Presentation on theme: "CBC Machine Technology TOOLBIT BENCH BLOCK. CBC Machine Technology TOOLBIT TERMINOLOGY u F.I.M. - Full Indicator Movement u RPM - Revolutions Per Minute."— Presentation transcript:
CBC Machine Technology TOOLBIT TERMINOLOGY u F.I.M. - Full Indicator Movement u RPM - Revolutions Per Minute u A.I.S.I. - American Iron & Steel Institute u 4140 - Last two digits represent % of carbon
CBC Machine Technology TOOLBIT EQUIPMENT Building this bench block will give you experience using: u Lathe u Vertical Mill u Horizontal Mill u Bandsaw u Heat Treat Oven u Surface Grinder
CBC Machine Technology TOOLBIT DRAW THIS PART 1.000 +-.005 1/4”.500 1/4”
CBC Machine Technology TOOLBIT PROCEDURE - SAW u Cutoff 2-3/4” diameter x 1-1/4” long A.I.S.A. tool steel.
CBC Machine Technology TOOLBIT PROCEDURE - LATHE u Chuck in lathe, in four jaw chuck u Indicate to within.015 F.I.M. u Face to cleanup surface at 80 RPM. u Turn OD to 2.450+-.005”. u Turn OD to 2.450+-.005 x1/4” from face.
CBC Machine Technology TOOLBIT PROCEDURE - LATHE u Check if there is time to : u Center drill. u Drill 1/2” hole thru at 400 RPM. u Turn ID to 2.00+-.010” x3/8” deep at 100 RPM.
CBC Machine Technology TOOLBIT PROCEDURE - LATHE u Remove turn part around rechuck on 1/4” shoulder and indicate to.002” F.I.M. u Face to 1.020+-.005 at 80 RPM. u Turn OD to 2.400+-.005 x 1/4”from face.
CBC Machine Technology TOOLBIT HORIZONTAL MILL u Setup in vice on parallels, leave 3/8” minimum above vice. u Setup 90 cutter on arbor. u Position center of cutter in center of workpiece. u Touch rotating cutter to top of workpiece.
CBC Machine Technology TOOLBIT HORIZONTAL MILL u Take two cuts,.125 deep each at 80 RPM. u remove 90 cutter, replace with 1/8” cutter. u Center cutter in center of grove. u Make one cut 1/8” deep.
Your consent to our cookies if you continue to use this website.