1. A GIS-Enabled Kinematic Wave Approach for Calculating the Transition between Sheet and Concentrated Flows Stacy L. Hutchinson 1, J.M. Shawn Hutchinson 2, and Ik-Jae Kim 1 1 Department of Biological and Agricultural Engineering and 2 Department of Geography, Kansas State University, Manhattan, Kansas 66506 Figure 1. Schematic of “typical” vegetated buffer system with diagram illustrating key differences between sheet and concentrated flows. Figure 2. Digital elevation models of varying spatial resolutions with resulting flow networks superimposed upon a false color composite aerial photograph of the Fort Riley study site. Figure 4. Tables showing reported efficiencies of vegetated buffer systems and McCuen and Spiess’ (1995) T ov calculation with evaluation criteria. Figure 5. Energy accumulation grid for a subwatershed of Cheney Reservoir, near Wichita, Kansas with actual ephemeral gully locations. References McCuen, R.H. and J.M. Spiess. 1995. Assessment of kinematic wave time of concentration. Journal of Hydrologic Engineering 121 (3):256-266. Meyer, A. and J.A. Martinez-Casasnovas. 1999. Prediction of existing gully erosion in vineyard parcels of the NE Spain: a logistic modeling approach. Soil & Tillage Research 50: 319-331. Prosser, I.P. and B. Abernethy. 1996. Predicting the topographic limits to a gully network using a digital terrain model and process thresholds. Water Resources Research 32(7): 2289-2298. Tarboton, D.G., R.L. Bras, and I. Rodriguez-Iturbe. 1991. On the extraction of channel networks from digital elevation model. Hydrological Processes 5:81-100.Acknowledgements This work is funded through CPSON-03-02 (Characterizing and Monitoring Non-Point Source Runoff from Military Ranges and Identifying their Impacts to Receiving Water Bodies) and the Kansas Agricultural Experiment Station. Special thanks to Mr. Phil Woodford and the Fort Riley Integrated Training Area Management (ITAM) for assistance with field site development and data collection. Introduction Non-point source (NPS) pollution has been called the nation’s largest water quality problem, and its reduction is a major challenge facing our society today. As of 1998 over 290,000 miles of river, almost 7,900,000 acres of lake and 12,500 square miles of estuaries failed to meet water quality standards. Military training maneuvers have the potential to significantly alter land surfaces in a manner that promotes NPS pollution, resulting in the inability of military installations to meet water quality standards and the decline of training lands. Currently, most efforts to reduce NPS pollution focus on the use of watershed water quality models. Identification of overland flow networks is a vital preprocessing step for these NPS models. Flow networks are used to determine transport routes for pollution and optimal placement of best management practices. One practice that is widely adopted for reducing NPS pollution is the vegetated buffer system (VBS). The primary hydrologic consideration for VBS design and function is uniform sheet flow. With time, however, overland flow concentrates and channelizes, reducing contact time with vegetation and NPS pollution reduction efficiency. The kinematic wave approximation is a useful technique for calculating overland flow time of concentration within a drainage area. Digital elevation models (DEMs) are widely used for determining various landscape variables, as well as for delineating overland flowpath networks and drainage area boundaries. Using topographic variables estimated from DEMs and applying the kinematic wave theory in a GIS environment, it is possible to estimate the length and travel time of overland flow providing an improved understanding of VBS placement for maximum water quality benefit, as well as a reduction in gully erosion caused by concentrated flow. Data and Methods USGS National Elevation Dataset (NED) 30m digital elevation model (DEM) data was used to develop three raster data layers using ESRI’s ArcGIS 9.1 software: Slope, flow direction, and flow accumulation. Slope (S) was calculated using the deterministic eight direction method (D8) in 3 by 3 cells. Unlike the normal procedure for delineating stream networks, flow direction was determined without “filling” because characteristics of land curvature affect the transition from sheet flow to concentrated flow and the potential for gully erosion. A flow accumulation grid, which connects the direction of flow from cell to cell and determines the number of cells accumulating within a downslope flowpath, was estimated using standard ArcGIS flow direction tools. The flow accumulation values (no. of cells) was converted into a slope length grid by multiple number of cells by 30, then by 3.208 to determine the upslope slope length for each cell (L). Kansas GAP landcover data for the installation were used to create a grid dataset for Manning’s coefficient (n) data layers. From this information, a continuous “energy accumulation” grid calculated as the product of three separate data layers representing Manning’s coefficient (n), slope length (L), and the square root of slope (S -0.5 ). Preliminary Results The location of ephemeral gullies were recorded, as part of a separate project, within a subwatershed of Cheney Reservoir in south-central Kansas. Gully point locations were overlayed on top of a continuous “energy accumulation” grid calculated as the product of three separate data layers representing Manning’s coefficient (n), slope length (L), and the square root of slope (S -0.5 ). Energy accumulation values for each gully point were extracted, as were the values for 500 additional points located randomly within the subwatershed. The mean values for these two datasets were then compared using a one-tailed two sample for means z-test in order to determine whether they were significantly different. The alternate hypothesis is that nLS -0.05 energy values at the gully locations would be greater than those for the randomly- placed points. Initial data analysis indicates that the mean energy accumulation values for the gully and random point datasets are significantly different at p = 0.21. Mean (standard deviation) nLS -0.05 values for the gully and random points were 32,532.5 (66,334.9) and 26,989.6 (123,110.7), respectively. Though the p-value is not in the preferred range of 0.01-0.05, this is an encouraging result given that very coarse resolution DEMs, and no soil characteristics, were used in this study. Grass – control runoff, sediment Shrubs – nutrient removal Trees – bank stabilization Zone 1Zone 3Zone 2 W L Uniform Sheet Flow A = W x L Concentrated Flow A = W x L x β β = A – Ineffective Area 10 m 3 m 30m USGS 30 m t ov = [0.93(nL) 0.6 ] / [i 0.4 (S 0.5 ) 0.6 ] Figure 3. The Fort Riley installation with grid surfaces representing (from bottom to top): Manning’s coefficient, flow length, slope, and nLS -0.5 energy accumulation.