Presentation is loading. Please wait.

Presentation is loading. Please wait.

Session III Personal Protective Equipment Isolate students from hazardous materials EYES HANDS BODY.

Similar presentations


Presentation on theme: "Session III Personal Protective Equipment Isolate students from hazardous materials EYES HANDS BODY."— Presentation transcript:

1 Session III Personal Protective Equipment Isolate students from hazardous materials EYES HANDS BODY

2 OSHA REGULATIONS Teachers shall provide training to each student who is required by this section to use PPE. Each such student shall be trained to know at least the following: A. When PPE is necessary b. What PPE is necessary c. How to properly don, doff, adjust, and wear PPE d. The limitations of the PPE e. The proper care, maintenance, useful life and disposal of the PPE

3 OSHA REGULATION The teacher shall assess the lab to determine if hazards are present, or are likely to be present, which necessitate the use of Personal Protective Equipment (PPE). If such hazards are present, or likely to be present, the teacher shall: select, and have each affected student use, the types of PPE that will protect the affected students from the hazards identified in the hazard assessment.

4 § 115C-166. Eye protection devices required in certain courses The teacher shall ensure that each affected student uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation. Defective and damaged equipment. Defective or damaged personal protective equipment shall not be used.

5 Eye Protection 29 CFR 1910.132 Protective eye and face devices purchased after July 5, 1994 shall comply with ANSI Z87.1-1989, "American National Standard Practice for Occupational Educational Eye and Face Protection. Eye and face PPE shall be distinctly marked to facilitate identification of the manufacturer. The teacher shall ensure that each affected student who wears prescription lenses while engaged in operations that involve eye hazards wears eye protection that incorporates the prescription in its design, or wears eye protection that can be worn over the prescription lenses without disturbing the proper position of the prescription lenses or the protective lenses.

6 Visitors to such shops and laboratories shall be furnished with and required to wear such eye safety devices while such programs are in progress. (1977 & 1981) § 115C-167. Visitors to wear eye safety devices

7 Modeling is Important! Teacher models appropriate safety behavior Wears appropriate PPE

8 ANSI Z87.1 IMPACT - 1 inch steel ball dropped from height 40 to 50 inches Does not impair, shatter, split, break lens, frame of eyewear Requires appropriate eyewear for the task Appropriate eyewear is standard established by Professional organizations Chemical Splash Goggles for any fluid Safety Glasses (Impact) UV Goggles Visorgogs

9 Examples

10 Types of Eyewear Chemical Splash Goggles – for any fluid Safety Glasses – impact UV Goggles – can be either impact or splash Impact Safety Goggles - impact Visorgogs – impact

11 Eye and Face Protection OSHA 29 CFR 1910.132 and 29 CFR 1910.133 Sterilization UV Cabinet (12-15 minutes) 70% isopropyl alcohol Swabs Wipes Elastic straps on some goggles – allow eggs of head lice to embed Use rubber straps

12 ANSI Z87.1 – Safety Glasses

13 ANSI Z87.1- Safety Glasses

14 ANSI Z87.1 - Visorgogs

15 ANSI Z87.1 – Safety Goggles

16 ANSI Z87.1 – Chemical Splash Goggles

17 Contact Lens 1994 OSHA Reversed Ruling Non-vented Chemical Splash Goggles ACS Approved NIOSH Approved

18 Hand Protection Required when there are hazards from skin absorption to harmful substances, severe cuts or lacerations, severe abrasions, punctures, chemical burns, thermal burns and harmful temperature extremes. Neoprene - for sunlight, heat, organic solvents Aluminized - for hot or cold materials Leather - for glass, bites, sharp objects, heat, cold Polyethylene - often disposable for solvents, acids, detergents Plastic latex - for general non-hazardous chemicals Nitrile for acids – organic solvents.

19 Clothing Open toed shoes and shoes with high heels are prohibited in the lab Short pants are prohibited in the lab Neck- ties should be removed when in the lab area. Loose jewelry is prohibited in the lab Long hair should be tied back A full length lab coat or a chemical- resistant apron is required when working with corrosive chemicals.

20 Some content for the slides in this section were produced by Linda Stroud, Science & Safety Consulting Services.

21 Session III Emergency Equipment Eye Wash Stations Drench Shower First Aid Kit Fire Extinguisher Fire Blanket Clean –up Kit

22 Emergency Equipment Must be strategically located throughout the lab Must be labeled Must be immediately available Must be in good working condition Each student must be instructed on its use

23 Eye Wash Station Must be able to get to eyewash within 10 seconds Must be able to supply a fresh supply of water for 15 minutes continuous Should be checked each week Eye wash area not to be used for anything else

24 Drench Shower ANSI Z 358-1-1990 Shower area must be clear of electrical wiring The area around the shower must be kept clear Shower should be tested once each month when school is in session Shower drain must be clear of object that may impede water flow Must be labeled

25 First Aid Kit Must be mounted on the wall Must be labeled Available for immediate use Should contain an adequate supply of: Gauze compresses and bandages Eye compress PPE No meds, creams, ointments to be dispensed-When purchasing a commercially stocked kit, please remove these items.

26 Fire Extinguisher Must be mounted in a conspicuous location near the chemical store room Must be labeled Must be charged ( indicator points in green area) Must be checked each month ( tag signed and dated)

27 Bio Hazard Clean Up Kit PPE Germicidal Spray Absorbent Media Collection Bag Scoop

28 Fire Blanket Must be constructed of wool and marked with appropriate signage Blanket should be in good condition no tears, holes Should be checked each year and replaced as needed

29 Fume Hood An operational fume hood should be available in all labs when conducting experiments involving hazardous fumes. Teachers will check the hoods efficiency capability at least weekly. Chemicals must not be stored in the hood.


Download ppt "Session III Personal Protective Equipment Isolate students from hazardous materials EYES HANDS BODY."

Similar presentations


Ads by Google