1. IE 201 INTRODUCTION TO ENGINEERING DESIGN

2. L-3d Presentation Team 5 Abdullah AbuKhwejah Abdullah Siami Adam Jalal Rami Almatani Mohamed AlShayea

3. Agenda Context1 min The work1 min –KTSA 1 min –GANTT CHART1 min –ARTIFACT SKETCHES1 min –Discussion1 min

4. Introduction: This is the fourth installment of the IE 201 project which is L3-D (implementation). This step comes right after we have selected the artifact which is to obtain, dissect the artifact and prepare for the final step. In this assignment we will apply the KTSA on the artifact and develop a (Gantt chart) that shows when the tasks will be completed. Finally we will sketch our artifact parts after dissection and shall number the parts so that it will be easy for us to put back together.

5. We first apply the Kepner-Tregoe Situation Analysis KTSA on the artifact that we obtained from the previous assignment which is Bicycle to help us prioritize the tasks and activities that remain to be completed. The Work:

6. - The table below shows the KTDA for our implementation problems SITUATION ANALYSIS PROCESS (PA,DA, PPA) IMPACT (H,M,L) TREND (H,M,L) TIMING (H,M,L) PROBLEMS DA,PPAHHH1. DISSECT BICYCLE PPAMLM2. SKETCH PARTS DA,PPAMMH3. REASSEMBLE BICYCLE PAMLM4. TEST PARTS PPAHLM5. ADD DYNAMO PPAMMH6. ADD LAMP DA,PPAHMM7. TEST THE COMPONENTS

7. Now, after applying the KTDA we need to have a Gantt Chart to show when the tasks will be completed. It lets us know who is working on each task and how long it will take.

8. - The table below represents a Gantt Chart for our implementation procedure. SaturdaySunday problem6p.m.7p.m. 8p.m.9p.m. 10p.m.6p.m. 7p.m.8p.m. Memb. 1 and memb. 4 dissect bicycle 30 min Memb. 5 sketch bicycle's parts 2h 30 min Memb. 2 and memb. 4 reassembl e bicycle 30mi n

9. Memb. 2 and memb. 3 test the parts 1h30min Memb. 1 and memb. 2 add the dynamo 45mi n Memb. 3 and memb. 4 add the lamp 45m in Memb. 4 test all componen ts 1h30min SaturdaySunday 6p.m.7p.m.8p.m.9p.m.10p.m.6p.m.7p.m.8p.m.

10. Now, we go for the artifact parts' sketches. After we dissected the Bicycle we made sketches for each part followed by a number and its name to make it easy when we put back together.

12. Discussion: We have come to the end of the assignment L3-D (implementation) which was the fourth assignment for this project. It contained firstly, the KTSA table and results, secondly we used the results and added them to a Gantt chart which helped us figure out who was doing what and how long it would take to achieve. And last but not least we drew some sketches of the parts after dissection to artifact, and we numbered the parts so that it would be easier to put back together. We look forward to the final part of the project L3-E.

13. THANK YOU