2 RevisionItemExplanationPrepared by 0.1All1 st draft R. Nonaka May 30, All2 nd draft R. Nonaka August 26, All Official release Content does not change from revision 0.2. R. Nonaka September 8, ABC DEF Features based on market request are added. R. Nonaka November 6, IP-GW(H.323) + 32 SIP-GW for V3 Total 32 ch for V2 2 Feature Enhancement for SIP SLT step 2 TDE MPR V3 => V4 13TDE SMDR : 10,000 calls TDE600 SMDR : 20,000 callsRevision
3 RevisionItemExplanationPrepared by 1.2ACondition is added to conference improvement. R. Nonaka December 15, 2008 G CSTA “Button Press” works without “Enhanced Feature” activation key. HDefault data is revised. 1 More than 49ch talking is under study for V4. 13Condition is added to SMDR expansion. 1.3 ABCD 1 These were planned at version 4 for NCP. (Previous information was “V4 Study”) R. Nonaka July 9, SIP extension more enhancement and IP expansion card were dropped from version 4 for TDE and NCP. (Previous information was “V4 Study”) 6 ESVM hardware on TDE MPR is updated to new version. Mass production change is informed by PCR. HDefault of dial tone is revised from 10s to 250s.Revision
4 Feature Enhancement No.Feature ExplanationNCPTDE AConference feature improvement - Broadcast feature supports 2nd mode newly. 1) Broadcasting mode (Same as current spec) Max.32 parties / one way talk at first 2) Group call conference mode Max.8 parties / 2 way talk without operation by coordinator - Public CO call is supported for broadcast feature (both modes). - Remote users can join during broadcasting (both modes) through DISA using PIN, even if they could not answer call from coordinator. DISA is released automatically after join. - Broadcast member can be assigned by CSTA as well as PCMC. MPR V4 (Planned) MPR V3 TDA : N/A KX-TDE KX-TDE DISA Record conference to Softphone N/AForUSA
5 Feature Enhancement No.Feature ExplanationNCPTDE BCommon extension numbering for 2 or more PBXs - Only for H.323 supported by MPR card MPR V4 (Planned) MPR V3 TDA : N/A Tokyo Office Fukuoka Office 2nd Floor IP Network st Floor
6 Feature Enhancement No.Feature ExplanationNCPTDE C CLIP of extension which set Fwd can be informed to ISDN by option. MPR V4 (Planned) MPR V3 D ARS for dial 011 and 0 is supported. - Even if ARS for dial 011 (International call from North America) is assigned, dial 0 (call operator of telephone company) is available. MPR V4 (Planned) MPR V3 E DECT distinctive ringing for ICD group call is supported. - This feature can be enabled by PCMC sales company level. MPR V2 MPR V3 FSoftphone controlled by MPR also can be tried without activation key, when user can log in to CA Pro trial mode. - Software version up of XP/Vista/Mobile Softphone (in CA) is not required for this improvement. - XP/Vista Softphone controlled by IP extension card has trial mode since version 1. MPR V2 MPR V3 TDA : N/A
