Presentation is loading. Please wait.

Presentation is loading. Please wait.

MENU SPWF01S Wi-Fi modules FW upgrading over UART Using STEVAL-IDW001V1 (Wi-Fi evaluation board)

Similar presentations


Presentation on theme: "MENU SPWF01S Wi-Fi modules FW upgrading over UART Using STEVAL-IDW001V1 (Wi-Fi evaluation board)"— Presentation transcript:

1 MENU SPWF01S Wi-Fi modules FW upgrading over UART Using STEVAL-IDW001V1 (Wi-Fi evaluation board)

2 MENU FW upgrading over UART STEVAL-PCC018V1 (UART to USB bridge) STEVAL-IDW001V1 (Wi-Fi eval board) JP3 RESET Flow description  Put jumper on JP3 as in the picture (pulling high (3.3V) BOOT0 pin signals “firmware download” mode)  Run the Flash Loader Demonstrator (UART Baud rate )  Specify the as starting address. ATTENTION! BE CAREFUL TO SPECIFY THE RIGHT ADDRESS  Specify the file to be downloaded (i.e SPWF01S f58d6b-RELEASE-main.bin)  Follow the steps (default) until the end of the process - see step by step guide on the next page  Remove jumper from JP3 (Pull low (GND) BOOT0 pin)  Reset the dongle  Open a terminal emulator (Baud rate: / Data: 8 bit / Parity: none / Stop: 1 bit / Flow control: none) and restore default settings typing AT command in brackets (AT&F) SPWF01SA.11 (Wi-Fi module) SW tools Flash Loader Demonstrator 47/CL1794/SC961/SS1743/PF /CL1794/SC961/SS1743/PF257525

3 MENU Flash Loader Demo Step by step guide Step 1 Step 2Step 3 Step 4 Step 5 Step 6


Download ppt "MENU SPWF01S Wi-Fi modules FW upgrading over UART Using STEVAL-IDW001V1 (Wi-Fi evaluation board)"

Similar presentations


Ads by Google