We think you have liked this presentation. If you wish to download it, please recommend it to your friends in any social system. Share buttons are a little bit lower. Thank you!
Presentation is loading. Please wait.
Published byWilliam Chapman
Modified about 1 year ago
Microwave Devices E511 Lecture 13 Amr Al.Awamry
Agenda Filter Implementation
Richards’ Transformation @ resonance frequency
Kuroda’s Identities * Physically separate transmission line stubs * Transform series stubs into shunt stubs, or vice versa *Change impractical characteristic impedances into more realizable values
Kuroda identities, cont.
Example 8.5 Design a low-pass filter for fabrication using microstrip lines. The specifications include a cutoff frequency of 4 GHz, an impedance of 50 ohm, and a third-order 3 dB equal-ripple passband response
Example 8.5 cont.
Impedance and Admittance Inverters
Stepped impedance design
BandPass & BandStop filters BandStop BandPass
Bandpass Filters Using Capacitively Coupled Series Resonators
Bandpass Filters Using Capacitively Coupled Series Resonators II Stub length equal λ /2
Bandpass Filters Using Capacitively Coupled Shunt Resonators Stub length equal λ /4
Figure 8. 1 (p. 371) Examples of periodic structures
ELCT564 Spring /17/20151ELCT564 Chapter 8: Microwave Filters.
Design of planar filters
Hanyang University 1/24 Microwave Engineering Chapter 8.8 Wonhong Jeong
Design of RF and Microwave Filters 2009 학년도 여파기 설계.
Microwave Filter Design
ELEC Lecture 15 ELEC 412 RF & Microwave Engineering Lecture 15 Fall 2004.
1 EKT 441 MICROWAVE COMMUNICATIONS CHAPTER 5: MICROWAVE FILTERS PART II.
Lecture 8 Periodic Structures Image Parameter Method
& Microwave Engineering
Chapter 8. Microwave Filters
Microwave Devices E511 Lecture 12 Amr Al.Awamry. Agenda Filter design Filter Prototype Impedance and Frequency Scaling LP,HP,BP,SP transformations.
EEE 194RF_ L121 ELEC 412 RF & Microwave Engineering Fall 2004 Lecture 12.
ALL POLE FILTERS SYNTHESIS AND REALIZATION TECHNIQUES.
111/01/08 ENE 490 Applied Communication Systems Lecture 6 High-Pass, Bandpass, and Bandstop Filter Design.
Microwave Filters Filters allow some frequencies to go through while block the remaining In receivers, the system filters the incoming signal right after.
論文研討 : H.Issa #1,J.-M.Duchamp #2,S.Abou-Chahine *3,and Ph.Ferrari #4 H.Issa #1,J.-M.Duchamp #2,S.Abou-Chahine *3,and Ph.Ferrari #4 “Compact Semi-Lumped.
A Microstrip Half-Wave Filter
Basic Electronics Ninth Edition Basic Electronics Ninth Edition ©2002 The McGraw-Hill Companies Grob Schultz.
ENE 428 Microwave Engineering
Circuits II EE221 Unit 5 Instructor: Kevin D. Donohue Passive Filters, low-Pass and Band-Pass filters.
1 Series & Parallel Resonance Passive Filter. 2 Resonance Resonance is a condition in an RLC circuit in which the capacitive and inductive reactances.
EKT 441 MICROWAVE COMMUNICATIONS
Analog Lowpass Filter Prototype Design ELEC 423 Prof. Siripong Potisuk.
ELEC Lecture 141 ELEC 412 RF & Microwave Engineering Fall 2004 Lecture 14.
ECEN 301Discussion #16 – Frequency Response1 Easier to Maintain Than to Retake Alma 59:9 9 And now as Moroni had supposed that there should be men sent.
Design of Compact and Sharp-Rejection Ultra Wideband Bandpass Filters Using Interdigital Stepped-Impedance Resonators IEICE TRANS. ELECTRON., VOL.E90–C,
Microwave Devices E511 Lecture 10 Amr Al.Awamry. Agenda Lossless Divider Resistive Divider Waveguide Directional coupler Quadrature Hybrids.
Ideal Filter Magnitude Responses
IIR FILTERS DESIGN BY POLE-ZERO PLACEMENT
Impedance Transformation. Topics Quality Factor Series to parallel conversion Low-pass RC High-pass RL Bandpass Loaded Q Impedance Transformation Coupled.
Chapter 14 Filter Circuits
1 BIEN425 – Lecture 12 By the end of the lecture, you should be able to: –Design and implement IIR filters using zero-pole placement.
CHAPTER 6: INTRODUCTION TO PASSIVE FILTERS
RF Overview RF and microwave engineering has innumerable applications, from radar (e.g. for air traffic control and meteorology) through electro-heat.
STUT Adviser :Hon Kuan Reporter : Wen-Lang Chen Date : 12/01/2008 A UWB FILTER USING MIXED OPEN STUBS TO SUPPRESS HARMONIC RESPONSE.
LECTURE 2. IMPEDANCE MATCHING
ANALOG FILTERS ELEC 202 Circuit Analysis II. Definition A frequency-selective device or circuit designed to pass signals with desired frequencies and.
Control of Bandstop Response of Cascaded Microstrip Low-pass-Bandstop Filters Using Arrowhead Slots in Backside Metallic Ground Plane Dr. Galal Nadim.
ENE 490 Applied Communication Systems Lecture 3 Stub matching, single- and two-port networks DATE: 27/11/06.
Design of Combline Bandpass Filters
1 EKT 441 MICROWAVE COMMUNICATIONS. 2 What is expected? Initial knowledge of these topics are required: Maths, maths & more maths… Smith Chart operation.
Analytic Solution for Shunt Stub
Chapter 13 RLC CIRCUITS AND RESONANCE. IMPEDANCE AND PHASE ANGLE OF SERIES RLC CIRCUITS A series RLC circuit contains resistance, inductance, and capacitance.
Impedance Matching and Tuning
1/20 Antennas & RF Devices Lab. ANTENNA THEORY : Analysis and design Third edition Seongkyu LEE.
COPLANAR WAVEGUIDE TRANSMISSION LINES
Lecture 29 Review: Frequency response Frequency response examples Frequency response plots & signal spectra Filters Related educational materials: –Chapter.
Microwave Engineering Prof. Tapas Mondal Associate Professor Department Of Electronics and Communication Engineering West Bengal, India Dr B C Roy Engineering.
© 2017 SlidePlayer.com Inc. All rights reserved.