7 Feature Enhancement No.Feature ExplanationNCPTDE G CSTA “Button Press” works without “Enhanced Feature” activation key. - Communication Assistant version 2 supports transfer retrieve. “Button Press” is used for the feature. MPR V2 MPR V3 HDefault data is revised. - Built in Communication Assistant : “Disable” to “Enable” - Hold Tone to IP-PT : Change to same tone as TDA - Flash key mode : “Recall” to “EFA” (Only for USA and Canada) - Dial Tone Timer : 10s to 250s -10s was not enough for CA user and NT400 user to search contact for transfer. - Dial tone for TD1232 does not have timer limitation. - This default change helps the UCD agents with held call to make their status busy for more long time by keeping the phone off-hook. Even this timer expires a hold recall will take the place of it to keep their status busy. (Currently UCD agent may receive new other incoming call after hold + 10s dial tone and 10s reorder tone.) MPR V2 MPR V3 TDA : N/A
8 Feature Enhancement No.Feature ExplanationNCPTDE IP-PT by MPR card is supported. MPR V4 (Planned) MPR V3 2 Feature enhancement for SIP-SLT Step 2 - Unscreened Transfer for SIP-SLT except KX-HGT PBX feature support by dial “flexible numbering” step 2 MPR V4 Drop 2AFeature enhancement for SIP-SLT Step 1 - Unscreened Transfer for Panasonic KX-HGT PBX feature support by dial “flexible numbering” step 1 MPR V2 MPR V3 Virtual Card in MPRMPR V2 Limitation 32ch IP-PT Card (incl. Softphone) 2 cards (64ch) 4 cards (128ch) 32ch SIP Ext Card 4 cards (128ch) 16ch SIP CO Card 2 cards (32ch) 3 cards (32ch) 16ch IP-GW Card2 cards (32ch) TDA : N/A *1) 32(V2) -> 64(V3) is supported. *2) 49ch talking at the same time except IP extension P2P talk. More than 49ch talking is planned for V4. MPR V3 4 cards (128ch) 8 cards (192ch) *2) 2 cards (32ch) 4 cards (64 ch) *1) 2 cards (32ch)
9 No.Feature ExplanationNCPTDE 3 Built-in Communication Assistant and NT400 are supported. -Specification is basically same as CA for NCP Max. 128 users (NT400 : 64) - Log-in user number without activation key is as follows. Reference MPR V1 MPR V2 for NT400 MPR V3 4CTI for system wireless extension is supported. - Specification is basically same as NCP1000. MPR V2 MPR V3 Feature Enhancement PBX CA Pro Trial (60 days) CA Basic (No limit) NCP10002 users 5 users TDE users10 users TDE6008 users20 users PBX PA Pro Trial (60 days) PA Express (No limit) TDA30/502 users 5 users TDE users10 users TDE6008 users20 users TDA : N/A Actually 240 CA is supported by TDE (Not NCP) without PCMC sales company level programming. But official spec is 128. Actually 240 CA is supported by TDE (Not NCP) without PCMC sales company level programming. But official spec is 128.
10 Total 128 ch with IP Extension in MPR *) 49 ch talking at the same time Feature Enhancement No.Feature ExplanationNCPTDE 5IP-CS is supported. - Specification is basically same as NCP1000. MPR V2 MPR V3 PBX A. IP-CS 8 ch B. D-PT CS 8 ch C. Other CS 2ch / 4 ch MAX.CS B x 2 + C MAX.CS (A+B) x 2 + C NCP5008 units2 units4 units4--- NCP10008 units4 units8 units8--- TDE units 32 units---32 TDE60016 units64 units128 units TDA : N/A Virtual Card for 32 ch IP-PT Card or 32 ch SIP Ext Card Virtual Card for 4 IP-CSIP-CS 4 cards / 128 ch 0 card 0 unit / 0 ch 3 cards / 96 ch 1 card 4 units / 32 ch 2 cards / 64 ch 2 cards 8 units / 64 ch 1 card / 32 ch 3 cards 12 units / 96 ch 0 card / 0 ch 4 cards 16 units / 128 ch more 48 units with IP Expansion Card (MPR V4 : Study) = Total 64 units (Target) => IP Expansion Card was dropped from version 4.
