We think you have liked this presentation. If you wish to download it, please recommend it to your friends in any social system. Share buttons are a little bit lower. Thank you!
Presentation is loading. Please wait.
Published byAddison Brumage
Modified over 6 years ago
Mary Beth Lemoine Media 6467 – UWG Spring 2009
Have you read the instruction manual? Make sure that you have the correct bulb for your overhead projector.
Do you need a screwdriver? Are there any cautionary instructions on the machine?
Unplug the power cord from the wall unit.
Make sure that the power is in the “Off” position.
Where is the burnt-out bulb located inside the overhead projector?
With the screwdriver, remove the screws from the cover.
Locate the burnt-out bulb. Are there two bulbs? If so, you may just be able to slide the new bulb into position?
Find the metal bar on the right side of the bulb. Press down gently.
Remove the bulb noting the direction of the prongs in the back of the bulb.
While trying not to touch the new bulb as much as possible, gently slide it into position keeping in mind the direction of the prongs on the back of the bulb.
Is it directly behind the metal plate with the circular opening?
Is the metal bar back in its proper position?
Replace the cover.
Replace the screws verifying that they tighten correctly.
Plug the power cord back into the wall unit.
Turn the power switch back into the “On” position.
RP-500 ½- 1. Modification Overview Production of the RP500 began in 2007 and is current. Production of the RP500 began in 2007 and is current.
Controlling Devices Unit 5E Making an Advertising Board. Instructions for working away from the computer with Valiant Control Console and Cambridge Brainbox.
FRONIUS IG Display Simulation © Fronius 2006 The following slides introduce how to set up a Personal Display with a FRONIUS IG inverter. Please note that.
Build Your Own Future RC2 Serviceability. Build Your Own Future Safety and Ground Rules Before servicing, always remove A/C power from the unit and disconnect.
Zebra® 105SL™ * Removing and Installing Printhead
Equipment for Assembly Fluke Multimeter 115 True RMS Glue Ring Jig Flathead screwdriver 60 Watt desk lamp HIOS Cl 4000 Electric screw driver Anti-static.
1 Stripe 400/600 Removing and Installing Printhead Printhead Resistance Calibration Toggle Position Adjustment.
Presenting A Power Point Program. Computer Checklist Computer Checklist Power Cord Mouse Computer.
So you want to do a presentation in the Council Chamber?? No problem, here’s how… Note: If you are using the laptop to conduct your presentation, either.
Brio 2000 / Brio 2000-M E-Learning Service Manual Rev. 0.0.
Construction Safety Part 5: Hand and Power Tool Safety.
Changing the Oil in a 2006 Mitsubishi Eclipse. Introduction Changing the oil in your 2006 Mitsubishi Eclipse is easier than you may think. With a few.
Optical Manufacturing Solutions 1 Probe Assembly.
Installation Quick Guide AD400 Cylindrical 6/01/13 Doc #
Portable Power Tool Safety. Portable Electric and Cordless Drill Be sure the electric drill is disconnected from the power source before installing bits.
1 STEPMILL 7000 PT ASSEMBLY INSTRUCTIONS PART NUMBER
Affordable Ownership: Filter cleaning example EMINTS -- Professional Development for Educators By Educators
How to Clean the NEC VT676/67/575/470 Projector Filter
Digital StarLab Set-Up, Operation, Maintenance, and Teacher Manual for the Digital StarLab are in the links below or on the training tab in the BlackBoard.
How to Clean the NEC NP 600/500/400 NP300/500W/NP600S/NP500Ws Projector Filter By Deb Doebler 2/2011.
© 2020 SlidePlayer.com Inc. All rights reserved.