Lines An edge on the part or a projected split line
on a face as a boundary that determines the face fillet shape

11. Face Fillet with Constant Width
Creates a fillet with a constant width

12. Fillet Type : Full Round Fillet
Creates fillets that are tangent to three adjacent faces sets
(with one or more faces tangent )

13. Fillet Property Manager : Tangent Propagation
Extends the fillet to all faces that are tangent to the selected face

14. fillet
Overflow Type
Default. The system chooses one of the following options, depending on the geometry conditions (convexity of edges being filleted and the adjacent edges, and so on).
Keep edge. Maintains the integrity of adjacent linear edges. However, the fillet surface is broken into separate surfaces, and in many cases the top edge of the fillet may have a dip in it.
Keep surface. Uses the adjacent surface to trim the fillet. As a result, the fillet edge is continuous and smooth, but the adjacent edge is disturbed.

15. fillet Select Loop To select a loop:
1- On a part, right-click an edge and choose Select Loop. A loop is selected on one face. A handle displays the direction of the loop.
2- To change the loop selection to the edges of the other connecting face, click the handle.
3- To select a loop on a face:
Select a face. Hold Ctrl and select an edge of a loop. The complete loop is selected.