11 Feature Enhancement No.Feature ExplanationNCP TDE TDE 600 6Music on Hold by ESVM card is supported. - One ch of ESVM card is occupied only for one MOH. - New hardware version (for high quality recording) is recommend for music on hold feature. *) ESVM hardware on TDE MPR is updated to new version. Mass production change is informed by PCR. MPR V3 software supports both ESVM old and new hardware version. MPR V2 MPR V3 SVM CardHardware VersionCH on NCP MPRNew2 on TDE MPROld to New *)2 on TDE600 MPRNew2 ESVM2 / ESVM4 for OPB3New2 / 4 TDA : N/A PBX ESVM Card Max. Installation Music on Hold Max. CH NCP cards1 ch by external + 6 ch by ESVM TDE cards2 ch by external + 6 ch by ESVM TDE60016 cards2 ch by external + 6 ch by ESVM
12 Feature Enhancement No.Feature ExplanationNCP TDE TDE Screened transfer from cellular phone is supported as well as unscreened transfer. - Screened transfer to extension (# + Ext No.) - Screened transfer using paging (# + *33 + Group No.) - Conference (# + Ext No. + # + 3) MPR V2 MPR V3 8 DDI number for cellular extension is informed as CLIP when call is made through DISA from cellular phone. - Currently caller ID of cellular phone or CLIP on CO line is informed. MPR V2 MPR V3 9Busy Display by DSS Key when cellular phone is busy. MPR V1 MPR V3 10 Intercept for call forwarded to CO (cellular phone, network extension and so on) is supported. MPR V1 MPR V3 MPR V2 11Transfer recall to Intercept destination is supported. Transfer recall to VM Group is supported. MPR V1 MPR V2.01 MPR V2 TDA : N/A TDA30/ : MPR V5 TDA600 : N/A TDA30/ : MPR V5 TDA600 : N/A
13 Feature Enhancement No.Feature ExplanationNCP TDE TDE Hotel “Cleaned Up” button is supported. - Operation using PT is basically same as [Check-in] button. - Control from CTI is also available. MPR V1 MPR V3 MPR V2 13SMDR Expansion by MEC card is supported. - KX-TDE0105 works for TDE as well as TDE600. *) SMDR 10,000 calls + Hotel 8,000 calls are available by PCMC sales company level with MEC. MPR V4 Study MPR V3 PBXSMDRHotel w/o MECwith MECw/o MECwith MEC TDA30/50200 callsN/A TDA calls 4,000 callsN/A4,000 calls TDA6001,000 calls 4,000 callsN/A8,000 calls NCP callsN/A1,000 callsN/A TDE V2200 callsN/A4,000 callsN/A TDE V3 200 calls10,000 calls4,000 calls TDE600 V21,000 calls 4,000 calls 8,000 calls TDE600 V3 *)1,000 calls20,000 calls4,000 calls TDA30/ : MPR V5 TDA600 : N/A
14 Feature Enhancement No.Feature ExplanationNCP TDE TDE CLIP for one extension is supported. - ARS itemized code can be 2 nd CLIP by option. MPR V2 MPR V3 MPR V2 15 Automatic recover from analog CO busy out is supported. MPR V2 MPR V3 MPR V2 16 One channel activation key is supported. - One channel activation key for TDE600 works for TDE also. MPR V1 MPR V2.01 MPR V2 17 Message waiting for Panasonic SIP-SLT KX-HGT100 is supported. MPR V1 MPR V2.01 MPR V2 18Public SIP CO compatibility is increased. *) Compatibility list is informed by different document. MPR V2 MPR V2.01 MPR V3 TDA : N/A TDA30/ : MPR V5 TDA600 : N/A TDA30/ : MPR V5 TDA600 : N/A
16 Main Office Main Office Remote Office Remote Office Roaming to Remote Office by IP CS - You can use your DECT handset in branch office or home, as well as in main office. CS KX-TDE / NCP KX-TDE / NCP IP-CS IP Network DECT D-PT IP-PT CS
17 Main Office Main Office Remote Office Remote Office CTI for PS CS - Wired telephone is removed from some advanced office. All of extension users have PS instead of D-PT. - When user is working with PC on desk, user wants to dial from Phone book in PC and sets Fwd using PC. (Same as D-PT user) => Target : Business application such as Communication Assistant IP-CS KX-TDE / NCP KX-TDE / NCP IP Network
18 Busy Display by DSS key when Cellular Phone as Extension is on the phone Busy Display by DSS key when Cellular Phone as Extension is on the phone Telephone Network (Fukuoka : 092) Telephone Network (Fukuoka : 092) KX-TDE / NCP KX-TDE / NCP Cellular Network (080) Cellular Network (080) Telephone Network (Yokohama : 045) Telephone Network (Yokohama : 045) Customer ( ) Main : DDI : xx DSS key for 102 becomes red, even when ICD group call is received by the paired cellular phone, or even when call is made by the paired cellular phone through PBX using DISA. Cellular Phone as Extension Extn103Extn102 Extn 202 Cell Phone ( ) Extn101 PT ( ) ICD Group Extn102 PT ( ) Extn 202 Virtual PS ( ) Screened Transfer can be informed to network as CLIP when call from cellular phone.