Presentation on theme: "Programming CMIII SELP Select button to program SensitivitySet between 0-9; 0 essentially turns off feature Cook TimeSelect cooking time for product Pressing."— Presentation transcript:
Programming CMIII SELP Select button to program SensitivitySet between 0-9; 0 essentially turns off feature Cook TimeSelect cooking time for product Pressing the checkmark and entering 1650, opens the computer to programming, in this sequence, for each product button.
Shake TimeSets point in cook cycle product is to be shaken Hold TimeSets time product can be held after cooked After entering each figure, press Checkmark to advance to the next figure.
Product programming At this point, the button to be programmed is pressed. Buttons L, R and 1 through 0 provide 12 programmable spots.
Sensitivity Sensitivity is set between 0 and 9. It adjusts -- “shrinks or stretches”-- cook time based on the effect dropping the frozen product has on oil temperature.
Cook Time The cook time for the product is selected.
Shake Time/ Hold Time Shake Time and Hold Time are entered. Pressing the checkmark after entering the hold figure returns the computer to SELP.
Start Up The computer shows CYCL while in the melt cycle. Here it is calling for heat as it warms up. Light indicates unit is calling for heat.
Temperature display The unit will display Celsius or Fahrenheit. Entering code 1658 toggles between the modes.
Cruising to setpoint The display shows dashes when the fryer gets about 15 above or below setpoint.
Checking fryer’s health Press check button Enter 1652 Fryer’s recovery time is displayed
Failure indicators Ignition failures are noted by a HELP on the display. Prob indicates trouble in the probe circuit.
CMIII.5 Entering Code 165R will display the software version and part number. Adjustment to the melt cycle can also be made in the software.